journal article·2022-02Open access

The effect of supplementary cementitious material systems on dynamic compressive properties of ultra-high performance concrete paste

Weitan Zhuang, Shaohua Li, Qingliang Yu

Abstract

Supplementary cementitious materials (SCMs) have been widely used to replace cement in UHPC, which benefits to reducing CO2 emissions and declining construction costs. However, the influence of SCMs on the dynamic compressive properties of Ultra-high performance concrete (UHPC) paste has not been well understood. Here, the workability, pore structure, quasi-static compressive strength and dynamic compressive properties of UHPC paste with different SCM systems are comprehensively studied. The results show that the substitution of cement by ground granulated blast furnace slag (GGBS) and limestone powder (LP) increases workability. With the substitution rate of 10% LP, the microstructure of M2 becomes denser. With the further increasing replacement of GGBS and LP, the porosity increases, while the quasi-static compressive strength and dynamic compressive properties trend to decrease, but the extent is limited. The compressive properties such as dynamic compressive strength, dynamic increase factor (DIF), peak strain and toughness are highly dependent on the strain rate. An applicable DIF model for UHPC is established at the strain rate of 53.9 - 170.7 s−1. The fractal dimension increases with the rising of GGBS and LP. Additionally, a positive linear relationship is observed between the fractal dimension and the denary logarithms of the strain rate.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Concrete and Cement Materials Research · Innovative concrete reinforcement materials · Concrete Properties and Behavior

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (77)

Show source-provided references
1. A review on ultra high performance concrete: Part I. Raw materials and mixture design10.1016/j.conbuildmat.2015.10.088 ↗
2. A review on ultra high performance concrete: Part II. Hydration, microstructure and properties10.1016/j.conbuildmat.2015.08.095 ↗
3. Influence of key design parameters of ultra-high performance fibre reinforced concrete on in-service bullet resistance10.1016/j.ijimpeng.2019.103434 ↗
4. Sustainability and performance assessment of binary blended low-carbon concrete using supplementary cementitious materials10.1016/j.jclepro.2020.124373 ↗
5. Development of waste-based concretes containing foundry sand, recycled fine aggregate, ground granulated blast furnace slag and fly ash10.1016/j.conbuildmat.2020.121004 ↗
6. Development and properties evaluation of sustainable ultra-high performance pastes with quaternary blends10.1016/j.jclepro.2019.118124 ↗
7. Reactivity of supplementary cementitious materials (SCMs) in cement blends10.1016/j.cemconres.2019.105799 ↗
8. Experimental investigation on optimum usage of Micro silica and GGBS for the strength characteristics of concrete10.1016/j.matpr.2019.12.354 ↗
9. A review on use of limestone powder in cement-based materials: Mechanism, hydration and microstructures10.1016/j.conbuildmat.2018.06.075 ↗
10. Towards ternary binders involving limestone additions — A review10.1016/j.cemconres.2021.106396 ↗
11. Rheological behaviour and mechanical properties of Moroccan ternary binder’s Portland clinker-fly ash-limestone10.1016/j.conbuildmat.2021.122513 ↗
12. Eco-friendly ultra-high performance cement pastes produced with quarry wastes as alternative fillers10.1016/j.jclepro.2020.122308 ↗
13. Potential of finely ground limestone powder to benefit ultra-high performance concrete mixtures10.1016/j.conbuildmat.2017.02.073 ↗
14. Impact characterization and modelling of basalt-polypropylene fibre-reinforced concrete containing mineral admixtures10.1016/j.cemconcomp.2018.07.019 ↗
15. Effect of mineral filler type on autogenous shrinkage of self-compacting concrete10.1016/j.cemconres.2010.01.014 ↗
16. The hydration and microstructure of ultra high-strength concrete with cement-silica fume-slag binder10.1016/j.cemconcomp.2015.04.013 ↗
17. Properties of self-compacting mortars using blends of limestone powder, fly ash, and zeolite powder10.1016/j.conbuildmat.2021.122788 ↗
18. Ternary blending of cement with fly ash microsphere and condensed silica fume to improve the performance of mortar10.1016/j.cemconcomp.2014.02.002 ↗
19. Hydration heat, strength and microstructure characteristics of UHPC containing blast furnace slag10.1016/j.jobe.2020.101915 ↗
20. A review on split Hopkinson bar experiments on the dynamic characterisation of concrete10.1016/j.conbuildmat.2018.09.187 ↗
21. Impact resistance of fiber-reinforced concrete – A review10.1016/j.cemconcomp.2019.103389 ↗
22. Mechanical and structural behaviors of ultra-high-performance fiber-reinforced concrete subjected to impact and blast10.1016/j.conbuildmat.2017.05.136 ↗
23. Review of strain rate effects for UHPC in tension10.1016/j.conbuildmat.2017.07.168 ↗
24. Flexural response of steel-fiber-reinforced concrete beams: Effects of strength, fiber content, and strain-rate10.1016/j.cemconcomp.2015.10.001 ↗
25. Effects of steel fiber and strain rate on the dynamic compressive stress-strain relationship in reactive powder concrete10.1016/j.conbuildmat.2018.03.101 ↗
26. Static, dynamic mechanical properties and microstructure characteristics of ultra-high performance cementitious composites10.1515/secm-2011-0136 ↗
27. Effects of steel fiber content and type on dynamic compressive mechanical properties of UHPCC10.1016/j.conbuildmat.2017.12.203 ↗
28. Contribution of fiber orientation to enhancing dynamic properties of UHPC under impact loading10.1016/j.cemconcomp.2021.104108 ↗
29. Static and dynamic compressive properties of ultra-high performance concrete (UHPC) with hybrid steel fiber reinforcements10.1016/j.cemconcomp.2017.02.010 ↗
30. Research progress on the dynamic compressive properties of ultra-high performance concrete under high strain rates10.1016/j.cemconcomp.2021.104258 ↗
31. G. 175-2007/XG2-2018, Common portland cement, (2018).
32. L. Wang, L. Yang, X. Dong, X. Jiang, Dynamic experimental study on the distortional law of materials, 2019.10.1016/B978-0-12-817321-3.00007-3 ↗
33. Rheology control of ultra-high-performance concrete made with different fiber contents10.1016/j.cemconres.2020.106222 ↗
34. GB/T 50081-2002., Standard test methods for mechanical properties of ordinary concrete[S], (2015).
35. Wang · Basic of Stress Wave · 1985
36. Experimental study on fractal characteristics of steam free reactive powder concrete under impact load
37. Fractal Characteristics of Concrete Fragmentation under Impact Loading10.1061/(ASCE)MT.1943-5533.0001764 ↗
38. The fractal geometry of nature
39. Effects of dynamic strain rate on the energy dissipation and fragment characteristics of cross-fissured rocks10.1016/j.ijrmms.2020.104600 ↗
40. Length scales and size distributions in dynamic fragmentation10.1007/s10704-009-9418-4 ↗
41. Experimental research on the dynamic mechanical properties and damage characteristics of lightweight foamed concrete under impact loading10.1016/j.ijimpeng.2020.103558 ↗
42. Effect of PCE-type superplasticizer on early-age behaviour of ultra-high performance concrete (UHPC)10.1016/j.conbuildmat.2017.07.145 ↗
43. Nanoscale analysis of the morphology and surface stability of calcium carbonate polymorphs10.1038/srep01587 ↗
44. Limestone and silica powder replacements for cement: Early-age performance10.1016/j.cemconcomp.2017.01.001 ↗
45. Interaction between polycarboxylate superplasticizers and amorphous ground granulated blast furnace slag10.1111/j.1551-2916.2010.03755.x ↗
46. Effectiveness of PCE superplasticizers in calcined clay blended cements10.1016/j.cemconres.2020.106334 ↗
47. Changes in rheology and mechanical properties of ultra-high performance concrete with silica fume content10.1016/j.cemconres.2019.105786 ↗
48. Uncovering the effect of fly ash cenospheres on the macroscopic properties and microstructure of ultra high-performance concrete (UHPC)10.1016/j.conbuildmat.2021.122977 ↗
49. Utilization of steel slag in ultra-high performance concrete with enhanced eco-friendliness10.1016/j.conbuildmat.2019.04.106 ↗
50. Effect of cement substitution by limestone on the hydration and microstructural development of ultra-high performance concrete (UHPC)10.1016/j.cemconcomp.2016.12.009 ↗
51. Environmental and economical friendly ultra-high performance-concrete incorporating appropriate quarry-stone powders10.1016/j.jclepro.2020.121112 ↗
52. Effects of densified silica fume on microstructure and compressive strength of blended cement pastes10.1016/S0008-8846(03)00100-5 ↗
53. Influence of pozzolans and slag on the microstructure of partially carbonated cement paste by means of water vapour and nitrogen sorption experiments and BET calculations10.1016/j.cemconres.2010.08.014 ↗
54. Evolution of porosity and calcium hydroxide in laboratory concretes containing silica fum10.1016/0008-8846(94)90027-2 ↗
55. A review on effects of limestone powder on the properties of concrete10.1016/j.conbuildmat.2018.10.119 ↗
56. Development of an eco-friendly Ultra-High Performance Concrete (UHPC) with efficient cement and mineral admixtures uses10.1016/j.cemconcomp.2014.09.024 ↗
57. About the dynamic strength enhancement of concrete-like materials in a split Hopkinson pressure bar test10.1016/S0020-7683(02)00526-7 ↗
58. An overview of the fatigue behaviour of plain and fibre reinforced concrete10.1016/S0958-9465(02)00139-7 ↗
59. Experimental and numerical studies on dynamic compressive behavior of reactive powder concretes10.1007/s10338-008-0851-0 ↗
60. Dynamic compressive behaviour of spiral steel fibre reinforced concrete in split Hopkinson pressure bar tests10.1016/j.conbuildmat.2013.07.022 ↗
61. A rate dependent stress-strain relationship model for normal, high and ultra-high strength concrete10.1260/2041-4196.4.3.451 ↗
62. Compressive behaviour of concrete at high strain rates10.1007/BF02472016 ↗
63. Mechanism of rate dependent behaviour of ultra-high performance fibre reinforced concrete containing coarse aggregates under flexural loading10.1016/j.conbuildmat.2021.124055 ↗
64. du Beton · 2013
65. Modelling of compressive behaviour of concrete-like materials at high strain rate10.1016/j.ijsolstr.2008.04.002 ↗
66. W.Y. Huang Z Xiao Y, Dynamic behavior of reactive powder concrete in split Hopkinson pressure bar testing, Nat. Sci. J. Xiangtan Univesity. 28(2) (2006) 113-117 (in Chinese).
67. Impact resistance of steel fiber-reinforced self-compacting concrete (SCC) at high strain rates
68. Strain-rate sensitive behavior of cement paste and mortar in compression
69. M.C.E. Harris DW Dolen TP, Dynamic properties of mass concrete obtained from dam cores, Aci Struct. J. 97 (3) (2000) 290–296.10.14359/4624 ↗
70. Dynamic behaviour and visco-elastic damage model of ultra-high performance cementitious composite10.1016/j.cemconres.2009.07.012 ↗
71. Dynamic mechanical characteristics of filling layer self-compacting concrete under impact loading10.1016/j.acme.2019.03.007 ↗
72. Mechanical properties of coral concrete subjected to uniaxial dynamic compression10.1016/j.conbuildmat.2018.12.032 ↗
73. Compressive impact tests of lightweight concrete with 155-mm-diameter spilt hopkinson pressure bar10.1016/j.cemconcomp.2020.103816 ↗
74. Enhancement of energy absorption in a closed-cell aluminum by the modification of cellular structures10.1016/S1359-6462(99)00255-9 ↗
75. Analysis of dynamic mechanical properties of sprayed fiber-reinforced concrete based on the energy conversion principle10.1016/j.conbuildmat.2020.119167 ↗
76. Evaluation of cracking patterns of cement paste containing polypropylene fibers10.1016/j.compstruct.2019.04.038 ↗
77. Experimental and modeling study of dynamic mechanical properties of cement paste, mortar and concrete10.1016/j.conbuildmat.2013.05.063 ↗