journal article·2022-04Open access

Viscoelasticity modelling of asphalt mastics under permanent deformation through the use of fractional calculus

M. Lagos-Varas, D. Movilla-Quesada, A.C. Raposeiras, D. Castro-Fresno, O. Muñoz-Cáceres, V.C. Andrés-Valeri, M.A. Rodríguez-Esteban

Abstract

This study focuses on the mechanical behaviour of asphalt mastic composed of filler particles bonded with an asphalt bitumens. Asphalt mastics are viscoelastic composite materials widely used in the construction of pavement layers. The mechanical properties and the influence of the fillers on the filler/bitumen (f/b) matrix is one of the main areas of current research. In particular, the elastic determination of fillers for mechanical testing in asphalt mastic is relevant to understand permanent deformation caused by temperature variations caused by seasonal changes and vehicular traffic loads. In this sense, this research proposes a new methodology for rheological characterization of the elastic properties of the filler ξ2 and elastic-viscous properties of the asphalt bitumen, ξ1 and η, respectively, complementing the existing designs of asphalt mixture. The proposed methodology allows for identification of the influence of non-conventional fillers in the behavior of the asphalt mastic for the different recovery cycles of the Multiple Stress Creep Recovery (MSCR) and determination of new rheological parameters for the compression of the recovery phenomena and the elastic capacity of the type of filler and weight of the base bitumen. The results obtained show a greater adjustment to the experimental curves in determining the elastic modulus in each cycle for the hydrated lime and fly ash fillers with different filler/bitumen ratios. In particular, the proposed model for bituminous mastics achieves a strong fit with the experimental curves by empirically reducing the quadratic error (R2 = 0.99) and managing to differentiate the elastic capacity ξ2 of each filler and its effect with increasing concentration. For example, it establishes that the Hydrated lime filler (HL) acquires an average Young's modulus of 0.005 MPa, being 99.31% more elastic than Fly ash filler (FA) for a load of 3.2 kPa at a 1.25f/b ratio. In addition, the new model can be used to modify bitumen properties to design optimized and stronger asphalt mixtures.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Asphalt Pavement Performance Evaluation · Infrastructure Maintenance and Monitoring · Rheology and Fluid Dynamics Studies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (46)

Show source-provided references
1. Study of the mechanical behavior of asphalt mixtures using fractional rheology to model their viscoelasticity10.1016/j.conbuildmat.2018.12.073 ↗
2. Electrically-conductive asphalt mastic: Temperature dependence and heating efficiency10.1016/j.matdes.2018.07.059 ↗
3. Performance-based design of asphalt mixtures and review of key parameters10.1016/j.matdes.2017.12.035 ↗
4. Sustainable asphalt mastics made up recycling waste as filler10.1016/j.jenvman.2021.113826 ↗
5. Identification of interfacial transition zone in asphalt concrete based on nano-scale metrology techniques10.1016/j.matdes.2017.05.015 ↗
6. Investigating the interaction between asphalt binder and fresh and simulated RAP aggregate10.1016/j.matdes.2016.04.102 ↗
7. Evaluation of water effect on bituminous mastics with different contribution fillers and binders10.1016/j.conbuildmat.2011.08.093 ↗
8. International Journal of Transportation Study on application of cement substituting mineral fillers in asphalt mixture10.1016/j.ijtst.2018.06.002 ↗
9. Thermal suspectability analysis of the reuse of fly ash from cellulose industry as contribution filler in bituminous mixtures10.1016/j.conbuildmat.2017.11.046 ↗
10. Investigation of rutting, fracture and thermal cracking behavior of asphalt mastic containing basalt and hydrated lime fillers10.1016/j.conbuildmat.2017.03.032 ↗
11. Effects of steel slag fillers on the rheological properties of asphalt mastic
12. Experimental research on combined effects of flame retardant and warm mixture asphalt additive on asphalt binders and bituminous mixtures10.1016/j.conbuildmat.2013.12.058 ↗
13. Influence of hydrated lime on linear viscoelastic properties of bituminous mastics10.1007/s11043-018-09404-x ↗
14. An experimental investigation of flame retardant mechanism of hydrated lime in asphalt mastics10.1016/j.matdes.2016.04.057 ↗
15. Effect of Hydrated Lime on Rheology, Fracture, and Aging of Bitumen10.3141/1661-14 ↗
16. Effect of hydrated lime on linear viscoelastic properties of asphalt mixtures with glass aggregates subjected to freeze-thaw cycles10.1016/j.conbuildmat.2018.06.130 ↗
17. Environmental impacts of utilizing waste steel slag aggregates as recycled road construction materials Environmental impacts of utilizing waste steel slag aggregates as recycled road construction materials10.1007/s10098-016-1289-6 ↗
18. Fly ash as low cost and environmentally friendly filler and its effect on the properties of mix asphalt10.1016/j.jclepro.2019.06.353 ↗
19. Effect of using fly ash as alternative filler in hot mix asphalt10.1016/j.pisc.2016.04.061 ↗
20. Evaluation of physicochemical interaction between asphalt binder and mineral filler through interfacial adsorbed film thickness10.1016/j.conbuildmat.2020.119135 ↗
21. Effect of air voids on the high-temperature creep behavior of asphalt mixture based on three-dimensional discrete element modeling10.1016/j.matdes.2015.10.005 ↗
22. Investigation of surface micro-crack growth behavior of asphalt mortar based on the designed innovative mesoscopic test10.1016/j.matdes.2019.108238 ↗
23. Influence of limestone filler on the rheological properties of bituminous mastics through susceptibility master curves10.1016/j.conbuildmat.2019.117126 ↗
24. Material nonlinearity in asphalt binder fatigue testing and analysis10.1016/j.matdes.2017.08.010 ↗
25. 3D printing of asphalt and its effect on mechanical properties10.1016/j.matdes.2018.09.030 ↗
26. Studies on the secondary modification of SBS modified asphalt by the application of octadecyl amine grafted graphene nanoplatelets as modifier10.1016/j.diamond.2018.08.011 ↗
27. Evaluation of sustainable technologies that upgrade the binder performance grade in asphalt pavement construction10.1016/j.matdes.2016.01.065 ↗
28. Investigating impacts of warm-mix asphalt technologies and high reclaimed asphalt pavement binder content on rutting and fatigue performance of asphalt binder through MSCR and LAS tests10.1016/j.jclepro.2019.02.131 ↗
29. Physico-chemo-rheological characterization of neat and polymer-modified asphalt binders10.1016/j.conbuildmat.2018.12.064 ↗
30. Correlation between multiple stress creep recovery (MSCR) results and polymer modification of binder10.1016/j.conbuildmat.2014.04.111 ↗
31. Multi–scale enhancement mechanisms of graphene oxide on styrene–butadiene–styrene modified asphalt: An exploration from molecular dynamics simulations10.1016/j.matdes.2021.109901 ↗
32. Use of the MSCR test to characterize the asphalt binder properties relative to HMA rutting performance – A laboratory study10.1016/j.conbuildmat.2015.06.044 ↗
33. Analysis of viscoelastic response and creep deformation mechanism of asphalt mixture10.1016/j.conbuildmat.2018.03.104 ↗
34. Rutting and fatigue performance evaluation of warm mix asphalt mastic containing high percentage of artificial RAP binder10.1016/j.conbuildmat.2019.117860 ↗
35. Study of the permanent deformation of binders and asphalt mixtures using rheological models of fractional viscoelasticity10.1016/j.conbuildmat.2020.120438 ↗
36. Experimental study on rheological properties and moisture susceptibility of asphalt mastic containing red mud waste as a filler substitute10.1016/j.conbuildmat.2019.03.252 ↗
37. Study of the action of nano-alumina particles in hydrated lime pastes10.1016/j.jobe.2021.103808 ↗
38. Effect of mineral fillers on the performance, rheological and dynamic viscosity measurements of asphalt mastic10.1016/j.conbuildmat.2019.06.170 ↗
39. Evaluation on long-term performance of emulsified asphalt cold recycled mixture incorporating fly ash by mechanistic and microscopic characterization10.1016/j.conbuildmat.2021.126120 ↗
40. The role of rejuvenators in embedded damage healing for asphalt pavement10.1016/j.matdes.2021.109564 ↗
41. Preventive maintenance of porous asphalt concrete using surface treatment technology10.1016/j.matdes.2016.03.082 ↗
42. Contact mechanics based solution to predict modulus of asphalt materials with high porosities10.1016/j.matdes.2021.109752 ↗
43. Synchronization for commensurate Riemann-Liouville fractional-order memristor-based neural networks with unknown parameters10.1016/j.jfranklin.2020.06.025 ↗
44. Micromechanics modeling of viscoelastic asphalt-filler composite system with and without fatigue cracks10.1016/j.matdes.2021.109983 ↗
45. Lorenzo · 1999
46. Unsteady boundary layer flow of viscoelastic MHD fluid with a double fractional Maxwell model10.1016/j.aml.2019.03.036 ↗