Influence of recycled limestone filler additions on the mechanical behaviour of commercial premixed hydraulic lime based mortars
Source abstract
Abstract
This paper presents an experimental programme aimed at investigating the use of limestone filler additions to modify the mechanical properties of commercial premixed hydraulic lime based mortars. The influence of adding recycled limestone filler was evaluated from the mechanical point of view, i.e. by comparing the experimental compressive and flexural strengths of five different mortar mixes with variable filler contents. The comparison of results shows that, up to a certain amount, the addition of filler provides an improvement of the mortar’s mechanical properties. Beyond this optimum limit, strengths tend to decrease and eventually stabilize. Hence, mortars tested as part of this experimental campaign covered a range of strengths. Consequently, adding limestone filler can serve to adapt the applicability of hydraulic lime mortars to different practical applications, from the conservation of historical buildings to laboratory research on masonry.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Building materials and conservation · Conservation Techniques and Studies · Concrete and Cement Materials Research
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (67)
Show source-provided references
1. Mechanical properties of natural hydraulic lime-based mortars10.1016/j.cemconres.2004.02.005 ↗
2. The history of calcareous cements
3. High-performance repair mortars for application in severe weathering environments: frost resistance assessment
4. Choosing mortar compositions for repointing of historic masonry under severe environmental conditions
5. Air lime mortars: what else do we need to know to apply them in conservation and rehabilitation interventions ? a review10.1016/j.conbuildmat.2017.09.080 ↗
6. Commercial NHL-containing mortars for the preservation of historical architecture. Part 1: compositional and mechanical characterisation10.1016/j.conbuildmat.2012.08.029 ↗
7. Lime-based mortars: viability for use as substitution renders in historical buildings10.1080/15583050902914678 ↗
8. The effect of aggregate size and type of binder on microstructure and mechanical properties of NHL mortars10.1016/j.conbuildmat.2013.11.111 ↗
9. Portland cement-lime mortars for conservation
10. Hydraulic lime mortars for the restoration of historic masonry in Crete10.1016/j.cemconres.2004.09.001 ↗
11. Natural hydraulic lime mortars: influence of the aggregates
12. A study of the workability of natural hydraulic lime mortars and its influence on strength10.1617/s11527-007-9250-0 ↗
13. Natural hydraulic lime versus cement for blended lime mortars for restoration works10.1016/j.conbuildmat.2015.06.058 ↗
14. The effects of site practice on the physical properties of proprietary stone restoration mortar10.1016/j.conbuildmat.2014.11.040 ↗
15. Commercial NHL-containing mortars for the preservation of historical architecture. Part 2: Durability to salt decay10.1016/j.conbuildmat.2015.08.006 ↗
16. Physico-chemical stone-mortar compatibility of commercial stone-repair mortars of historic buildings from Paris10.1016/j.conbuildmat.2016.07.076 ↗
17. Changes in properties of cement and lime mortars when incorporating fibers from end-of-life tires10.3390/fib4010007 ↗
18. Recycled plastic aggregate in mortars composition: effect on physical and mechanical properties10.1016/j.matdes.2013.06.025 ↗
19. Mechanical and mineralogical properties of natural hydraulic lime-metakaolin mortars in different curing conditions10.1016/j.conbuildmat.2013.10.045 ↗
20. Fiber-reinforced lime-based mortars: effect of zeolite addition10.1016/j.conbuildmat.2014.12.067 ↗
21. Study of natural hydraulic lime-based mortars prepared with masonry waste powder as aggregate and diatomite/fly ash as mineral admixtures10.1016/j.jclepro.2016.01.069 ↗
22. Influence of the addition of waste graphite powder on the physical and microstructural performance of hydraulic lime pastes10.1016/j.conbuildmat.2017.05.156 ↗
23. Experimental investigation on physical and mechanical properties of lime mortar: effect of organic addition10.1016/j.culher.2017.10.009 ↗
24. Characterization of hydraulic lime mortar containing opuntia ficus-indica as a bio-admixture for restoration applications10.1080/15583058.2015.1109735 ↗
25. Effect of a high calcite filler addition upon microstructural, mechanical, shrinkage and transport properties of a mortar10.1016/j.cemconres.2008.02.007 ↗
26. Evaluation of fine limestone quarry by-products, for the production of building elements – an experimental approach10.1016/j.conbuildmat.2011.05.011 ↗
27. D. Manning, Exploitation and Use of Quarry Fines. Report No. 087/MIST2/DACM/01, Mineral Solutions, 2004.
28. Sustainable utilisation of quarry by-products
29. Filler technology for improving robustness and reducing cementitious paste volume of SCC10.1016/j.conbuildmat.2017.07.160 ↗
30. Fresh and hardened characteristics of self compacting concretes made with combined use of marble powder, limestone filler, and fly ash10.1016/j.conbuildmat.2012.07.092 ↗
31. Sustainability perspective of marble and granite residues as concrete fillers10.1016/j.conbuildmat.2013.03.032 ↗
32. Limestone filler cement in low w/c concrete: a rational use of energy10.1016/S0008-8846(02)01087-6 ↗
33. Effect of limestone fillers the physic-mechanical properties of limestone concrete10.1016/j.phpro.2011.10.005 ↗
34. Strength and durability of concrete incorporating crushed limestone sand10.1016/j.conbuildmat.2008.02.005 ↗
35. Lea · 1971
36. Calcareous fillers and the compressive strength of portland cement10.1016/0008-8846(76)90099-5 ↗
37. Influence of CaCO3 on the hydration of 3CaO·Al2O310.1111/j.1151-2916.1965.tb11787.x ↗
38. A review on use of limestone powder in cement-based materials: mechanism, hydration and microstructures10.1016/j.conbuildmat.2018.06.075 ↗
39. Effect of limestone powder as a partial replacement of crushed quarry sand on properties of self-compacting repair mortars10.34118/jbms.v3i1.21 ↗
40. Hydration kinetics and compressive strength of steam-cured cement pastes and mortars containing limestone filler10.1016/j.conbuildmat.2016.03.031 ↗
41. Air lime mortars: the influence of calcareous aggregate and filler addition10.4028/www.scientific.net/MSF.636-637.1280 ↗
42. T. Skoulidis, D. Charalambous, K. Tsakona, Amelioration of the properties of hydrated lime for the consolidation of the surface or/and the mass of building materials of monuments or new buildings or statures and ornaments, in: 8th Int. Congr. Deterior. Conserv. Stone, 1996: pp. 1599–1605.
43. A.M. Forster, N. Razali, P. Banfill, E. Szadurski, C. Torney, The influence of calcitic filler in hydraulic lime mortars for use in high temperature and high humidity climatic conditions : A preliminary investigation, in: J.J. Hughes, J. Válek, C. Groot (Eds.), Hist. Mortars, Springer International, 2019: pp. 201–211. doi: https://doi.org/10.1007/978-3-319-91606-4.10.1007/978-3-319-91606-4_15 ↗
44. European Committee for Standardization (CEN), EN 459-1 Building lime – Part 1: Definitions, specifications and conformity criteria, 2010.
45. European Committee for Standardization (CEN), EN 933-1 Test for geometrical properties of aggregates – Part 1: Determination of particle size distribution. Sieving method, 1997.
46. European Committee for Standardization (CEN), EN 1015-3 Methods of test for mortar for masonry – Part 3: Determination of consistence of fresh mortar (by flow table), 1999.
47. European Committee for Standardization (CEN), EN 1015-11 Methods of test for mortar for masonry – Part 11: Determination of flexural and compressive strength of hardened mortar, 1999.
48. European Committee for Standardization (CEN), EN 196-1 Methods of testing cement – Part 1: Determination of strength, 2005.
49. Strength development and lime reaction in mortars for repairing historic masonries10.1016/j.cemconcomp.2004.02.017 ↗
50. A. Costigan, An experimental study of the physical properties of lime mortar and their effect on lime-mortar masonry, PhD dissertation, University of Dublin, 2013.
51. Combined in-situ and laboratory minor destructive testing of historical mortars10.1080/15583058.2017.1323247 ↗
52. Hydraulic lime mortar for stone, brick and block masonry
53. B.A. Silva, A.P. Ferreira Pinto, A. Gomes, Influence of natural hydraulic lime content on the properties of aerial lime-based mortars, Constr. Build. Mater. 72 (2014) 208–218. doi: 10.1016/j.conbuildmat.2014.09.010.10.1016/j.conbuildmat.2014.09.010 ↗
54. Hiding in plain sight: hot mixed lime mortars
55. Study of the historical mortars of the Holy Aedicule as a basis for the design, application and assessment of repair mortars: a multispectral approach applied on the Holy Aedicule10.1016/j.conbuildmat.2018.06.016 ↗
56. Implications of the spandrel type on the lateral behavior of unreinforced masonry walls10.1002/eqe.2441 ↗
57. Review of experimental cyclic tests on unreinforced and strengthened masonry spandrels and numerical modelling of their cyclic behaviour10.1016/j.engstruct.2016.11.063 ↗
58. Two-story perforated URM wall subjected to cyclic in-plane loading10.1061/(ASCE)ST.1943-541X.0002021 ↗
59. G. Magenes, A. Penna, A. Galasco, M. Rota, Experimental characterisation of stone masonry mechanical properties, in: 8th Int. Mason. Conf., 2010: pp. 247–256.
60. G. Guerrini, I. Senaldi, S. Scherini, S. Morganti, G. Magenes, K. Beyer, A. Penna, Material Characterization for the Shaking-Table Test of the Scaled Prototype of a Stone Masonry Building Aggregate, in: Proc. XVII Convegno ANIDIS “L’Ingegneria Sismica Ital., 2017.
61. Monotonic and cyclic testing of clay brick and lime mortar masonry in compression10.1016/j.conbuildmat.2018.10.198 ↗
62. Dynamic elastic properties of brick masonry constituents10.1016/j.conbuildmat.2018.12.071 ↗
63. Quantification of progressive structural integrity loss in masonry with Acoustic Emission-based damage classification10.1016/j.conbuildmat.2018.10.215 ↗
64. Compression test of masonry core samples extracted from existing brickwork10.1016/j.conbuildmat.2016.05.057 ↗
65. P. Matysek, Compressive strength of brick masonry in existing buildings — research on samples cut from the structures, in: C. Modena, F. da Porto, M.R. Valluzzi (Eds.), Brick Block Mason. – Trends, Innov. Challenges, Taylor & Francis Group, 2016: pp. 1741–1747.10.1201/b21889-216 ↗
66. Experimental analysis of the size effect on the compressive behaviour of cylindrical samples core-drilled from existing brick masonry10.1016/j.conbuildmat.2019.116759 ↗
67. Cornadó · 2015