Modelling and optimization of the mechanical properties of engineered cementitious composite containing crumb rubber pretreated with graphene oxide using response surface methodology
Source abstract
Abstract
Abstract One of the biggest obstacles to using crumb rubber (CR) in cementitious composites for structural applications is its adverse effects on mechanical strength. This is caused by the poor bonding between the CR and the hardened cement paste. The problem persists despite several CR pretreatment methods proposed in different studies. This research aims to investigate a novel approach to CR pretreatment using graphene oxide (GO). The effect of GO concentration (GOC) and pretreated CR as a partial substitute to fine aggregate on the mechanical properties of ECC has been investigated. Using response surface methodology (RSM), 16 experimental runs having varying combinations and levels of GOC (0, 0.25, 0.5, 0.75, and 1.0 mg/ml) and CR replacement (1, 3, and 5% by volume) of fine aggregate as the independent variables have been tested for compressive, flexural, tensile strengths and strain capacity (CS, FS, TS, and TC) as the responses. Results show an increase in the mechanical strengths with higher GOC attributed to higher reactivity and better bonding at the CR and hardened cement matrix interface. At a 5% GO-CR replacement, there is a 50.3, 70.4, and 68.3% improvement in CS, FS, and TS between the control mix with 0 mg/ml GOC and the mix with 1.0 mg/ml GOC. Response surface models to predict the mechanical strengths have been developed and validated using ANOVA with R2 values ranging from 94.13 to 99.07% for all the models. Multi-objective optimization has been performed and experimentally validated, with the predicted and experimental results having
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Innovative concrete reinforcement materials · Structural Behavior of Reinforced Concrete · Innovations in Concrete and Construction Materials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (66)
Show source-provided references
1. Oikonomou · 2009 · 213
2. Research on crumb rubber concrete: From a multi-scale review10.1016/j.conbuildmat.2019.117282 ↗
3. Properties of cement mortar containing NaOH-treated Crumb rubber as fine aggregate replacement
4. A review of the effect of waste tire rubber on the properties of ECC
5. Properties of concrete with untreated and treated crumb rubber – A review10.1016/j.jmrt.2021.02.019 ↗
6. Effect of crumb rubber aggregate on the performance of cementitious composites: A review
7. Effects of different crumb rubber sizes on the flowability and compressive strength of hybrid fibre reinforced ECC
8. S. M. Razavi, H. Nazarpour, and M. Hosseinali Beygi, “Investigation of the efficacy of nano-silica on mechanical properties of Green-Engineered Cementitious Composite (GECC) containing high volume natural zeolite,” Construction and Building Materials, vol. 291, 2021.10.1016/j.conbuildmat.2021.123246 ↗
9. “Static and dynamic mechanical behavior of engineered cementitious composites with PP and PVA fibers,” Journal of Building
10. Matrix design of light weight, high strength, high ductility ECC10.1016/j.conbuildmat.2019.03.159 ↗
11. Compressive performance of all-grade engineered cementitious composites: Experiment and theoretical model10.1016/j.conbuildmat.2020.118357 ↗
12. Self-sensing capability of Engineered Cementitious Composites: Effects of aging and loading conditions10.1016/j.conbuildmat.2019.117132 ↗
13. Effect of sub-elevated temperature on mechanical properties of ECC with different fly ash contents
14. Effect of curing relative humidity on mechanical properties of engineered cementitious composites at multiple scales10.1016/j.conbuildmat.2021.122834 ↗
15. Development of engineered cementitious composites (ECC) using artificial fine aggregates10.1016/j.conbuildmat.2021.124742 ↗
16. Mechanical and self-healing behavior of low carbon engineered cementitious composites reinforced with PP-fibers10.1016/j.conbuildmat.2020.119805 ↗
17. Applications and recommendations of high performance fiber reinforced cement composites with multiple fine cracking (HPFRCC) in Japan10.1617/s11527-009-9541-8 ↗
18. Micromechanical modeling of crack-bridging relations of hybrid-fiber Strain-Hardening Cementitious Composites considering interaction between different fibers10.1016/j.conbuildmat.2018.06.115 ↗
19. A. Dhawale, V. J. I. j. o. a. o. I. i. E. Joshi, and Management, “Engineered cementitious composites for structural applications,” vol. 2, pp. 198-205, 2013.
20. Engineered Cementitious Composites (ECC) – Material, Structural, and Durability Performance
21. Tailoring an impact resistant engineered cementitious composite (ECC) by incorporation of crumb rubber10.1016/j.conbuildmat.2020.120116 ↗
22. “Mechanical and deformation properties of rubberized engineered cementitious composite (ECC),” Case Studies
23. “Properties of Self-Consolidating Engineered Cementitious Composite Modified with Rubber,” (in English)10.1061/(ASCE)MT.1943-5533.0002219 ↗
24. Tailoring Engineered Cementitious Composites with local ingredients10.1016/j.conbuildmat.2015.10.146 ↗
25. Influence of Crumb Rubber on the Mechanical Behavior of Engineered Cementitious Composites
26. “Effect of elevated temperatures on physical and mechanical properties of recycled rubber mortar,” (in English)10.1016/j.conbuildmat.2016.09.018 ↗
27. M. S. N. a. H. J. S. Tholfekar H. Hussain, “Effect of elevated temperature on degradation behaviour of reactive powder concrete made with rubber tire wastes as an aggregate replacement,” ARPN Journal of Engineering and Applied Sciences, vol. 14, no. 3, 2019.
28. L. Sabapathy, B. S. Mohammed, A. Al-Fakih, M. M. A. Wahab, M. S. Liew, and Y. H. M. Amran, “Acid and Sulphate Attacks on a Rubberized Engineered Cementitious Composite Containing Graphene Oxide,” Materials (Basel), vol. 13, no. 14, Jul 13 2020.10.3390/ma13143125 ↗
29. Y. Wang, Z. Zhang, J. Yu, J. Xiao, and Q. Xu, “Using Green Supplementary Materials to Achieve More Ductile ECC,” Materials (Basel), vol. 12, no. 6, Mar 14 2019.10.3390/ma12060858 ↗
30. B. S. Mohammed, L. W. Xian, S. Haruna, M. S. Liew, I. Abdulkadir, and N. A. W. A. Zawawi, “Deformation Properties of Rubberized Engineered Cementitious Composites Using Response Surface Methodology,” Iranian Journal of Science and Technology, Transactions of Civil Engineering, 2020.10.1007/s40996-020-00444-3 ↗
31. Investigation of the Mechanical Properties of Engineered Cementitious Composites with Low Fiber Content and with Crumb Rubber and High Fly Ash Content10.1177/0361198119837510 ↗
32. G. A. Andres, Arce; Rupnow, Tyson; Hassan, Marwa, “Evaluation of the Performance and Cost-Effectiveness of Engineered Cementitious Composites (ECC) Produced from Region 6 Local Materials,” in “Publications,” Louisiana State University2018, vol. 7.
33. Investigation on Properties of ECC Incorporating Crumb Rubber of Different Sizes10.3151/jact.13.241 ↗
34. V. C. M. Khed, Bashar S ; Liew, Mohd Shahir; Alaloul, Wesam S.; Adamu, Musa “Hybrid Fiber Rubberized ECC Optimization for Modulus of Elasticity,” International Journal of Civil Engineering and Technology (IJCIET), vol. 9, no. 7, pp. 918-928, 2018.
35. Partial replacement of copper slag with treated crumb rubber aggregates in alkali-activated slag mortar10.1016/j.conbuildmat.2020.119468 ↗
36. Durability performance of rubberized mortar and concrete with NaOH-Solution treated rubber particles10.1016/j.conbuildmat.2017.07.085 ↗
37. F. M. E. a. M. A. Mohammed Safan, “Enhanced Properties of Crumb Rubber and Its Application in Rubberized Concrete,” International Journal of Current Engineering and Technology, vol. 7, no. 2, pp. 1784-1790, 2017.
38. Properties of rubberized concrete modified by using silane coupling agent and carboxylated SBR10.1016/j.jclepro.2015.06.099 ↗
39. Surface modification of crumb rubber and its influence on the mechanical properties of rubber-cement concrete10.1016/j.conbuildmat.2016.05.025 ↗
40. O. Youssf et al., “Influence of Mixing Procedures, Rubber Treatment, and Fibre Additives on Rubcrete Performance,” Journal of Composites Science, vol. 3, no. 2, 2019.10.3390/jcs3020041 ↗
41. Novel approach to improve crumb rubber concrete strength using thermal treatment10.1016/j.conbuildmat.2019.116901 ↗
42. UV modification of tire rubber for use in cementitious composites10.1016/j.cemconcomp.2014.04.004 ↗
43. Crumb rubber aggregate coatings/pre-treatments and their effects on interfacial bonding, air entrapment and fracture toughness in self-compacting rubberised concrete (SCRC)10.1617/s11527-013-0034-4 ↗
44. Hardened properties of concrete mixtures containing pre-coated crumb rubber and silica fume10.1016/j.jclepro.2014.06.068 ↗
45. Rubber modified concrete improved by chemically active coating and silane coupling agent10.1016/j.conbuildmat.2013.06.072 ↗
46. Graphene-based polymer nanocomposites10.1016/j.polymer.2010.11.042 ↗
47. Investigation of dispersion behavior of GO modified by different water reducing agents in cement pore solution10.1016/j.carbon.2017.11.016 ↗
48. A short discussion on how to effectively use graphene oxide to reinforce cementitious composites10.1016/j.conbuildmat.2018.08.170 ↗
49. Strong Adhesion of Graphene Oxide Coating on Polymer Separation Membranes10.1021/acs.langmuir.8b02342 ↗
50. B. Mensah, S. I. Kang, W. Wang, and C. Nah, “Effect of graphene on polar and nonpolar rubber matrices,” Mechanics of Advanced Materials and Modern Processes, vol. 4, no. 1, 2018.10.1186/s40759-017-0034-0 ↗
51. H. L. Lye, B. S. Mohammed, M. S. Liew, M. M. A. Wahab, and A. Al-Fakih, “Bond behaviour of CFRP-strengthened ECC using Response Surface Methodology (RSM),” Case Studies in Construction Materials, vol. 12, 2020.10.1016/j.cscm.2019.e00327 ↗
52. “Modelling and multi-objective optimization of the fresh and mechanical properties of self-compacting high volume fly ash ECC (HVFA-ECC) using response surface methodology (RSM),” Case Studies
53. Mechanical and microstructural properties of high calcium fly ash one-part geopolymer cement made with granular activator10.1016/j.heliyon.2019.e02255 ↗
54. Graphene-oxide coating for corrosion protection of iron particles in saline water10.1016/j.carbon.2018.08.062 ↗
55. Graphene Oxide Coatings Deposited on Steel Substrate Using Electrophoretic Deposition and Electrochemical Evaluation of Coatings in Saline Media10.4028/www.scientific.net/KEM.778.111 ↗
56. Experimental study of the effects of graphene oxide on microstructure and properties of cement paste composite10.1016/j.compositesa.2017.07.022 ↗
57. Z. Lu, D. Hou, L. Meng, G. Sun, C. Lu, and Z. Li, “Mechanism of cement paste reinforced by graphene oxide/carbon nanotubes composites with enhanced mechanical properties,” RSC Advances, 10.1039/C5RA18602A vol. 5, no. 122, pp. 100598-100605, 2015.10.1039/C5RA18602A ↗
58. Effect of graphene oxide nanosheets of microstructure and mechanical properties of cement composites10.1016/j.conbuildmat.2013.08.022 ↗
59. Graphene-based nanosheets for stronger and more durable concrete: A review10.1016/j.conbuildmat.2018.06.201 ↗
60. Strain hardening behaviour of PE fibre reinforced calcium aluminate cement (CAC) – Ground granulated blast furnace (GGBFS) blended mortar10.1016/j.conbuildmat.2020.118100 ↗
61. Tensile strain capacity of concrete under various states of stress10.1680/macr.2000.52.3.185 ↗
62. Effects of crumb rubber particles on mechanical properties and sustainability of ultra-high-ductile slag-based composites10.1016/j.conbuildmat.2020.121959 ↗
63. Performance of engineered cementitious composites incorporating crumb rubber as aggregate10.1016/j.conbuildmat.2020.122033 ↗
64. RSM-based model to predict the performance of self-compacting UHPC reinforced with hybrid steel micro-fibers10.1016/j.conbuildmat.2014.05.064 ↗
65. The influence of high temperature on microstructural damage and residual properties of nano-silica-modified (NS-modified) self-consolidating engineering cementitious composites (SC-ECC) using response surface methodology (RSM)10.1016/j.conbuildmat.2018.10.114 ↗
66. Bond behaviour of nano-silica-modified self-compacting engineered cementitious composite using response surface methodology10.1016/j.conbuildmat.2019.07.115 ↗