journal article·2021-11

Analytical model predicting the concrete tensile stress development in the restrained shrinkage ring test

Yingda Zhang, Sumaiya Afroz, Quang Dieu Nguyen, Taehwan Kim, Johanna Eisenträger, Arnaud Castel, Tengfei Xu

Publisher page

Abstract

Abstract Concrete structures may experience unexpected cracking at an early age. Early age cracking can be induced by restrained deformations where tensile stress generated in concrete exceeds its tensile strength. The restrained concrete ring test is often used to evaluate the ability of concrete to resist early age cracking induced by shrinkage. This paper proposed an analytical model of the restrained ring test by capturing the effect of both restrained shrinkage and tensile creep based on the age-adjusted effective modulus theory. The analytical model allows for accurately predicting the tensile stress of the restrained concrete ring based on the experimental measurements of the time-dependent development of elastic modulus, total free shrinkage, and tensile creep of concrete. A numerical finite element simulation was also successfully carried out to validate the new analytical model. Importantly, the model was validated considering a total of 21 concretes consisting of 6 strength grades ranging from 25 MPa to 100 MPa. For each grade, one fly ash blend (30%), two GGBFS blends (40% and 60%) and a reference mix without supplementary cementitious materials were tested.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Concrete Properties and Behavior · Concrete and Cement Materials Research · Innovative concrete reinforcement materials

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (64)

Show source-provided references
1. Effect of the water saturation of aggregates on the shrinkage induced cracking risk of concrete at early age10.1016/j.cemconcomp.2014.02.006 ↗
2. Analysis of cracking risk in early age mass concrete with different aggregate types10.1016/j.proeng.2017.06.209 ↗
3. A. Schindler, B. Byard and A. Tankasala, Mitigation of early-age cracking in concrete structures, in: MATEC Web of Conferences, 2019.10.1051/matecconf/201928407005 ↗
4. Insight into thermal stress distribution and required reinforcement reducing early-age cracking in mass foundation slabs10.3390/ma14030477 ↗
5. Early-age tensile creep and shrinkage-induced cracking in internally restrained concrete members10.1680/jmacr.18.00038 ↗
6. Cracking behaviour of reinforced concrete subjected to early-age shrinkage10.1007/BF02482208 ↗
7. Restrained cracking failure behavior of concrete due to temperature and shrinkage10.1016/j.conbuildmat.2020.118318 ↗
8. Assessing residual stress development and stress relaxation in restrained concrete ring specimens10.1016/S0958-9465(03)00069-6 ↗
9. Tensile creep and early-age concrete cracking due to restrained shrinkage10.1016/j.conbuildmat.2017.05.081 ↗
10. Ageing coefficient for early age tensile creep of blended slag and low calcium fly ash geopolymer concrete10.1016/j.conbuildmat.2020.119855 ↗
11. Effects of shrinkage reducing admixtures on restrained shrinkage cracking of concrete
12. Influence of specimen size/geometry on shrinkage cracking of rings
13. Free and restrained shrinkage of normal and high-strength concretes
14. A new look at tensile creep of fiber reinforced concrete
15. Restrained shrinkage cracking in fiber reinforced concrete — a novel test technique10.1016/0008-8846(95)00186-7 ↗
16. Shrinkage cracking of restrained concrete slabs
17. Model of studying shrinkage cracking in concrete building walls
18. Influence of fiber reinforcement on restraint shrinkage and cracking
19. Effect of internal curing with super absorbent polymers on residual stress development and stress relaxation in restrained concrete ring specimens10.1016/j.conbuildmat.2016.05.048 ↗
20. Shrinkage cracking characteristics of concrete using ring specimens
21. Enhancement of strength and durability of fly ash concrete in seawater environments: Synergistic effect of nanoparticles10.1016/j.conbuildmat.2018.07.214 ↗
22. Effect of GGBFS on compressive strength and durability of concrete10.4028/www.scientific.net/AMR.1145.22 ↗
23. The greening of the concrete industry10.1016/j.cemconcomp.2008.12.010 ↗
24. V. Malhotra, Role of supplementary cementing materials in reducing greenhouse gas emissions, in: Concrete technology for a Sustainable Development in the 21st Century, E&FN Spon, London, 2000.
25. Allen · 2019
26. Fracture properties evaluation of cellulose nanocrystals cement paste10.3390/ma13112507 ↗
27. Predicting the compressive strength of fly ash concrete with the Particle Model10.1016/j.cemconres.2020.106218 ↗
28. Using particle composition of fly ash to predict concrete strength and electrical resistivity10.1016/j.cemconcomp.2019.103493 ↗
29. Mechanical properties, long-term hydration heat, shinkage behavior and crack resistance of dam concrete designed with low heat Portland (LHP) cement and fly ash10.1016/j.conbuildmat.2018.08.056 ↗
30. Effect of various supplementary cementitious materials on early-age concrete cracking10.1061/(ASCE)MT.1943-5533.0003120 ↗
31. Effectiveness of fly ash on the restrained shrinkage cracking resistance of self-compacting concrete10.1016/j.cemconcomp.2017.01.010 ↗
32. Effects of fly ash on early-age properties and cracking of concrete
33. Mitigating the risk of early age cracking in fly ash blended cement-based concrete using ferronickel slag sand10.3151/jact.17.295 ↗
34. Tensile creep of concrete at early age
35. Early-age tensile creep and cracking potential of concrete internally cured with pre-wetted lightweight aggregate10.1016/j.conbuildmat.2016.12.187 ↗
36. Gilbert · 2011
37. Auswirkungen des Superpositionsprinzips auf Kriech- und Relaxations Probleme bei Beton und Spannbeton
38. Method of creep analysis of structural members
39. Prediction of concrete creep effects using age-adjusted effective method
40. A. 207.2R95, Effect of Restraint, Volume Change, and Reinforcement on Cracking of Mass Concrete, Farmington Hills, MI: American Concrete Institute, 1995.
41. AS3972-2010, General purpose and blended cements, Sydney: Standards Australia, 2010.
42. AS3582.1-2016, Supplementary cementitious materials - Fly ash, Sydney: Standards Australia, 2016.
43. AS3582.2-2016, Supplementary cementitious materials - Slag - Ground granulated blast-furance, Sydney: Standards Australia, 2016.
44. Superplasticizers: their effect on the strength properties of concrete
45. D. Sathyan, K.B. Anand, K.M. Mini, S. Aparna, Optimization of superplasticizer in portland pozzolana cement, in: International Conference on Advances in Materials and Manufacturing Application, Bengaluru, 2017.10.1088/1757-899X/310/1/012036 ↗
46. Compressive strength and hydration characteristics of high-volume fly ash concrete prepared from fly ash10.1007/s10973-018-7578-z ↗
47. Effect of GGBFS on time dependent compressive strength of concrete10.1016/j.conbuildmat.2010.01.007 ↗
48. AS1012.8.4-2015, Methods of testing concrete – Method for making and curing concrete – Drying shrinkage specimens prepared in the field or in the laboratory, Sydney: Standards Australia, 2015.
49. AS1012.9-2014, Methods of Testing Concrete Compressive Strength Tests – Concrete, Mortar and Grout Specimens, Sydney: Standard Australia, 2014.
50. AS1012.10-2000, Method of testing concrete – Determination of indirect tensile strength of concrete cylinders (Brasil or splitting test), Sydney: Standard Australia, 2000.
51. AS1012.17-1997, Method of testing concrete – Determination of the static chord modulus of elasticity and Poisson's ratio of concrete specimens, Sydney: Standard Australia, 1997.
52. ASTMC1581/C1581M, Standard Test Method for Determining Age at Cracking and Induced Tensile Stress Characteristics of Mortar and Concrete under Restrained Shrinkage, West Conshohocken, PA: ASTM International, 2018.
53. The ring method of measuring restrained shrinkage in mortar and concrete10.1520/CCA10168J ↗
54. Assessment of behaviour and cracking susceptibility of cementitious systems under restrained conditions through ring tests: a critical review10.1016/j.cemconcomp.2018.10.016 ↗
55. Free, restrained and drying shrinkage of cement mortar composites reinforced with vegetable fibres10.1016/j.cemconcomp.2004.09.005 ↗
56. AS1012.13-2015, Methods of testing concrete – Determination of the drying shrinkage of concrete for samples prepared in the field or in the laboratory, Sydney: Standards Australia, 2015.
57. Investigation on multi-cracks initiation and propagation of fiber reinforced concrete in restrained shrinkage ring tests10.1016/j.tafmec.2020.102856 ↗
58. Influence of specimen thicknesson cracking behavior in restrained shrinkage ring test10.7763/IJET.2013.V5.645 ↗
59. AS3600-2018, Australian standard for concrete structures, Sydney: Standards Australia, 2018.
60. Creep of FRP-wrapped concrete columns with or without fly ash under axial load10.1016/j.conbuildmat.2010.07.019 ↗
61. Effect of different supplementary cementitious materials on mechanical properties of high performance concrete10.1016/0008-8846(94)00128-L ↗
62. Quantifying the influence of elliptical ring geometry on the degree of restraint in a ring test10.1016/j.compstruc.2017.08.002 ↗
63. Degree of restraint concept in analysis of early-age stresses in concrete walls10.1016/j.engstruct.2015.08.025 ↗
64. Effect of temperature history and restraint degree on cracking behavior of early-age concrete10.1016/j.conbuildmat.2018.10.066 ↗