journal article·2019-03

Investigation on mechanical and microwave heating characteristics of asphalt mastic using activated carbon powder as electro-magnetic absorbing materials

Yongdan Wang, Ziming Liu, Peiwen Hao

Publisher page

Abstract

Abstract Activated carbon, one of carbon-based materials with developed pore structure and favourable microwave radiation absorption, was added in asphalt to investigate its possibility as microwave heating enhancement in asphalt materials. Effect of activated carbon powder (ACP) on mechanical performance of asphalt mastic was firstly studied. Mechanical tests including multiple stress creep and recovery (MSCR) test, temperature sweep test, time sweep test, and linear amplitude sweep (LAS) test were conducted to evaluate rutting resistance, liner viscosity, and fatigue resistance. Interactions between fillers and asphalt were then observed by scanning electron microscope (SEM). Besides, microwave heating capacity of asphalt mastic with different amount of ACP was investigated to ensure its potential in microwave heating acceleration. Cost of activated carbon powder in asphalt mixture was roughly estimated and compared with other microwave absorbing materials. Results showed that addition of ACP slightly influenced physical properties of mastic, permanent deformation at high temperature of asphalt mastic decreased and creep recovery increased. Increase of complex shear modulus and rutting factor suggested that asphalt was stiffened by adding ACP and rutting resistance was also improved. Fatigue resistance was improved and fatigue life was extended most when ACP replacement was 100% volume fraction of fillers. Wetting surface between ACP and asphalt was smooth with less folds and voids which means it had good contact and interaction with asphalt. Mastic with larger amount of ACP had a quick temperature rise under microwave radiation and heating rate (HR) defined as temperature increment per seconds was applied. It is found that surface temperature increased firstly fast and then slowly when dividing heating process as two stage. Results basically ensured the feasibility of ACP in enhancing mechanical performance and microwave heating capacity of asphalt materials. The extra cost from ACP is relatively lower. Partial substitution of ACP in fillers and reused ACP from pollution treatment factories may further reduce the amount and cost from ACP application.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Asphalt Pavement Performance Evaluation · Electromagnetic wave absorption materials · Corrosion Behavior and Inhibition

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (47)

Show source-provided references
1. Multiscale prediction of viscoelastic properties of asphalt concrete10.1061/(ASCE)0899-1561(2009)21:12(771) ↗
2. Effect of Mineral Filler Characteristics on Asphalt Mastic and Mixture Rutting Potential10.3141/2208-05 ↗
3. Airey · 2006
4. Effect of filler on low temperature physical hardening of bitumen10.1016/S0950-0618(98)00028-2 ↗
5. Influence of the geometrical and physical properties of filler in the filler–bitumen interaction10.1016/j.conbuildmat.2014.12.008 ↗
6. A state-of-the-art review on interfacial behavior between asphalt binder and mineral aggregate
7. Study on Microscopic Mechanism of Fly Ash Hot Recycled Asphalt mortar and Performance of Mixture
8. Influence of nanosilica and diatomite on the physicochemical and mechanical properties of binder at unaged and oxidized conditions10.1016/j.conbuildmat.2016.09.140 ↗
9. Evaluation of rice husk ash as filler in hot mix asphalt concrete10.1016/j.conbuildmat.2013.06.029 ↗
10. Application of coal waste powder as filler in hot mix asphalt10.1016/j.conbuildmat.2014.06.002 ↗
11. Advanced evaluation of asphalt mortar for induction healing purposes10.1016/j.conbuildmat.2016.09.011 ↗
12. Induction heating and healing of carbon black modified asphalt concrete under microwave radiation10.1016/j.conbuildmat.2018.04.002 ↗
13. Microwave Absorbing Characteristics of Asphalt Mixes with Carbonyl Iron Powder10.2528/PIERM11052312 ↗
14. Self-healing efficiency of ferrite-filled asphalt mixture after microwave irradiation10.1016/j.conbuildmat.2017.02.145 ↗
15. Utilization of steel slag as aggregate in asphalt mixtures for microwave deicing10.1016/j.jclepro.2017.03.113 ↗
16. Snow and ice melting properties of self-healing asphalt mixtures with induction heating and microwave heating10.1016/j.applthermaleng.2017.10.050 ↗
17. Activated carbons modified with sewage sludge derived phase and their application in the process of NO removal10.1016/j.carbon.2007.08.030 ↗
18. Adsorption of volatile organic compounds by pecan shell- and almond shell-based granular activated carbons10.1016/S0960-8524(03)00117-2 ↗
19. Sulfur dioxide adsorption by activated carbons having different textural and chemical properties10.1016/j.fuel.2008.06.002 ↗
20. Preparation of sludge-based activated carbon and its application in dye waste water treatment10.1016/j.jhazmat.2007.08.011 ↗
21. Non-conventional low-cost adsorbents for dye removal: a review10.1016/j.biortech.2005.05.001 ↗
22. Temperature measurement of GAC and decomposition of PCP loaded on GAC and GAC-supported copper catalyst in microwave irradiation10.1016/j.apcata.2003.12.026 ↗
23. Investigation on the rapid degradation of congo red catalyzed by activated carbon powder under microwave irradiation10.1016/j.jhazmat.2006.12.083 ↗
24. Degradation of Methyl Orange in Aqueous Solution by Microwave Irradiation in the Presence of Granular-Activated Carbon10.1007/s11270-014-1983-0 ↗
25. Gu Jianyu, Ma Chen, Zhou Bi cheng, Liu Yan, Preparation and Performance Study of Activated Carbon/Magnetic Metal Hybrid as Microwave Absorbent, J. Microwaves 2014, (s1).
26. Microwave assisted preparation of activated carbon from biomass: a review10.1016/j.rser.2018.04.051 ↗
27. Induced heating-healing characterization of activated carbon modified asphalt concrete under microwave radiation10.1016/j.conbuildmat.2018.05.012 ↗
28. Effect of activated carbon and furan resin on asphalt mixture performance10.1080/14680629.2015.1092465 ↗
29. Investigation on road performance of asphalt mortar composited with magnetite powder/activated carbon powder
30. Investigation on Using SBS and Active Carbon Filler to Reduce the VOC Emission from Bituminous Materials10.3390/ma7096130 ↗
31. Using Activated Carbon to Reduce the Volatile Organic Compounds from Bituminous Materials10.1061/(ASCE)MT.1943-5533.0002024 ↗
32. VOCs reduction and inhibition mechanisms of using active carbon filler in bituminous materials10.1016/j.jclepro.2018.01.222 ↗
33. Using activated carbon to enhance the vocs and heavy metals removal of a porous asphalt pavement system
34. A conceptual study on the formulation of a permeable reactive pavement with activated carbon additives for controlling the fate of non-point source environmental organic contaminants10.1016/j.chemosphere.2017.11.028 ↗
35. Investigation of rutting, fracture and thermal cracking behavior of asphalt mastic containing basalt and hydrated lime fillers10.1016/j.conbuildmat.2017.03.032 ↗
36. AASHTO Designation: TP 350, Standard method of test for multiple stress creep recovery (MSCR) test of asphalt binder using a dynamic shear rheometer (DSR).
37. Simplification of Linear Amplitude Sweep Test and Specification Parameter10.3141/2370-02 ↗
38. AASHTO Designation: TP 101-14, Standard method of test for estimating damage tolerance of asphalt binders using the linear amplitude sweep.
39. Jinsheng · 2009
40. Construction of Activated Carbon Efficient Atomistic Model, and Molecular Simulation Insight Into the Behavior of Sorption
41. Crack pinning in asphalt mastic and concrete: Healing studies
42. Evaluation of Fatigue Tests for Characterizing Asphalt Binders10.1061/(ASCE)MT.1943-5533.0000625 ↗
43. N. Gibson, X. Qi, A. Shenoy, G. Al-Khateeb, M.E. Kutay, A. Andriescu, Full-scale accelerated performance testing for Superpave and structural validation, Final Rep. FHWA-RT-01946, Federal Highway Administration, Washington, DC, 2011.
44. B. Zohuri, Chapter 6 – Second Law of Thermodynamics, Phys. Cryogenics, 2018: pp. 165–183.10.1016/B978-0-12-814519-7.00006-9 ↗
45. Effects of carbon black on the anti-aging, rheological and conductive properties of SBS/asphalt/carbon black composites10.1016/j.conbuildmat.2013.11.061 ↗
46. Electromagnetic wave absorbing properties of asphalt mixture with natural magnetite powder
47. https://www.1688.com/chanpin/-313030BBEED0D4CCBFB7DB.html.