journal article·2020-02

Experimental investigation on replacing cement by sintered limestone ash from the steelmaking industry for cement-stabilized soil: Engineering performances and micro-scale analysis

Fei Xu, Hua Wei, Wenxun Qian, Xunjie Chen, Tianlei Xu, Yang He, Guocheng Wen

Publisher page

Abstract

Abstract The enormous cement demand for soil stabilization intensifies the carbon footprint on the environment, which can be relieved by replacing cement with supplementary cementitious materials (SCMs). However, such application of common SCMs is limited by the availability and the reactivity of the materials. To deal with this issue, sintered limestone ash (SLA), a novel waste from the steelmaking industry, was investigated for the feasibility of replacing cement for soil stabilization. The SLA was first characterized by means of a laser particle sizer, scanning electron microscopy-energy dispersive spectroscopy (SEM-EDS), X-ray diffraction (XRD), thermogravimetry (TG) and X-ray fluorescence (XRF), and was revealed to process a certain hydration reactivity. To prepare the stabilized soils, the mass fraction of cementitious materials (i.e., cement and SLA) was controlled to 10% of the total dry mass of the solids, and the SLA was then used to replace the cement in mass fractions of 0%, 5%, 10%, 15%, 20%, 50%, 80% and 100%. Subsequently, unconfined compression test revealed that the unconfined compressive strength (UCS) of the stabilized soils were benefitted from an SLA replacement ratio of ≤20%, while they decreased substantially thereafter. Following the UCS test, the compactability and hydraulic conductivity of representative soil samples were investigated, while XRD, SEM-EDS, TG and mercury intrusion porosimetry (MIP) were employed for the micro-scale characterization and mechanism analysis. With increasing SLA replacement ratios, the compactability and hydraulic conductivity value of the stabilized soils were improved. The beneficial effects were produced by the enhanced formation of calcium aluminate hydrate (CAH) and Al2O3–Fe2O3–mono (AFm) phases, as well as the filling effect of high content CaCO3 of SLA, while the deteriorative effects were produced by the relatively low reactivity of SLA compared to that of cement. In addition, the SLA replacement promoted the formation of Fe-AFm, and the high CaCO3 content hindered the carbonation process of AFm phases, enhancing their stability.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Concrete and Cement Materials Research · Recycling and utilization of industrial and municipal waste in materials production · Grouting, Rheology, and Soil Mechanics

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (45)

Show source-provided references
1. Soil stabilisation with lime-activated-GGBS—A mitigation to flooding effects on road structural layers/embankments constructed on floodplains10.1016/j.enggeo.2012.09.010 ↗
2. Long-term strength of soil-cement columns in coastal areas10.1016/j.sandf.2017.04.005 ↗
3. Use of alkali activated high-calcium fly ash binder for kaolin clay soil stabilisation: Physicochemical evolution10.1016/j.conbuildmat.2018.12.188 ↗
4. Boutouil M, Levacher D. Effect of high initial water content on cement-based sludge solidification, 2005.10.1680/grim.2005.9.4.169 ↗
5. Strength development in blended cement admixed saline clay10.1016/j.clay.2011.10.003 ↗
6. Volume changes and mechanical degradation of a compacted expansive soil under freeze-thaw cycles10.1016/j.coldregions.2018.10.008 ↗
7. Stabilization treatment of a dispersive clayey soil using granulated blast furnace slag and basic oxygen furnace slag10.1016/j.clay.2015.02.024 ↗
8. Influences of slag on properties of lightweight cement-treated soils subjected to sulfate corrosion10.1016/j.conbuildmat.2019.02.043 ↗
9. Modeling and simulation of cement hydration kinetics and microstructure development10.1016/j.cemconres.2010.10.004 ↗
10. Reactivity of supplementary cementitious materials (SCMs) in cement blends10.1016/j.cemconres.2019.105799 ↗
11. Microstructural characterization of ITZ in blended cement concretes and its relation to transport properties10.1016/j.cemconres.2015.09.018 ↗
12. Cement technology roadmap 2009: carbon emission reductions up to 2050
13. NDRC. Annual Report on Comprehensive Utilization of Chinese Resources. In: Commission NDaR, editor.2014.
14. The effect of chemical activators on early strength of ordinary Portland cement-slag mortars10.1016/j.conbuildmat.2010.04.006 ↗
15. Experimental study on the performance of lime-based low carbon cementitious materials10.1016/j.conbuildmat.2018.02.156 ↗
16. Pozzolanic Index and lime requirement of low calcium fly ashes in high volume fly ash mortar10.1016/j.conbuildmat.2016.11.038 ↗
17. Characteristics of steel slags and their use in cement and concrete—A review10.1016/j.resconrec.2018.04.023 ↗
18. Durability studies on eco-friendly concrete mixes incorporating steel slag as coarse aggregates10.1016/j.jclepro.2016.04.033 ↗
19. Effect of Steel Slag and Portland Cement in the Rate of Hydration and Strength of Blast Furnace
20. Salman M, Cizer Ö, Pontikes Y, Snellings R, Vandewalle L, Blanpain B, et al. Cementitious binders from activated stainless steel refining slag and the effect of alkali solutions, 2015.10.1016/j.jhazmat.2014.12.046 ↗
21. Choi S, Kim J, Han D, Kim J-H. Hydration properties of ladle furnace slag powder rapidly cooled by air, 2016.10.1016/j.conbuildmat.2016.03.089 ↗
22. Taylor · 1997
23. Effect of anions on the phase stability of γ-FeOOH nanoparticles and the magnetic properties of gamma-ferric oxide derived from lepidocrocite10.1016/S0022-3697(03)00270-1 ↗
24. Composite alkaline activator on cemented soil: Multiple tests and mechanism analyses10.1016/j.conbuildmat.2018.08.118 ↗
25. Hydraulic conductivity and strength of foamed cement-stabilized marine clay10.1016/j.conbuildmat.2019.06.164 ↗
26. Hydraulic conductivity behaviour of soil blended with geofiber inclusions10.1016/j.geotexmem.2017.10.008 ↗
27. Daniel · 1997 · 208
28. Experimental study on the tensile strength of gravelly soil with different gravel content
29. Hydration states of AFm cement phases10.1016/j.cemconres.2015.02.011 ↗
30. Fe-containing phases in hydrated cements10.1016/j.cemconres.2013.12.012 ↗
31. Uptake of chloride and carbonate ions by calcium monosulfoaluminate hydrate10.1016/j.cemconres.2012.05.012 ↗
32. Dissolution-precipitation behaviour of ettringite, monosulfate, and calcium silicate hydrate10.1016/j.cemconres.2003.08.016 ↗
33. Study of chloride binding and diffusion in GGBS concrete10.1016/S0008-8846(02)00712-3 ↗
34. Meyers KS, Speyer RF. Chapter 6 - Thermal Analysis of Clays. In: Brown ME, Gallagher PK, editors. Handbook of Thermal Analysis and Calorimetry: Elsevier Science B.V.; 2003. p. 261-306.10.1016/S1573-4374(03)80010-9 ↗
35. Quantitative evaluation of hydrated cement modified by silica fume using QXRD, 27Al MAS NMR, TG–DSC and selective dissolution techniques10.1016/j.conbuildmat.2012.06.075 ↗
36. Utilization of precipitated CaCO3 from carbon sequestration of industrially emitted CO2 in cementless CaO-activated blast-furnace slag binder system10.1016/j.jclepro.2017.08.097 ↗
37. Adsorption, Cement, Polymer. Interaction mechanisms between Na montmorillonite clay and MPEG-based polycarboxylate superplasticizers10.1016/j.cemconres.2012.03.005 ↗
38. Assessment of pozzolanic activity of different calcined clays10.1016/j.cemconcomp.2013.01.002 ↗
39. Pore size distribution of clayey soils and its correlation with soil organic matter10.1016/S1002-0160(15)60009-1 ↗
40. Pore structure characterization of cement pastes blended with high-volume fly-ash10.1016/j.cemconres.2011.09.012 ↗
41. Pore size distribution of mortars produced with agroindustrial waste10.1016/j.jclepro.2018.03.219 ↗
42. Hydraulic conductivity of cement-stabilized marine clay with metakaolin and its correlation with pore size distribution10.1016/j.enggeo.2015.04.018 ↗
43. Pozzolanic reactivity of pure calcined clays10.1016/j.clay.2016.08.003 ↗
44. Hydration kinetics of cement-quicklime system at different temperatures10.1016/j.tca.2019.01.002 ↗
45. Effect of iron on pozzolanic activity of kaolin10.1016/j.conbuildmat.2013.02.068 ↗