Ageing of clay and clay–tannin geomaterials for building
Source abstract
Abstract
Abstract Clay geomaterials for building are clay sand mixture with controlled microstructural characteristics. The macroscopic strength mostly results from the binding property of clays and can be increased with the addition of various additives as tannins from plants. Such an improvement is due to the formation of chemical complexes tannin–clay–iron hydroxides. In this study, controlled clay–sand mixtures were used to obtain compressed blocks with a composite microstructure. The used clay is mixed with tannin compound that is simply obtained from Parkia biglobosa trees of Burkina Faso. Creep curves during 21 days under a stress level commonly used in building (0.2 MPa) evidence a complex behavior with successive strain stages, depending on water and tannin contents. In general, creep is due to a slow and continuous volumetric deformation of the clay matrix and also to delayed micro-cracks propagation at sharp corners of sand grains. Ageing is evidenced by multi stage creep curves, resulting from local stress distribution within the matrix clay phase, which evolve with clay humidity and tannin content. Under a permanent stress, the microstructural internal bindings evolve with time leading to the weakening of the macroscopic material strength, which progressively tends to failure.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Geotechnical and construction materials studies · Hygrothermal properties of building materials · Geotechnical Engineering and Soil Stabilization
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (24)
Show source-provided references
1. Analysis of strength development in cement-stabilized silty clay from microstructural considerations10.1016/j.conbuildmat.2010.03.011 ↗
2. Development of low-cost functional geopolymeric materials10.1002/9780470930991.ch15 ↗
3. Use of ground clay brick as a pozzolanic material to reduce the alkali-silica reaction10.1016/S0008-8846(03)00101-7 ↗
4. Sina S, Traoré SA. Parkia biglobosa (Jacq.) R.Br. ex G.Don. Record from protabase. In: Oyen LPA, Lemmens RHMJ, editors. PROTA (Plant Resources of Tropical Africa/Ressources végétales de l’Afrique tropicale). Wageningen, The Netherlands; 2002.
5. Recent advances in the chemistry and chemical utilization of the natural condensed tannins10.1016/S0031-9422(00)90068-2 ↗
6. Retention of tannic acid and condensed tannin by Fe-oxide-coated quartz sand10.1016/j.jcis.2005.01.104 ↗
7. Permeability to water of sintered clay ceramics10.1016/j.clay.2009.09.005 ↗
8. Strength and creep behavior of geomaterials for building with tannin addition
9. Modelling of ageing effects on the elasto-viscoplastic behaviour of geomaterial10.3208/sandf.48.155 ↗
10. Discrete modelling of time-dependent rockfill behavior10.1002/nag.743 ↗
11. Analysis of total phenols and other oxidation substrates and antioxidants by means of Folin-Ciocalteu reagent10.1016/S0076-6879(99)99017-1 ↗
12. Do tannins in leaves of trees and shrubs from African and Himalayan regions differ in level and activity?10.1023/A:1006027231497 ↗
13. Polymerization of tannins combined with iron polymers from renewable resources: a challenge for the future of macromolecular materials10.1021/ma801735u ↗
14. Determining the cyclic strength of geomaterials under low frequency cyclic loading with acoustic emission10.51400/2709-6998.1942 ↗
15. Tatsuoka F, Lo Presti DCF, Kohata Y. Deformation characteristics of soils and soft rocks under monotonic and cyclic loads and their relationships. In: Prakash editor. SOA report, proc. of the third int. conf. on recent advances in geotechnical earthquake engineering and soil dynamics, vol. 2. St. Luois; 1995. p. 851–79.
16. Kongkitkul W, Tatsuoka F. Inelastic deformation of sand reinforced with different reinforcing materials; Soil Stress–Strain Behavior: Measurement, Modeling and Analysis. In: Ling et al. editor. Proc. of geotechnical symposium in Roma; 2007. p. 102–9.10.1007/978-1-4020-6146-2_64 ↗
17. Modelling and simulation of rate-dependent stress–strain behaviour of granular materials in shear10.3208/sandf.48.175 ↗
18. Formaldehyde-free tannin based foams and their use as lightweight panels10.15376/biores.6.4.4218-4228 ↗
19. Generalized creep and stress relaxation model for clays10.1061/(ASCE)0733-9410(1992)118:11(1765) ↗
20. Numerical separation of bi-modal strength distributions10.1016/S0955-2219(01)00383-1 ↗
21. Determining the cyclic strength of geomaterials under low frequency cyclic loading with acoustic emission10.51400/2709-6998.1942 ↗
22. A micromechanical model of elastoplastic and damage behavior of a cohesive geomaterial10.1016/j.ijsolstr.2007.09.025 ↗
23. Discrete numerical modelling of rockfill dams10.1002/nag.514 ↗
24. Discrete modelling of rock-ageing in rockfill dams10.1016/j.compgeo.2008.01.005 ↗