Stress corrosion cracking of new 2001 lean–duplex stainless steel reinforcements in chloride contained concrete pore solution: An electrochemical study
Source abstract
Abstract
Abstract An experimental SCC tests has been performed on 2001 lean–duplex stainless steel (LDSS) and 2205 duplex stainless steel (DSS) reinforcements. Specimens were tested by loads up to 85% of their yield strength and simultaneously exposed to 8% chloride in simulated concrete pore solution. Although the maximum corrosion current density value obtained for 2001 LDSS was three times higher than 2205 DSS, specimens demonstrated passivity. Cycling polarization curve was performed which shows that 2205 DSS does not develop any pit but 2001 LDSS does. Finally, specimens were loaded until failure; fracture surface analysis detected a combination of ductile and brittle fracture mode in 2001 LDSS. Even if 2001 LDSS shows worse SCC performance, it is enough to ensure the nominal service life of reinforced concrete structures with lower cost.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Concrete Corrosion and Durability · Hydrogen embrittlement and corrosion behaviors in metals · Corrosion Behavior and Inhibition
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (40)
Show source-provided references
1. Stress corrosion cracking behavior of ZK60 magnesium alloy under different conditions10.1016/j.ijhydene.2017.08.161 ↗
2. Corrosion prevention and remediation strategies for reinforced concrete coastal bridges10.1016/S0958-9465(01)00031-2 ↗
3. Steel corrosion behaviour in carbonated alkali-activated slag concrete10.1016/j.corsci.2009.05.033 ↗
4. Corrosion and cathodic protection of carbon steel in the tidal zone: products, mechanisms and kinetics10.1016/j.corsci.2014.10.035 ↗
5. A prediction study of hydroxyapatite entrapment ability in concrete10.1016/j.conbuildmat.2010.04.060 ↗
6. Electrochemical study on the corrosion behaviour of a new low-nickel stainless steel in carbonated alkaline solution in the presence of chlorides10.1016/j.electacta.2014.02.107 ↗
7. Corrugated stainless steels embedded in mortar for 9 years: corrosion results of non-carbonated, chloride-contaminated samples10.1016/j.conbuildmat.2015.04.060 ↗
8. Corrosion behavior of stainless steel rebars embedded in concrete: an electrochemical impedance spectroscopy study10.1016/j.electacta.2013.11.154 ↗
9. Durability assessment of concrete structures in HZM sea link project for service life of 120 years10.1617/s11527-015-0754-8 ↗
10. Stress corrosion cracking behavior of 2205 duplex stainless steel in concentrated NaCl solution10.1016/S0010-938X(99)00105-5 ↗
11. Stress corrosion cracking of LDX 2101® duplex stainless steel in chloride solutions in the presence of thiosulphate10.1016/j.corsci.2013.11.028 ↗
12. Structural effects of steel reinforcement corrosion on statically indeterminate reinforced concrete members10.1617/s11527-016-0836-2 ↗
13. Fracto-surface mobility mechanism in high-strength steel wires10.1016/j.engfracmech.2017.11.003 ↗
14. Evaluation of mechanical and structural behavior of austenitic and duplex stainless steel reinforcements10.1016/j.conbuildmat.2015.01.008 ↗
15. Mechanical properties and corrosion behaviour of stainless steel reinforcing bars10.1016/S0924-0136(03)00393-5 ↗
16. NACE International Institute. Maintenance and rehabilitation considerations for corrosion control of existing steel reinforced concrete structures. RP 0390-90, 1990.
17. Briz Blanco E. Evaluation of 2205 duplex stainless steel and 2001 lean duplex stainless steel reinforcements behaviour under stress corrosion cracking in chloride contained simulated concrete pore solution. Ph D Thesis (2016) University of Cantabria.
18. Corrosion behaviour of a new low-nickel stainless steel in saturated calcium hydroxide solution10.1016/j.conbuildmat.2011.04.056 ↗
19. Low-nickel stainless steel passive film in simulated concrete pore solution: a SIMS study10.1016/j.apsusc.2010.03.140 ↗
20. BS 6744. Stainless steel bars for the reinforcement of and use in concrete-Requirements and test methods. British Standard, 2016.
21. ASTM-A955/A955M-18. Standard specification for deformed and plain stainless-steel bars for concrete reinforcement. American Society for Testing and Materials, 2018.
22. EHE 08. Instrucción de hormigón estructural. Ministerio de Fomento Comisión permanente del hormigón, 2008.
23. BA 84/02. Use of stainless steel reinforcement in highway structures. British Standard, The highway structures, 2002.
24. UNE 36067. Stainless steel wire for the reinforcement of concrete. European Standard, 2017.
25. B. Sørense, P Jensen, E Maahn, The corrosion properties of stainless seel reinforcement, Corrosion of Reinforcements in Concrete, Ed Elsevier, 1990, pp. 601–610.
26. Effects of hydrogen assisted stress corrosion on damage tolerance of a high-strength duplex stainless steel wire for prestressing concrete10.1016/j.conbuildmat.2014.05.069 ↗
27. Examination of rockbolt stress corrosion cracking utilising full size rockbolts in a controlled mine environment10.1016/j.ijrmms.2015.11.007 ↗
28. UNE-EN ISO 7539-6. Corrosion of metals and alloys – stress corrosion testing – Part 6: Preparation and use of precracked specimens for tests under constant load or constant displacement. European Standard, 2012.
29. UNE 112072, Laboratory measurement of corrosion speed using the polarization resistance technique, European Standard, 2011.
30. Chloride threshold value to initiate reinforcement corrosion in simulated concrete pore solutions: the influence of surface finishing and pH10.1016/j.conbuildmat.2017.03.004 ↗
31. UNE 112083, Measurement of free corrosion potential on steel reinforced concrete structures, European Standard, 2010.
32. Standard test method for corrosion potentials of uncoated reinforcing steel in concrete
33. Chloride-induced corrosion resistance of high-strength stainless steels in simulated alkaline and carbonated concrete pore solutions10.1016/j.corsci.2011.12.012 ↗
34. The electrochemical behaviour of 2205 duplex stainless steel in alkaline solutions with different pH in the presence of chloride10.1016/j.electacta.2012.01.025 ↗
35. UNE-EN 1990:2003. Eurocode – Basis of structural design. European Standard, 2003.
36. Eurocode 2, Design of concrete structures – Part 1-1: General rules and rules for buildings, European Standard, 2015.
37. A stress corrosion cracking mechanism based on surface mobility10.1016/0010-938X(87)90117-X ↗
38. The role of hydrogen in microbiologically influenced corrosion and stress corrosion cracking10.1016/S0360-3199(00)00091-4 ↗
39. Corrosion-induced brittle failure in reinforcing steel10.1016/j.tafmec.2017.08.006 ↗
40. A. Knudsen, F.M. Jensen, O. Klinghoffer, T. Skovsgaard, Cost-effective enhancement of durability of concrete structures by intelligent use of stainless steel reinforcement, 1999, p. 15.