journal article·2009-06

Cyclic loading tests on sandstone and limestone shale aggregates used in unbound forest roads

M. Rodgers, G. Hayes, M.G. Healy

Publisher page

Abstract

This study examined the performance of two aggregates subjected to cyclic loading in a large-scale test rig. The two aggregates examined were: (i) a sandstone from Co. Cork, Ireland and (ii) a limestone shale from Co. Limerick, Ireland. The aggregates were classified and their engineering properties established and compared. Various depths of the aggregates, overlaying a 1 m-deep formation layer, were compacted and subjected to a cyclic loading regime of incrementally increasing pressures of 500 kPa, 750 kPa and 1,000 kPa. Each aggregate was tested for up to 150,000 load applications. The resilient pressures, resilient surface deflections and permanent deformations were measured. The sandstone performed well in a dry state but poorly when wetted up. The shale behaved poorly but the addition of a wet mix macadam (WWM) layer greatly improved its performance.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Geotechnical Engineering and Soil Stabilization · Transportation Safety and Impact Analysis · Geotechnical Engineering and Analysis

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (11)

Show source-provided references
1. Browne SF. The structural role of granular materials in flexible pavements. In: Jones RH, editor. Symposium on unbound aggregates in roads; 1981.
2. B.S. 1377: Part 4. Methods of test for Soils for civil engineering purposes – Compaction-related tests. London: British Standards Institution; 1990.
3. B.S. 1377: Part 8. Methods of test for soils for civil engineering purposes – shear strength tests (effective stress). London: British Standards Institution; 1990.
4. B.S. 812: Part 110. Method of determination of the aggregate crushing value (ACV). London: British Standards Institution; 1990.
5. B.S. 812: Part 111. Methods for determination of ten per cent fines value (TFV). London: British Standards Institution; 1990.
6. B.S. 812: Part 112. Methods for determination of aggregate impact value (AIV). London: British Standards Institution; 1990.
7. B.S. 812: Part 113. Method of determination of aggregate abrasion value (AAV). London: British Standards Institution; 1990.
8. Design method for geogrid-reinforced unpaved roads. II. Calibration and applications10.1061/(ASCE)1090-0241(2004)130:8(787) ↗
9. Kielty A. A comparative study on the behaviour of two aggregates under repeated loading. M.Eng.Sc. thesis submitted to the National University of Ireland, Galway; 1997.
10. Powell WD, Potter JF, Mayhew HC, Nunn ME. The structural design of bituminous roads. Laboratory report LR 1132. TRRL, Crowthorne; 1984.
11. Properties of gap-aggregate gradation asphalt mixture and permanent deformation10.1016/j.conbuildmat.2004.05.005 ↗