journal article·2011-02

Development of an automatic torque test to measure the shear bond strength between asphalt

A.C. Collop, M.H. Sutanto, G.D. Airey, Richard C. Elliott

Publisher page

Abstract

Abstract This paper describes the development of a laboratory-based automatic torque bond test that is capable of quasi-static and repeated load interface testing. Results from quasi-static testing undertaken using either a controlled torque rate or a controlled rotation rate showed that the shear strengths and shear reaction moduli increased as the temperature decreased. Samples with interfaces treated with the cationic emulsion were found to display the highest shear strengths and those treated with no emulsion were found to display the lowest shear strengths. A reasonably good correlation was found between results from testing performed at 600 N m/min and testing performed at 180°/min. The nominal shear strength measured from a test performed at 180°/min was found to be approximately 1.9 times higher than the nominal shear strength measured from a test performed at 600 N m/min. The nominal shear reaction modulus from a test performed at 180°/min was found to be approximately 1.6 times higher than the nominal shear reaction modulus from the test performed at 600 N m/min. The effect of material compliance above and below the interface on the rotation of the interface and shear reaction modulus of the interface is likely to be relatively small unless the shear stiffness of these materials is very low and/or the thickness is large. Results from repeated load (fatigue) testing showed a higher fatigue life and greater sensitivity to shear stress level at the lower temperature.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Asphalt Pavement Performance Evaluation · Infrastructure Maintenance and Monitoring · Transport Systems and Technology

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (29)

Show source-provided references
1. Anon. Interim report of the working party on the slippage of rolled asphalt wearing courses. TRRL report SR 213UC; 1976.
2. Kennedy CK. The development of slip-planes in rolled asphalt surfacings. TRRL report LR 813; 1978.
3. Anon. Final report of the working party on the slippage of rolled asphalt wearing courses. TRRL report SR 493; 1979.
4. Kennedy · 1980
5. Peattie · 1980
6. Anon. Le décollement des couches de revêtement de chaussées. Note d’information chaussées – terrassement n’ 25’, SETRA; 1986.
7. Shaat AA. Investigation of slippage of bituminous layer in overlaid pavement in Northern Ireland. Consultancy report submitted for the DOE in Northern Ireland; 1992.
8. Lepert P, Poilane JP, Villard-Bats M. Evaluation of various field measurement techniques for the assessment of pavement interface condition. In: 7th International conference on asphalt pavements, vol. 3; 1992. p. 224–237.
9. Hachiya T, Sato K. Effect of tack coat on bonding characteristics at interface between asphalt concrete layers. In: 8th International conference on asphalt pavements, Seattle; 1997.10.2208/jscej.1997.571_199 ↗
10. Charmot S, Romero P, Dunning M. Forensic analysis of slippage cracking. In: Proceeding of the 84th TRB annual meeting, Washington, DC; 2005.
11. Romain JE. Contraintes, déformations et déflexions dans les systémes quadricouches élastiques. Rapport de recherche No. 147/JER/1968, Centre de Recherches Routiéres, Bruxelles; 2005.
12. Investigation of adhesion properties between asphalt concrete layers
13. The influence of bonding between bituminous layers
14. Shahin M, Kirchner K, Blackmon EW. Analysis of asphalt concrete layers slippage and its effect on pavement performance and rehabilitation design. In: 6th International conference on the structural design of asphalt pavements. University of Michigan, Ann Arbor, Michigan; 1987.
15. Investigation of bonding between asphalt layers on road construction
16. Al Hakim B. An improved backcalculation method to predict flexible pavement layers moduli and bonding condition between wearing course and base course. PhD thesis, Liverpool John Moores University; 1997.
17. Kruntcheva MR, Collop AC, Thom NH. Theoretical and practical aspects of the importance of bonding in a pavement structure. Project report PGR 2000–08, The University of Nottingham; 2000.
18. Romanoschi SA, Metcalf JB. Characterization of asphalt concrete layer interface. Transportation Research Record: Journal of the Transportation Research Board, No. 1778, TRB, National Research Council, Washington DC; 2001, p. 132–139.10.3141/1778-16 ↗
19. Temperature effects on the shear behaviour of tack coat emulsions used in flexible pavements10.1080/10298430500068720 ↗
20. Assessment of bond condition using the Leutner shear test
21. Miró R, Martínez A, Pérez Jiménez F. Assessing heat-adhesive emulsions for tack coats. In: Proceedings of the institution of civil engineers. transport, 158, TR1; 2005. p. 45–51.10.1680/tran.2005.158.1.45 ↗
22. Preliminary investigation of a test method to evaluate bond strength of bituminous tack coats
23. Walsh ID, Williams JT. HAPAS certificates for procurement of thin surfacing’. Highways and transportation, July/August; 2001.
24. British Board of Agreement. Guidelines document for the assessment and certification of thin surfacing systems for highways. Working Draft SG3/98/173, British Board of Agreement, Watford, UK; 2000.
25. Choi · 2005
26. British Board of Agreement. Guidelines Document for the assessment and certification of thin surfacing systems for highways. SG3/05/234, British Board of Agreement, Watford, UK; 2004.
27. Shear fatigue behaviour of tack coats in pavements10.1080/14680629.2006.9690033 ↗
28. Diakhaté M, Petit C, Millien A, Phelipot-Mardelé A, Pouteau B, Goacolou H. Comparison of direct shear and torque tests for determining viscoelastic shear behavior of tack coats. In: Proceeding of the international conference on advanced characterization of pavement and soil engineering materials, Athens, Greece; 2007. p. 281–90.
29. Piber H, Canestrari F, Ferrotti G, Lu X, Millien A, Partl MN, Petit C, Phelipot-Mardelé A, Raab C. RILEM interlaboratory test on interlayer bonding of asphalt pavements. In: Proceeding of the 7th international RILEM symposium ATCBM09 on advanced testing and characterization of bituminous material, vol. 2, Rhodes, Greece, 27–29 May, 2009. p. 1181–9.10.1201/9780203092989.ch114 ↗