Effect of flue gas desulfurization gypsum addition on critical chloride content for rebar corrosion in fly ash concrete
Source abstract
Abstract
Abstract The effect of flue gas desulfurization (FGD) gypsum addition on the critical chloride content (Ccrit) for rebar depassivation in fly ash concrete was studied. Open circuit potential and electrochemical impedance spectroscopy were employed for measurements of corrosion potential and corrosion current density, respectively. The results demonstrate that adding FGD gypsum decreases the Ccrit. Evolutions of corrosion potential and corrosion current density are found to obey a 3-parameter Weibull distribution. XRD analyses indicate that adding FGD gypsum facilitates the formation of ettringite phase, which increases the solid volume of hydrates. MIP results demonstrate that adding FGD gypsum decreases the critical pore diameter, which restrains the chloride transport. The improved chloride resistance can counterbalance the negative effect induced by the lower Ccrit, consequently postponing the corrosion initiation.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Concrete and Cement Materials Research · Concrete Corrosion and Durability · Magnesium Oxide Properties and Applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (38)
Show source-provided references
1. Research on the incorporation of untreated flue gas desulfurization gypsum into magnesium oxysulfate cement10.1016/j.jclepro.2020.122497 ↗
2. Investigation the synergistic effects in quaternary binder containing red mud, blast furnace slag, steel slag and flue gas desulfurization gypsum based on artificial neural networks10.1016/j.jclepro.2020.122972 ↗
3. Water resistant blended cements containing flue-gas desulfurization gypsum, Portland cement and fly ash for structural applications10.1016/j.cemconcomp.2019.04.033 ↗
4. Study on the performance of FGD gypsum-metakaolin-cement composite cementitious system10.1016/j.conbuildmat.2016.09.134 ↗
5. Alternative calcium-sulfate-bearing materials as cement retarders: Part II. FGD gypsum10.1016/j.cemconres.2004.03.021 ↗
6. The synergistic effect of AFt enhancement and expansion in Portland cement-aluminate cement-FGD gypsum composite cementitious system10.1016/j.conbuildmat.2018.09.139 ↗
7. Development of green binder systems based on flue gas desulfurization gypsum and fly ash incorporating slag or steel slag powders10.1016/j.conbuildmat.2020.120275 ↗
8. Properties of mortars made by uncalcined FGD gypsum-fly ash-ground granulated blast furnace slag composite binder10.1016/j.wasman.2012.02.014 ↗
9. Improving properties of high-volume fly ash cement paste blended with β-hemihydrate from flue gas desulfurization gypsum10.1016/j.conbuildmat.2020.120494 ↗
10. Thermal treatment and utilization of flue gas desulphurization gypsum as an admixture in cement and concrete10.1016/j.conbuildmat.2007.04.001 ↗
11. Effect of limestone powder addition on threshold chloride concentration for steel corrosion in reinforced concrete10.1016/j.cemconres.2020.106018 ↗
12. Predicting the time to corrosion initiation in reinforced concrete structures exposed to chlorides10.1016/j.cemconres.2018.08.007 ↗
13. Critical chloride threshold values as a function of cement type and steel surface condition10.1016/j.cemconres.2020.106086 ↗
14. GB175-2007, Standard for Common Portland Cement, China Architecture and Building Press, Beijing, 2007 (in Chinese).
15. ASTM C618-17, Standard Specification for Coal Fly Ash and Raw or Calcined Natural Pozzolan for Use in Concrete, ASTM International, West Conshohocken, PA, 2017.
16. ASTM C876–91, Standard Test Method for Half-cell Potentials of Uncoated Reinforcing Steel in Concrete, (1991).
17. Experimental protocol to determine the chloride threshold value for corrosion in samples taken from reinforced concrete structures
18. Potential measurement to determine the chloride threshold concentration that initiates corrosion of reinforcing steel bar in slag concretes10.1617/s11527-013-0130-5 ↗
19. ASTM C1218, Standard Test Method for Water-Soluble Chloride in Mortar and Concrete, ASTM International, West Conshohocken, PA, 2017.
20. ASTM C1152, Standard Test Method for Acid-Soluble Chloride in Mortar and Concrete, ASTM International, West Conshohocken, PA, 2012.
21. Chloride induced reinforcement corrosion: Electrochemical monitoring of initiation stage and chloride threshold values10.1016/j.corsci.2011.01.025 ↗
22. Hall-cell potential measurements-Potential mapping on reinforced concrete structures10.1007/BF02481526 ↗
23. Corrosion monitoring of reinforced concrete structures - a review10.1016/S1452-3981(23)17049-0 ↗
24. Analysis of chloride threshold from laboratory and field experiments in marine atmosphere zone10.1016/j.conbuildmat.2014.01.052 ↗
25. Investigation on the effect of supplementary cementitious materials on the critical chloride threshold of steel in concrete10.1617/s11527-015-0778-0 ↗
26. Critical conditions for pit initiation and growth of austenitic stainless steels10.1016/j.corsci.2014.12.006 ↗
27. Rebar corrosion in coral aggregate concrete: Determination of chloride threshold by LPR10.1016/j.corsci.2019.108238 ↗
28. Critical chloride content in reinforced concrete - An updated review considering Chinese experience10.1016/j.cemconres.2018.11.020 ↗
29. The effect of carbonate and sulfate ions on chloride threshold level of reinforcement corrosion in mortar with/without fly ash10.1016/j.conbuildmat.2016.03.018 ↗
30. A statistical distribution function of wide applicability10.1115/1.4010337 ↗
31. Determination of chloride threshold initiating corrosion: A new set-up taking the localized aspect of corrosion into account10.1016/j.cemconres.2019.105825 ↗
32. Utilization of flue gas desulfurization gypsum as an activation agent for high-volume slag concrete10.1016/j.jclepro.2018.09.145 ↗
33. Pore structure and permeability of concrete with high volume of limestone powder addition10.1016/j.powtec.2018.07.054 ↗
34. Relationship between pore structure and chloride diffusion in cementitious materials10.1016/j.conbuildmat.2019.116868 ↗
35. The density of cement phases10.1016/j.cemconres.2009.06.005 ↗
36. Effects of Deoxyribonucleic acid on cement paste properties and chloride-induced corrosion of reinforcing steel in cement mortars10.1016/j.cemconcomp.2018.05.002 ↗
37. A holistic model for cement paste and concrete chloride diffusion coefficient10.1016/j.cemconres.2020.106049 ↗
38. Dependence of unsaturated chloride diffusion on the pore structure in cementitious materials10.1016/j.cemconres.2019.105919 ↗