journal article·2018-06

Comparison of the 3-dim linear viscoelastic behavior of asphalt mixes determined with tension-compression and dynamic tests

Jean-Claude Carret, Alvaro Pedraza, Hervé Di Benedetto, Cédric Sauzeat

Publisher page

Abstract

Abstract In this paper, conventional cyclic tension-compression tests and dynamic measurements have been applied to three cylindrical specimens of asphalt mixes. The results of the two tests have been compared. For the tension-compression tests, the complex modulus was obtained from the measurements of the axial stress and axial strain. For the dynamic testing, an instrumented impact hammer and an accelerometer have been used to obtain the frequency response functions of the specimens at different temperatures. The dynamic complex modulus was then back calculated by optimizing finite element calculated frequency response functions to match the measured frequency response functions. The 2S2P1D linear viscoelastic model was used to estimate master curves of the complex modulus for the two test methods. The two tests give similar results. However, the dynamic measurements give a higher value of the norm of the complex modulus and a lower value of the phase angle compared to the tension–compression results. This result is probably explained by the nonlinearity of asphalt mixes as dynamic tests are performed at a much smaller strain level than the tension-compression tests.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Asphalt Pavement Performance Evaluation · Geotechnical Engineering and Underground Structures · Structural Health Monitoring Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (40)

Show source-provided references
1. Impulse technique for structural response frequency testing
2. ASTM: C215-08 · 2008
3. Migliori · 1997
4. Non-contact rolling surface wave measurements on asphalt concrete
5. Fast simulated annealing inversion of surface waves on pavement using phase-velocity spectra10.1190/1.2204964 ↗
6. Stiffness of bituminous mixtures using ultrasonic wave propagation10.1080/14680629.2009.9690227 ↗
7. Determination of bituminous mixtures linear properties using ultrasonic wave propagation10.1016/j.conbuildmat.2012.04.136 ↗
8. Dynamic modulus of asphalt mixture by ultrasonic direct test10.1016/j.ndteint.2010.06.007 ↗
9. Determination of the complex modulus of asphalt concrete using the impact resonance test10.1177/0361198106197000116 ↗
10. Constructing the dynamic modulus mastercurve using impact resonance testing
11. Determining asphalt concrete properties via the impact resonant method10.1520/JTE12648J ↗
12. Application of resonant acoustic spectroscopy to asphalt concrete beams for determination of the dynamic modulus10.1617/s11527-012-9877-3 ↗
13. Resonant ultrasound spectroscopy
14. Application of three-dimensional resonant acoustic spectroscopy method to rock and building materials10.1121/1.1402255 ↗
15. Resonant frequency testing of cylindrical asphalt samples10.1080/19648189.2011.9693349 ↗
16. Optimization based identification of the dynamic properties of linearly viscoelastic materials using vibrating beam techniques10.1115/1.4003594 ↗
17. Characterization of elastic parameters of acoustical porous materials from beam bending vibrations10.1016/j.jsv.2010.11.013 ↗
18. Simulation based estimation of dynamic mechanical properties for viscoelastic materials used for vocal fold models10.1016/j.jsv.2011.05.008 ↗
19. Characterizing the complex modulus and Poisson's ratio of asphalt concrete specimens through modal testing10.1121/1.4747016 ↗
20. Anisotropic small strain properties of sand and mixture of sand-clay measured by dynamic and static methods10.3208/sandf.47.457 ↗
21. Experimental measurements of the global anisotropic elastic behavior of dry Hostun sand during tri-axial tests, and effects of sample preparation10.1680/geot.7.00042 ↗
22. Comparing linear viscoelastic properties of asphalt concrete measured by laboratory seismic and tension-compression tests10.1007/s10921-014-0253-9 ↗
23. Complex modulus and complex Poisson's ratio from cyclic and dynamic modal testing of asphalt concrete10.1016/j.conbuildmat.2015.04.007 ↗
24. Combined bituminous binder and mixture linear rheological properties10.1016/j.conbuildmat.2004.04.008 ↗
25. Linear and nonlinear viscoelastic behavior of bituminous mixtures10.1617/s11527-014-0316-5 ↗
26. Nonlinearity of bituminous mixtures
27. Projets Mure et Improvmure: bilan à mi-parcours
28. Linear viscoelastic behavior of bituminous materials: From binders to mixtures10.1080/14680629.2004.9689992 ↗
29. General 2S2P1D model and relation between the linear viscoelastic behaviors of bituminous binders and mixes
30. Approximation of linear viscoelastic model in the 3 dimensional case with mechanical analogues of finite size – APPLICATION to bituminous materials
31. Three dimensional linear behavior of bituminous materials: Experiments and modeling10.1061/(ASCE)1532-3641(2007)7:2(149) ↗
32. Time-temperature superposition principle for bituminous mixtures10.1080/19648189.2009.9693176 ↗
33. Validation of the time-temperature superposition principle for crack propagation in bituminous mixtures10.1617/s11527-012-9954-7 ↗
34. Time-temperature superposition principle validation for bituminous mixes in the linear and nonlinear domain10.1061/(ASCE)MT.1943-5533.0000658 ↗
35. Ferry · 1980
36. Development of an automatic modal pendulum for the measurement of frequency responses for the calculation of stability charts10.1016/j.procir.2015.06.090 ↗
37. P.E. Norman, G. Jung, C. Ratcliffe, R. Crane, C. Davis, Development of an Automated Impact Hammer for Modal Analysis of Structures, 2012. DSTO-TN-1062.
38. Spectral analysis of surface waves in single and multi-layer slabs with finite thickness using finite element modelling10.1016/j.ndteint.2004.03.009 ↗
39. Dynamic backcalculation with different load-time histories
40. Evaluation of interface bonding conditions based on non-destructing testing deflection measurements