Factors affecting air-entrainment and performance of roller compacted concrete
Source abstract
Abstract
Abstract The study reported in this paper aims at assessing the key factors affecting the air-entrainment in roller compacted concrete (RCC). The effects of binder content, air-entraining agent (AEA) dosage, workability level, and compaction method on the air-void system and frost resistance of RCC were evaluated. The mixtures were tested to evaluate compressive strength, splitting tensile strength, modulus of elasticity, as well as frost resistance of RCC including freeze–thaw resistance, de-icing salt scaling resistance, and air-void system. The performance of the RCC was compared to that of reference air-entrained and non-air-entrained concrete mixtures. Test results indicated that RCC mixtures with air contents of 5% to 7% and spacing factors lower than 230 μm can be achieved even in relatively dry mixtures with Vebe consistency of 90 s. The air-void network of RCC was found to depend primarily on the consistency level of the concrete and to a lesser extent on the binder content and compaction method. The 28-d compressive strength ranged between 36 and 58 MPa even in the mixtures with a low binder content of 255 kg/m3. Despite the adequate air-void system, the RCC mixtures exhibited low to marginal freeze–thaw resistance. However, the air-entrained RCC mixtures exhibited high durability to deicing salt-scaling with mass loss lower than 400 g/m2 after 50 freeze–thaw cycles.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Concrete and Cement Materials Research · Innovative concrete reinforcement materials · Concrete Properties and Behavior
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (39)
Show source-provided references
1. American Concrete Institute, ACI Concrete Terminology, American Concrete Institute, Farmington Hills, MI, http:// Terminology.concrete.org (accessed Jan. 14, 2008). 2010.
2. Khayat, K.H., Libre, N.A. and Wu, Z., 2019. Roller compacted concrete for rapid pavement construction (No. cmr 19-003).
3. Pittman DW. Development of design procedure for roller compacted concrete (RCC) pavement. Technical Report GL-994-6. US Army Corps of EngineersWaterways Experiment Station; 1994.
4. Pierre Gauthier, Jacques Marchand. Design and construction of roller compacted concrete pavements in Quebec. Report, 2005.
5. A study on performance of roller-compacted concrete for pavement10.1016/j.conbuildmat.2017.07.135 ↗
6. C1170, Standard Test Method for Determining Consistency and Density of Roller-Compacted Concrete Using a Vibrating
7. ACI 325.10R-95, Report on Roller-Compacted Concrete Pavements.
8. Fresh and mechanical properties of roller compacted concrete containing Cationic Asphalt Emulsion admixture10.1016/j.conbuildmat.2018.11.186 ↗
9. The effect of coarse to fine aggregate ratio on the fresh and hardened properties of roller-compacted concrete pavement10.1016/j.conbuildmat.2018.02.216 ↗
10. Marchand J., Gagne R., Ouellet E., Lepage S. Mixture proportioning of roller compacted concrete: a review. ACI Special Publication, 1997, 171
11. Rollings, R. S., Design of roller compacted concrete pavements, proceedings, roller compacted concrete II (February 29-March 2, 1988, San Diego, CA, 1988, Edited by Kenneth D. Hansen and Leslie K. Guice), American Society of Civil Engineers (ASCE), New York, NY, USA, pp. 454-466.
12. Piggott, R. W., Roller compacted concrete pavements - a study of long term performance, RP366.01P, Portland Cement Association, Skokie, IL, USA, 62 pages, 1999.
13. Liu, T. C., Performance of Roller Compacted Concrete – Corps of Engineers’ Experience,‖ ACI Special Publication SP-126, Durability of Concrete, Second International CANMET/ACI Conference, Vol. II, 1991, pp. 155-167.
14. Frost resistance of roller compacted concrete in airport runway subjected to ethylene glycol solution10.1108/ACMM-03-2018-1916 ↗
15. LaHucik, J. R, Roesler, J. R. Material constituents and proportioning for roller compacted concrete mechanical properties, 2018.
16. Laboratory-Made RCC containing Dry Bottom Ash: Part I - Mechanical Properties
17. Assessing the effects of supplementary cementitious materials on the performance of low-cement roller compacted concrete pavement10.1016/j.conbuildmat.2010.06.003 ↗
18. Effects of density and mixture proportions on freeze-thaw durability of roller-compacted concrete pavement
19. Freeze–thaw resistance and transport properties of high-volume fly ash roller compacted concrete designed by maximum density method10.1016/j.cemconcomp.2013.01.009 ↗
20. Influences of mixture composition on properties and freeze–thaw resistance of RCC10.1016/j.conbuildmat.2010.06.023 ↗
21. Freeze-thaw resistance and water permeability properties of roller compacted concrete produced with macro synthetic fibre10.1016/j.conbuildmat.2019.117382 ↗
22. The mechanical property and frost resistance of roller compacted concrete by mixing silica fume and limestone powder: Experimental study
23. The effects of compaction methods and mix parameters on the properties of roller compacted concrete mixtures10.1016/j.conbuildmat.2019.116807 ↗
24. ASTM C150. Standard specification for Portland cements. American society for testing and materials. West Conshohocken, PA: ASTM International; 2003.
25. Khayat, K. H. and Nicolas Ali Libre Roller compacted concrete: field evaluation and mixture optimization. 2014.
26. ASTM C1170 (2010). Standard Test Method for Determining Consistency and Density of Roller-Compacted Concrete Using a Vibrating Table. West Conshohocken, PA: ASTM International; 2014.
27. ASTM C39 (2010), Standard Test Method for Compressive Strength of Cylindrical Concrete Specimens, American Society of Testing and Materials, West Conshohocken, PA.
28. ASTM C469 (2010), Standard Test Method for Static Modulus of Elasticity and Poisson’s Ratio of Concrete in Compression, American Society of Testing and Materials, West Conshohocken, PA.
29. AASHTO T358-19.Standard Method of Test for Surface Resistivity Indication of Concrete’s Ability to Resist Chloride Ion Penetration. 2019.
30. ASTM C 457, Microscopic Determination of Air-Void Content and Parameters of the Air-Void System in Hardened Concrete, 2016.
31. ASTM C496/C496M. Standard Test Method for Splitting Tensile Strength of Cylindrical Concrete Specimens. 2017.
32. ASTM C 666/C666M-03. Standard test method for resistance of concrete to rapid freezing and thawing. Annual book of ASTM Standards. Philadelphia, PA, USA: American Society for Testing and Materials; 2008.
33. [33] ASTM C 642, Standard test method for density, absorption, and voids in hardened concrete, in: Annual Book of ASTM Standards, vol. 04.02, American Society for Testing and Materials,Philadelphia, 2002.
34. ASTM C672/C672M-12 Standard Test Method for Scaling Resistance of Concrete Surfaces Exposed to Deicing Chemicals, 2012.
35. Highways, Missouri, and Transportation Commission, 2004. Missouri Standard Specifications for Highway Construction, 2004. Missouri Highways and Transportation Commission.
36. Amer, N., N. Delatte, and C. Storey. Using Gyratory Compaction to Investigate Density and Mechanical Properties of Roller-Compacted Concrete. In Transportation Research Record: Journal of the Transportation Research Board, No. 1834, Transportation Research Board of the National Academies, Washington, D.C., 2003, pp. 77–84.10.3141/1834-10 ↗
37. Effect of circulating fluidized bed combustion ash on the properties of roller compacted concrete pavement10.1016/j.cemconcomp.2013.10.001 ↗
38. Strength properties of high-volume fly ash roller compacted and workable concrete, and influence of curing condition10.1016/j.cemconres.2004.07.037 ↗
39. CEB-FIP. Diagnosis and assessment of concrete structures – state of art report. CEB Bull 1989;192:83-85.