Effect of high water salinity on the adhesion properties of model bitumen modified with a smart additive
Source abstract
Abstract
Abstract The interfacial behavior at the asphalt/salt solution is really important to understand and improve the road durability near sea areas or in zones where salt is added to avoid traffic problems (i.e. mountain areas in winter). Consequently, in an attempt to understand the problems, dynamic interfacial tensions between bitumen modified with selected additives and aqueous salt solutions were measured to simulate the effect of salinity on the adhesion properties of asphalt in sea areas. In addition, contact angle and boiling water tests were performed to understand better the salt effect. Three different surfactants were used in this work to obtain modified bitumen solutions: a cationic, a nonionic organosilane surfactant and a primary alkyl amine surfactant. Generally, the salt had a pejorative effect on the adhesion of the bitumen on the stones, but the presence of small amounts of organosilane surfactant looked likely to have the best performance and then it was also tested against different salt concentrations. All the dynamic interfacial results were studied and analyzed thanks to the Ward-Torday model and the Graham and Phillips approach, obtaining information about the interfacial properties of the asphalt/brine interface. Thanks to these results, the complex adhesion phenomena at the brine interface could be better understood with an improvement effect on the additives to be used to avoid the premature ageing of the road surfaces.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Asphalt Pavement Performance Evaluation · Petroleum Processing and Analysis · Enhanced Oil Recovery Techniques
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (46)
Show source-provided references
1. Impact of salt and freeze-thaw cycles on performance of asphalt mixtures in coastal frozen region of China10.1016/j.coldregions.2010.02.002 ↗
2. Effects of runway deicers on pavement materials and mixes: Comparison with road salt10.1061/(ASCE)0733-947X(2002)128:4(385) ↗
3. Effects of deicing salt solutions on physical properties of pavement concretes10.3141/2290-09 ↗
4. A.D. ASTM, Standard terminology relating to petroleum, petroleum products, and lubricants, in: for, A. S.; Materials, T. a., (Eds.) Annual Book of Standards, A.S.f.T.a. Materials, Philadelphia, PA, 2005.
5. Part 1: History and terminology
6. Interfacial behavior of asphaltenes10.1016/j.cis.2015.10.005 ↗
7. Oil/water-partitioning and interfacial behavior of naphthenic acids10.1081/DIS-120025547 ↗
8. Mass Transfer between crude oil and water. Part 1: effect of oil components10.1021/ef501751b ↗
9. P.C. Heimenz, R. Rajagopalan, Principles of Colloid and Surface Chemistry, 3rd ed., New York, 1997.
10. Interfacial tension of hydrocarbon plus water/brine systems under high pressure10.1021/je950259a ↗
11. Adsorption and surface tension of ionic surfactants at the air-water interface: review and evaluation of equilibrium models10.1016/S0927-7757(00)00706-8 ↗
12. Effect of salinity, resin, and asphaltene on the surface properties of acidic crude oil/smart water/rock system10.1021/ef5015692 ↗
13. Systematic study of the effect of electrolyte composition on interfacial tensions between surfactant solutions and crude oils10.1016/j.ces.2015.04.032 ↗
14. The influence of temperature, pressure, salinity, and surfactant concentration on the interfacial tension of the N-octane-water system10.1080/009864490510644 ↗
15. Influence of interaction between heavy oil components and petroleum sulfonate on the oil-water interfacial tension10.1080/01932690903167475 ↗
16. Studies on interfacial behavior and wettability change phenomena by ionic and nonionic surfactants in presence of alkalis and salt for enhanced oil recovery10.1016/j.apsusc.2016.03.024 ↗
17. Sweep efficiency improvement by alkaline flooding for pelican lake heavy oil
18. Interactions between acidic crude oil and alkali and their effects on enhanced oil recovery10.1021/ef101729f ↗
19. The effect of surfactant type on the rheology of ovalbumin layers at the air/water and oil/water interfaces10.1016/j.foodhyd.2012.03.012 ↗
20. An extensive laboratory investigation of the use of bio-oil modified bitumen in road construction10.1016/j.conbuildmat.2015.12.009 ↗
21. Role of a food grade additive in the high temperature performance of modified bitumens10.1016/j.colsurfa.2017.01.025 ↗
22. Investigation of the surface properties of polymeric soaps obtained by ring-opening polymerization of epoxidized soybean oil10.1002/app.27784 ↗
23. Effects of adhesion promoters on the contact angle of bitumen-aggregate interface10.1016/j.ijadhadh.2016.07.013 ↗
24. A.D. 96, Standard practice for effect of water on bituminous-coated aggregate using boiling water, 2005.
25. Interfacial tension measurements between oil fractions of a crude oil and aqueous solutions with different ionic composition and pH10.1080/01932691.2013.783618 ↗
26. Effect of aqueous phase ph on the dynamic interfacial tension of acidic crude oils and myristic acid in dodecane10.1080/01932691.2010.516416 ↗
27. S.S. Dukhin, G. Kretzschmer, R. Miller, Dynamics of Adsorption at Liquid Interfaces, first ed., vol. 1, Elsevier Science, Amsterdam, The Netherlands, 1995.
28. Crude oil/brine interfacial tensions
29. Aggregation behavior of two asphaltenic fractions in aromatic solvents10.1021/ef9802072 ↗
30. Investigation of asphaltene association with vapor pressure osmometry and interfacial tension measurements10.1021/ie000073r ↗
31. Molecular origins of heavy oil interfacial activity part 1: fundamental interfacial properties of asphaltenes derived from heavy crude oils and their correlation to chemical composition10.1021/ef0604240 ↗
32. Molecular origins of heavy crude oil interfacial activity part 2: fundamental interfacial properties of model naphthenic acids and naphthenic acids separated from heavy crude oils10.1021/ef060425s ↗
33. Influence of the salinity on the interfacial properties of a Brazilian crude oil-brine systems10.1016/j.fuel.2013.10.057 ↗
34. Thermodynamics of interfacial
35. Kinetics of surfactant adsorption at fluid/fluid interfaces: non-ionic surfactants10.1209/epl/i1996-00497-y ↗
36. Dynamic surface properties of asphaltenes and resins at the oil-air interface10.1006/jcis.2001.7566 ↗
37. Relaxation of asphaltenes at the toluene/water interface: diffusion exchange and surface rearrangement10.1080/00218460490477143 ↗
38. Protein adsorption at the oil/water interface: characterization of adsorption kinetics by dynamic interfacial tension measurements10.1016/S0301-4622(99)00082-4 ↗
39. Adsorption kinetics of asphaltenes at the oil-water interface and nanoaggregation in the bulk10.1021/la301423c ↗
40. Adsorption kinetics of asphaltenes at oil/water interface: Effects of concentration and temperature10.1016/j.fuel.2017.10.051 ↗
41. Hydroxypropylmethylcellulose surface activity at equilibrium and adsorption dynamics at the air-water and oil-water interfaces10.1016/j.foodhyd.2009.06.013 ↗
42. Rheological surface properties of commercial citrus pectins at different pH and concentration10.1016/j.lwt.2018.03.037 ↗
43. Proteins at liquid interfaces: III. Molecular structures of adsorbed films10.1016/0021-9797(79)90048-1 ↗
44. Comparative evaluation of warm mix asphalt containing high percentages of reclaimed asphalt pavement10.1016/j.conbuildmat.2013.03.010 ↗
45. Quantitative evaluation of organosilane-based adhesion promoter effect on bitumen-aggregate bond by contact angle test10.1016/j.ijadhadh.2016.10.015 ↗
46. Adhesion promoters in bituminous road materials: a review