journal article·1992-05-01

Factors Controlling the Amount of Corrosion for Cracking in Reinforced Concrete

M.L. Allan, B.W. Cherry

Corrosion· Volume 48· Issue 5
Publisher page

Abstract

Some of the factors that control the pressure due to the formation of corrosion products to cause failure of reinforced concrete were determined experimentally. The failure pressure is controlled predominantly by the toughness of the cover concrete and the bar/concrete interface and the size of air voids and microcracks. Failure pressure is not directly controlled by mix proportions.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Concrete Corrosion and Durability · Concrete and Cement Materials Research · Concrete Properties and Behavior

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

*Energy Efficiency and Conservation Division, Dept. of Applied Science, Brookhaven National Laboratory, Upton, New York.

**Materials Engineering, Monash University, Clayton, Victoria, Australia.

References (5)

Show source-provided references
1. Mechanical Simulation of Corrosion Induced Cracking in Reinforced Concrete
2. Failure Mechanisms for Corroding Reinforced Concrete
3. Broek · 1986
4. Mendenhall · 1986
5. Bazant · Journal of the Structural Division, Proc. of the American Society of Civil Engineers · 1979 · 105 · 1137