journal article·2023-06Open access

Macro synthetic fiber pullout behavior in short- and long-term tests

Thais da S. Rocha, Daniel C.T. Cardoso, Luís A.G. Bitencourt Jr.

Abstract

The creep phenomenon in fiber-reinforced composites is particularly important when synthetic macro fibers are used. In addition to the low modulus of elasticity, the polymers used in fibers have pronounced viscoelastic behavior even at room temperature, which can lead to changes in the cracking control over time. The long-term fiber pullout response also results from fiber and interface creep contributions. To understand the above phenomena, pullout tests with short- and long-term loads were conducted on three types of polymeric macro fibers subject to different levels of long-term loads (20, 30, 40 and 50%). The results of the pullout tests were strongly dependent on the fiber configuration, surface corrugation and modulus of elasticity. Macro fibers with crimped surfaces and higher modulus of elasticity achieved higher bond stresses and lower creep deformations. The Burgers model was applied and showed a good agreement with the experimental creep curves, therefore consisting of a promising alternative for modeling long-term behavior. Microtomography and scanning electron microscopy images showed that a large portion of the strain in tension, under sustained load, can be attributed to the creep of the fiber itself, thus making it challenging to estimate the creep of this type of composite, given the considerable variability of fiber configurations.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Structural Behavior of Reinforced Concrete · Innovative concrete reinforcement materials · Mechanical Behavior of Composites

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (50)

Show source-provided references
1. Pull-out work of steel fibers from cementitious composites: analytical investigation10.1016/0958-9465(91)90030-L ↗
2. W.D. Callister Jr., Ciência e Engenharia de Materiais: Uma introdução, 2002.
3. Sprince · 2013 · 75
4. Effect of fiber types on creep behavior of concrete10.1016/j.conbuildmat.2015.12.149 ↗
5. Effects of Temperature and Stress on Creep Behavior of PP and Hybrid Fiber Reinforced Reactive Powder Concrete10.1186/s40069-019-0357-9 ↗
6. Creep mechanisms in precracked polypropylene and steel fiber-reinforced concrete10.1061/(ASCE)MT.1943-5533.0003775 ↗
7. Experimental analysis of time dependent phenomena and temperature effects on macro-synthetic fibre reinforced concretes in different loading conditions10.1016/j.conbuildmat.2022.126904 ↗
8. Tensile creep of concrete: study of its sensitivityto basic parameters
9. Time-dependent response of ECC: characterisation of creep and rate dependence10.1016/j.cemconres.2007.02.001 ↗
10. Creep rupture and viscoelastoplasticity of polypropylene10.1016/j.engfracmech.2010.05.010 ↗
11. Effect of sustained tensile loading on SHCC crack widths10.1016/j.cemconcomp.2012.11.009 ↗
12. Tensile creep of macro-synthetic fibre reinforced concrete (MSFRC) under uni-axial tensile loading10.1016/j.cemconcomp.2014.08.002 ↗
13. Pull-out response of macro synthetic fibre from concrete matrix: effect of loading rate and embedment length10.1016/j.conbuildmat.2016.12.160 ↗
14. R. Vrijdaghs, E. Verstrynge, L. Vandewalle, A two-phased and multi-scale finite element analysis of the tensile creep behavior of polypropylene fiber reinforced concrete, in: 857Computational Modelling of Concrete Structures – Meschke, Pichler & Rots (Eds, 2018: pp. 857–866.10.1201/9781315182964-100 ↗
15. Postcrack creep of polymeric fiber-reinforced concrete in flexure10.1016/S0008-8846(99)00228-8 ↗
16. Post-cracking behaviour of steel and macro-synthetic fibre-reinforced concretes10.1016/j.conbuildmat.2010.12.022 ↗
17. Creep behaviour of cracked steel and macro-synthetic fibre reinforced concrete10.1617/s11527-015-0727-y ↗
18. Testing and modelling the creep of cracked macro-synthetic fibre reinforced concrete (MSFRC) under flexural loading10.1617/s11527-016-0795-7 ↗
19. The need to consider flexural post-cracking creep behavior of macro-synthetic fiber reinforced concrete10.1016/j.conbuildmat.2017.05.166 ↗
20. Time-dependent deformation and cracking behaviour of FRC beams10.1016/j.engstruct.2022.114741 ↗
21. Short-term and creep pull-out behavior of polypropylene macrofibers at varying embedded lengths and angles from a concrete matrix10.1016/j.conbuildmat.2017.05.005 ↗
22. Pull-out creep mechanism of synthetic macro fibres under a sustained load10.1016/j.conbuildmat.2018.04.148 ↗
23. F.R. Souza, V.N. Lima, D.C.T. Cardoso, F.A. Silva, Experimental Study of Polyvinyl Alcohol (PVA) Fiber Reinforced Concrete under Cyclic Loading, in: CILAMCE-PANACM-2021 Proceedings of the XLII Ibero-Latin-American Congress on Computational Methods in Engineering and III Pan-American Congress on Computational Mechanics, ABMEC-IACM, 2021.
24. ABNT (Associação de Normas Técnicas), Agregados - Determinação da composição granulométrica - Método de ensaio. NBR 17054, Brazil, 2022.
25. ASTM · 2017
26. ABNT (Associação Brasileira de Normas Técnicas), Concreto - Determinação da consistência pelo abatimento do tronco de cone, São Paulo, SP, 2020.
27. ASTM, Standard Test Method for Slump of Hydraulic-Cement Concrete, West Conshohocken, PA, 2015.
28. ABNT (Associação Brasileira de Normas Técnicas), Cimento Portland - Determinação da resistência à compressão de corpos de prova cilíndricos, Brazil, 2019.
29. ASTM · 2021
30. ABNT (Associação Brasileira de Normas Técnicas), Concreto endurecido - Determinação dos módulos de elasticidade e de deformação - Parte 1: Módulos estáticos à compressão, Brazil, 2021.
31. European Standard (EN), Testing hardened concrete Determination of secant modulus of elasticity in compression, United Kingdom, 2021.
32. Fiji: An open-source platform for biological-image analysis10.1038/nmeth.2019 ↗
33. Elasto Plastic Concrete®, “BarChip 54 – Concrete Fibre Reinforcement”, PS54_2021_2 Product Data Sheet (PDS)., 2021. https://barchip.com/wp-content/uploads/2021/07/PDS_BarChip54_web.pdf (accessed April 1, 2023).
34. Normet Construction Chemicals, “TamFib SP54 – Structural Polymer Macro Fibres for Reinforcing Concrete”, V3WW18 – 2018.5.22, Technical Data Sheet, 2018. https://www.normet.com/wp-content/uploads/2019/11/TamFib-SP-TDS-Global-20180524.pdf (accessed April 1, 2023).
35. Euclid Chemical, “TUF-STRANDTM SF”, 03 24 00, Technical Data Sheet., 2023. https://www.euclidchemical.com/fileshare/ProductFiles/TDS/Tuf_Strand_SF.pdf (accessed April 1, 2023).
36. Bentur · 2007
37. ZEISS Group, Scout-and-Scan Instrument Control System [Computer program], version 14.0.14829, (2014). https://www.zeiss.com/microscopy/us/l/campaigns/scout-and-scan.html (accessed April 1, 2023).
38. Object Research Systems (ORS) Inc, Dragonfly 2020.2 [Computer software], (2022). http://www.theobjects.com/dragonfly (accessed April 1, 2023).
39. Iterative non-local means filter for salt and pepper noise removal10.1016/j.jvcir.2016.03.024 ↗
40. Enhanced bonding of low modulus polymer fibers-cement matrix by means of crimped geometry10.1016/S0008-8846(97)00088-4 ↗
41. Treatments of polypropylene fibres to optimize their reinforcing efficiency in cement composites10.1016/0958-9465(92)90026-R ↗
42. Pullout behavior of polypropylene fibers from cementitious matrix10.1016/j.cemconres.2004.02.014 ↗
43. Effect of inclining angle, bundling and surface treatment on synthetic fibre pull-out from a cement matrix10.1016/0010-4361(90)90005-H ↗
44. A study of some factors affecting the fiber-matrix bond in steel fiber reinforced concrete10.1139/l90-069 ↗
45. R. de S. Castoldi, L.M.S. de Souza, F. de Andrade Silva, Comparative study on the mechanical behavior and durability of polypropylene and sisal fiber reinforced concretes, Constr Build Mater. 211 (2019). 10.1016/j.conbuildmat.2019.03.282.10.1016/j.conbuildmat.2019.03.282 ↗
46. Monteiro · 2020
47. Effect of fiber length and placement method on flexural behavior, tension-softening curve, and fiber distribution characteristics of UHPFRC10.1016/j.conbuildmat.2014.04.007 ↗
48. Crack bridging in fiber reinforced cementitious composites with slip-hardening interfaces10.1016/S0022-5096(96)00095-6 ↗
49. Pullout behavior of inclined steel fiber in an ultra-high strength cementitious matrix10.1016/j.conbuildmat.2010.03.009 ↗
50. P.A. Krahl, G. de Miranda Saleme Gidrão, R.B. Neto, R. Carrazedo, Effect of curing age on pullout behavior of aligned and inclined steel fibers embedded in UHPFRC, Constr. Build. Mater. 266 (2021). 10.1016/j.conbuildmat.2020.121188.10.1016/j.conbuildmat.2020.121188 ↗