journal article·2021-03

Investigating binder aging during hot in-place recycling (HIR) of asphalt pavement

Haobai Zhong, Weidong Huang, Chuanqi Yan, Yuan Zhang, Quan Lv, Lijun Sun, Liyuan Liu

Publisher page

Abstract

Abstract Hot in-place recycling (HIR) is considered as an effective way to reuse reclaimed asphalt pavement (RAP). Heating pavement is the core technology of HIR. To ensure construction workability, the pavement should be heated and held at a relatively high temperature. However, the high heating temperature of HIR may cause significant aging on the SBS modified asphalt, which is usually used in the pavement. The objective of this study is to understand the aging behavior of SBS modified asphalt in HIR and provide appropriate guidance for future HIR projects. In this research, eight kinds of asphalt binder samples were collected and extracted from different stages of a practical HIR project. They were then tested in terms of the chemical and rheological properties. The rheological properties of asphalt are evaluated by the frequency sweep testing and Multiple Stress Creep Recovery (MSCR) testing using the Dynamic Shear Rheometer (DSR). The chemical evolution during FTIR was tracked from Fourier Transform Infrared (FTIR) spectra and Gel Permeation Chromatography (GPC). The results of the experiments showed that the influence of long-term aging is quite significant and untreated pavement exhibits much lower elastic recovery due to the degradation of SBS polymer. HIR did cause some extent of extra aging to the treated pavement, Compared with Untreated, the Carbonyl index and molecular weight ratio of polymer of Heated (#3) are reduced by 34% and 39% respectively. The effect of heating gradient between different pavement depths is noticeable. The modulus of Surface is 2.69 times that of Bottom. The PB index of Surface is 0.37 times that of Bottom. There is no noticeable chemical reaction between the rejuvenator and the aged asphalt. After adding rejuvenator, the modulus of pavement decreased by 55%.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Asphalt Pavement Performance Evaluation · Infrastructure Maintenance and Monitoring · Innovative concrete reinforcement materials

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (33)

Show source-provided references
1. A comparative study on asphalt binder and mixture performance of two traffic lanes during hot in-place recycling (HIR) procedure10.1016/j.conbuildmat.2019.06.201 ↗
2. Impacts of hot in-place recycling techniques in Pakistan
3. Hot in-place recycling of porous asphalt concrete
4. H. Ozer, P. Singhvi, R. Yang, I.L. Al-Qadi, I. Abuawad, A sustainability evaluation of hot-in-place asphalt recycling technique, 8th International Conference on Maintenance and Rehabilitation of Pavements, MAIREPAV 2016, Research Publishing Services, 2016, pp. 736-745.10.3850/978-981-11-0449-7-131-cd ↗
5. A comparison of rejuvenator and sryrene–butadiene rubber latex used in hot in-place recycling10.1080/14680629.2016.1142465 ↗
6. Cold recycling of reclaimed asphalt pavement towards improved engineering performance10.1016/j.jclepro.2017.10.132 ↗
7. Environmental burden evaluation of hot in-place recycling of asphalt pavement based on discrete event simulation10.1016/j.trd.2018.08.012 ↗
8. Performance of hot in-place recycled Superpave mixtures in Florida10.1016/j.conbuildmat.2013.08.043 ↗
9. Basic asphalt recycling manual
10. Brock · 1994 · 6
11. M. Makowska, E. Huuskonen-Snicker, P. Alanaatu, K. Aromaa, A. Savarnya, T. Pellinen, A. Das, Iop, Incorporating the transverse profile of the wearing course into the control of the hot in-place recycling of asphalt concrete, Resilient and Safe Road Infrastructure2018.10.1088/1757-899X/356/1/012019 ↗
12. Laboratory Evaluation of Microwave Heating Method for Hot In-Place Recycling
13. Heating Temperature Control for Hot In-Place Recycling of SMA Asphalt Pavement
14. Progress in Hot-In-Place Recycling Technology
15. Laboratory Evaluation of Microwave Heating Method for Hot In-Place Recycling
16. Aging of asphalt binder in hot pavement rehabilitation10.1016/j.conbuildmat.2018.07.216 ↗
17. Investigation of rutting performance of asphalt mixtures containing polymer modifiers10.1016/j.conbuildmat.2005.08.014 ↗
18. Polymer modified asphalt binders10.1016/j.conbuildmat.2005.07.007 ↗
19. Polymer modification of bitumen: Advances and challenges10.1016/j.eurpolymj.2014.02.005 ↗
20. Codrin · 2005
21. Aging behaviour and mechanism of SBS-modified asphalt10.1520/JTE20120150 ↗
22. Improving the aging resistance of styrene–butadiene–styrene tri-block copolymer modified asphalt by addition of antioxidants10.1016/j.polymdegradstab.2005.06.009 ↗
23. Relations between thermal degradations of SBS copolymer and asphalt substrate in polymer modified asphalt10.1007/s10098-010-0301-9 ↗
24. Rheological performance of aged polymer modified bitumens
25. Harrigan · 1994
26. Investigation of original and in-service asphalt properties for the development of improved specifications-final phase of testing and analysis
27. Investigation of reclaimed asphalt pavement blending efficiency through GPC and FTIR10.1016/j.conbuildmat.2013.10.003 ↗
28. C. Daranga, Characterization of aged polymer modified asphalt cements for recycling purposes, (2005).
29. Asphalt mixtures containing RAS and/or RAP: relationships amongst binder composition analysis and mixture intermediate temperature cracking performance10.1080/14680629.2016.1266758 ↗
30. Implementation of GPC characterization of asphalt binders at Louisiana materials laboratory
31. Rheological Examination of Aging in Polymer-Modified Asphalt10.1061/(ASCE)MT.1943-5533.0001370 ↗
32. Rheological, chemical and aging characteristics of high content polymer modified asphalt10.1016/j.conbuildmat.2019.02.086 ↗
33. Chemical and rheological evaluation of aging properties of high content SBS polymer modified asphalt10.1016/j.fuel.2019.04.022 ↗