journal article·2018-11

Experimental and numerical study into the punching shear strengthening of RC flat slabs using post-installed steel bolts

Haifa Saleh, Robin Kalfat, Kamiran Abdouka, Riadh Al-Mahaidi

Publisher page

Abstract

Abstract This paper presents a strengthening technique of reinforced concrete (RC) flat slabs using post-installed steel bolts. Two large-scale RC slabs representing an interior slab-column connection were tested. One slab was without shear reinforcement and was used as a control slab and the second slab was strengthened against punching shear using steel bolts with end anchorage steel plates. The punching tests were compared with the numerical results using finite element method (FEM). Numerical results showed good correlations with the experimental results in terms of the load-displacement response, concrete strain and failure mode. The results showed that the strengthening technique increased the load up to flexural failure of the slabs and improved ductility of slab relative to the control. The strengthening technique was also successful and contributed to changing the failure mode from brittle punching shear mode to ductile flexural failure mode. Photogrammetry was used in this research. Photogrammetry technique holds several advantages over traditional contact instrumentations including that it is inexpensive, simple for analyzing the results and a remote visualization technique. The displacement profile along the span of the slab and rotation has been compared with the results obtained from the traditional sensors.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Structural Behavior of Reinforced Concrete · Structural Response to Dynamic Loads · Structural Load-Bearing Analysis

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (39)

Show source-provided references
1. Punching tests of slabs with low reinforcement ratios
2. Influence of slab thickness on punching shear strength
3. Experimental investigation on punching strength and deformation capacity of shear-reinforced slabs
4. Effect of shear reinforcement on punching shear strength of reinforced concrete slabs
5. Effect of flexural and shear reinforcement on the punching behavior of reinforced concrete flat slabs10.1016/j.aej.2017.05.019 ↗
6. Behavior of two-way RC slabs externally bonded with steel plate10.1061/(ASCE)0733-9445(2001)127:4(390) ↗
7. Punching shear reinforcing using studs with steel plates in reinforced concrete flat plates10.1680/macr.2008.61.9.721 ↗
8. Punching strengthen ing of two-way slabs using external steel plates10.1016/j.aej.2015.09.005 ↗
9. Strengthening of two-way slabs using steel plates
10. Behavior of RC slab-column connections strengthened with external CFRP sheets and subjected to eccentric loading10.1061/(ASCE)CC.1943-5614.0000343 ↗
11. CFRP strengthening for punching shear of interior slab-column connections10.1061/(ASCE)1090-0268(2006)10:5(410) ↗
12. Criteria for punching failure mode in RC slabs reinforced by externally bonded CFRP10.1016/j.compstruct.2006.09.008 ↗
13. Experimental and numerical investigation into strengthening flat slabs at corner columns with externally bonded CFRP10.1016/j.conbuildmat.2017.02.056 ↗
14. Punching of slab-column connections strengthened using external steel shear bolts10.1680/macr.14.00434 ↗
15. Retrofit of slab column interior connections using shear bolts
16. Strengthening of flat slabs with transverse reinforcement by introduction of steel bolts using different anchorage approaches10.1016/j.engstruct.2012.05.043 ↗
17. Punching shear behavior of two-way slabs reinforced with FRP shear reinforcement10.1061/(ASCE)CC.1943-5614.0000493 ↗
18. Punching shear strengthening of flat-slabs with CFRP dowels10.1680/macr.2010.62.7.465 ↗
19. Punching shear strengthening of two-way flat slabs using CFRP rods10.1016/j.compstruct.2012.11.028 ↗
20. Structural improvement of strengthened deck panels with externally bonded plates10.1016/j.cemconres.2004.08.006 ↗
21. Punching shear strength of reinforced concrete slabs strengthened with glass fiber-reinforced polymer laminates
22. Strengthening concrete slabs for punching shear with carbon fiber-reinforced polymer laminates
23. Punching shear strengthening of reinforced concrete flat plates using carbon fiber reinforced polymers10.1061/(ASCE)0733-9445(2003)129:9(1173) ↗
24. Punching shear strengthening of two-way flat slabs with CFRP grids10.1061/(ASCE)CC.1943-5614.0000443 ↗
25. Punching shear behavior of two-way slabs reinforced with high-strength steel
26. Experimental investigation on the behavior of high-strength concrete slabs
27. Modelling of CFRP-concrete shear-lap tests10.1016/j.conbuildmat.2006.06.012 ↗
28. Bond behaviour of CFRP reinforcement for torsional strengthening of solid and box-section RC beams10.1016/j.compositesb.2006.06.018 ↗
29. ASTMC39-14a · 2014
30. ASTMC496-11 · 2011
31. ASTMA370-16 · 2016
32. Cervenka · 2007
33. CEB-FIP Model Code for Concrete Structures. International Federation for Structural Concrete, Lausanne; 2010.
34. Punching shear behavior of flat slabs strengthened with fiber reinforced polymer laminates10.1061/(ASCE)1090-0268(2004)8:5(384) ↗
35. Shear strengthening of interior slab-column connections using carbon fiber-reinforced polymer sheets10.1061/(ASCE)1090-0268(2003)7:2(145) ↗
36. Abdulla · 2010
37. ACI318-14 · 2014
38. Eurocode 2, Design of Concrete Structures—Part 1-1: General Rules and Rules for Building, British Standards, 2004.
39. CEB-FIP Model Code 1990 Design code, London: Thomas Telford, Lausanne, Switzerland, 1993.