Experimental and modeling investigation on the dynamic response of granite after high-temperature treatment under different pressures
Source abstract
Abstract
Abstract In this work, the dynamic compressive mechanical properties of Beishan granite are investigated under the condition of uniaxial load and confined pressure, respectively. The purpose of this investigation is to study the effect of hydrostatic pressure and pre-heating temperature on the strength property and failure of such material. The investigation is carried out with the use of a large-diameter split-Hopkinson pressure bar (SHPB), which is equipped with an active confining device. The dynamic stress–strain behaviors of the granite samples under different confined conditions are obtained with a pre-heating temperature ranging from 25 to 800 °C. We analyzed the temperature-dependent variation of the peak stress, peak strain and elastic modulus of the material under selected values of confined pressure. It is observed that the uniaxial compressive behavior of Beishan granite under unconfined pressure is strongly dependent on the pre-heating temperature. The values of the peak stress and the elastic modulus both decrease as the pre-heating temperature increases, while the value of the peak strain increases with the rise of pre-heating temperature, indicating a characteristic change from elastic-brittle to elastic–plastic. Under confined pressure, the strength of the material can be greatly improved, and higher pre-heating temperature tends to bring down the value of the strength. With the confined configuration, the strengthening of the peak stress is not significantly associated with the value of the confined pressure; instead the dependence on the strain rate becomes more remarkable. For the temperature effect, the value of the peak stress can be linearly correlated with the temperature level through comparative analysis. Moreover, the elastic modulus of the material can be associated with the temperature by a functional form, known as the temperature shift factor. Finally, an elastoplastic-damage constitutive model is established to predict the dynamic mechanical behavior of the material after high-temperature treatment under different confined pressures.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: High-Velocity Impact and Material Behavior · Rock Mechanics and Modeling · Structural Response to Dynamic Loads
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (40)
Show source-provided references
1. Influence of thermal damage on physical properties of a granite rock: porosity, permeability and ultrasonic wave evolutions10.1016/j.conbuildmat.2007.04.002 ↗
2. Implications of exposure to high temperatures for stone cladding requirements of three Portuguese granites regarding the use of dowel–hole anchoring systems10.1016/j.conbuildmat.2014.03.035 ↗
3. An experimental investigation on thermal damage and failure mechanical behavior of granite after exposure to different high temperature treatments10.1016/j.geothermics.2016.09.008 ↗
4. Observation of brittle-deformation features at the maximum stress of westerly granite and solenhofen limestone10.1016/0148-9062(70)90043-4 ↗
5. The role of bulking in brittle failure of rocks under rapid compression10.1016/0148-9062(76)91284-5 ↗
6. Dynamic characteristics of granite subjected to intermediate loading rate10.1007/s00603-004-0030-7 ↗
7. Static and dynamic flexural strength anisotropy of barre granite10.1007/s00603-013-0390-y ↗
8. B.K. Atkinson, Microseismic activity in geologic structures and materials, in: Proc. 3rd Int: Conf. On AE Leighton, 1984.
9. The influence of microcrack density on the elastic and fracture mechanical properties of stripa granite10.1016/0031-9201(85)90127-X ↗
10. Effects of temperature and stress on the time-dependent behavior of Beishan granite10.1016/j.ijrmms.2016.11.007 ↗
11. A test of the law of effective stress for crystalline rocks of low porosity10.1016/0148-9062(70)90030-6 ↗
12. Triaxial compression tests on a granite at different strain rates and confining pressures10.1016/S1365-1609(99)00120-3 ↗
13. Effect of strain rate on compressive strength and deformability of granite10.2473/shigentosozai.118.377 ↗
14. Effects of strain rate and confining pressure on the compressive behavior of kuru granite10.1016/j.ijimpeng.2016.01.010 ↗
15. A non-associated viscoplastic model for the behaviour of granite in triaxial compression10.1016/S0167-6636(01)00052-7 ↗
16. Numerical 3D modeling of the effects of strain rate and confining pressure on the compressive behavior of Kuru granite10.1016/j.compgeo.2017.03.004 ↗
17. A damage-mechanism-based creep model considering temperature effect in granite10.1016/j.mechrescom.2013.11.009 ↗
18. Damage stress and acoustic emission characteristics of the Beishan granite10.1016/j.ijrmms.2013.09.003 ↗
19. Experimental characterization and micromechanical modeling of damage-induced permeability variation in Beishan granite10.1016/j.ijrmms.2014.07.002 ↗
20. Mechanical testing and evaluation
21. Experimental and modeling study of dynamic mechanical properties of cement paste, mortar and concrete10.1016/j.conbuildmat.2013.05.063 ↗
22. Rate dependent behavior and modeling of concrete based on SHPB experiments10.1016/j.cemconcomp.2014.07.011 ↗
23. Static and dynamic properties of concrete with different types and shapes of fibrous reinforcement10.1016/j.conbuildmat.2015.12.037 ↗
24. H. Kolsky, Stress Waves in Solids, Oxford Univ. Press, London, vol. 3, 1953, pp. 58–62.
25. Experimental investigation and modeling of mechanical behaviors of polyurea over wide ranges of strain rates and temperatures10.1016/j.polymertesting.2016.06.004 ↗
26. Experimental investigation and modeling of the rate-dependent deformation behavior of PMMA at different temperatures10.1016/j.eurpolymj.2016.10.036 ↗
27. L.J. Gibson, M.F. Ashby, Cellular Solids Structure and Properties, Cambridge University Press, vol. 3, 1997, pp. 79–80.10.1017/CBO9781139878326 ↗
28. Computational modeling of the mechanical response of lightweight foamed concrete over a wide range of temperatures and strain rates10.1016/j.conbuildmat.2015.08.064 ↗
29. Constitutive modeling of the viscoelastic mechanical response of foam rubber-like materials10.1039/C5RA03116H ↗
30. Computational modeling of the response and damage behavior of fiber reinforced cellular concrete10.1016/j.compstruc.2004.01.001 ↗
31. A continuous damage mechanics model for ductile materials10.1115/1.3225775 ↗
32. Anisotropic damage law of evolution10.1016/S0997-7538(00)00161-3 ↗
33. Statistical aspects of the continuous damage theory10.1016/0020-7683(82)90039-7 ↗
34. Plasticity of a two-phase composite with partially debonded inclusion10.1016/S0749-6419(96)00029-0 ↗
35. A micromechanical damage model for effective elastoplastic behavior of ductile matrix composites considering evolutionary complete particle debonding10.1016/S0045-7825(99)00219-4 ↗
36. Models for the strain-rate-dependent behavior of polymer composites10.1016/S0266-3538(00)00133-0 ↗
37. Dynamic compressive strengths of polymeric composites10.1016/j.ijsolstr.2003.12.010 ↗
38. Modeling and testing strain rate-dependent compressive strength of carbon/epoxy composites10.1016/j.compscitech.2005.06.012 ↗
39. Soil mechanics and plastic analysis or limit design10.1090/qam/48291 ↗
40. Strain-rate effect on brittle failure in compression10.1016/0956-7151(94)90295-X ↗