Effect of Anodic Polarization on the Susceptibility of AA6111 Automotive Sheet to Stress Corrosion Cracking
Source abstract
Abstract
AA6xxx Al-Mg-Si-Cu alloys are increasingly used to meet lightweight objectives in automotive applications given their high strength-to-weight ratio. However, their use in conjunction with steels and carbon fiber-reinforced polymers in these applications will result in galvanic coupling that may be deleterious to the Al alloy. As such, the ability of anodic polarization to induce stress corrosion cracking (SCC) in AA6xxx, an alloy typically considered SCC-resistant, is explored. In this study, fracture mechanics-based testing under full immersion in 0.6 M NaCl was used to quantify the threshold stress intensity above which SCC can occur (KTH) and stage II SCC crack growth rate (da/dtII) as a function of applied potential at and above the freely corroding potential. Under freely corroding conditions and potentials applied within the range observed for the freely corroding potential, no SCC was observed as results matched those gathered in the air (i.e., KTH was equivalent to the measured fracture toughness). When applying potentials anodic to the freely corroding potential (greater than −706 mVSCE), a decrease in KTH and an increase in da/dtII was observed. Crack growth rates measured under anodic polarizations were slowed through the reapplication of the freely corroding potential. These data imply that galvanic coupling may have the capacity to induce severe SCC in AA6111.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Aluminum Alloy Microstructure Properties · Non-Destructive Testing Techniques · Advanced Welding Techniques Analysis
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
*Fontana Corrosion Center, Department of Materials Science and Engineering, The Ohio State University, Columbus, Ohio 43210.
**Coatings and Surfaces Research, Ford Research and Advanced Engineering, Ford Motor Company, Dearborn, Michigan 48124.
References (93)
Show source-provided references
1. Polmear · 2017
2. Murtha · SAE Trans. · 1995 · 104 · 657
3. An Optimized Aluminum Alloy (X6111) for Auto Body Sheet Applications
4. Issues and Trends in Automotive Aluminum Sheet Forming10.4271/930277 ↗
5. Hatch · 1989
6. Troeger · Mater. Sci. Eng. A · 2000 · 277 · 10210.1016/S0921-5093(99)00543-2 ↗
7. Alloy Designation, Processing, and Use of AA6xxx Series Aluminum Alloys
8. Miao · Scr. Mater. · 1999 · 40 · 87310.1016/S1359-6462(99)00046-9 ↗
9. Marioara · Metall. Mater. Trans. A · 2014 · 45 · 293810.1007/s11661-014-2250-0 ↗
10. Braun · Mater. Charact. · 2006 · 56 · 8510.1016/j.matchar.2005.03.006 ↗
11. Gracio · Int. J. Plast. · 2004 · 20 · 42710.1016/S0749-6419(03)00095-0 ↗
12. Mrówka-Nowotnik · Inżynieria Mater. · 2007 · 28 · 449
13. Bjurenstedt · Acta Mater. · 2017 · 130 · 110.1016/j.actamat.2017.03.026 ↗
14. Corrosion Behavior of Automotive Al-Mg-Si Alloys and Assessment of the Ability of Accelerated Corrosion Tests to Predict on-Road Corrosion of These Alloys
15. Birbilis · J. Electrochem. Soc. · 2005 · 152 · B14010.1149/1.1869984 ↗
16. Birbilis · J. Electrochem. Soc. · 2008 · 155 · C11710.1149/1.2829897 ↗
17. Birbilis · J. Electrochem. Soc. · 2008 · 155 · C11710.1149/1.2829897 ↗
18. Kairy · Corrosion · 2015 · 71 · 130410.5006/1840 ↗
19. Kairy · Corrosion · 2016 · 73 · 8710.5006/2249 ↗
20. Kairy · Corrosion · 2017 · 73 · 128010.5006/2506 ↗
21. Zou · Appl. Surf. Sci. · 2017 · 405 · 48910.1016/j.apsusc.2017.02.045 ↗
22. Larsen · J. Electrochem. Soc. · 2010 · 157 · C6110.1149/1.3261804 ↗
23. Schnatterer · Surf. Interface Anal. · 2016 · 48 · 75010.1002/sia.5859 ↗
24. Svenningsen · Corros. Sci · 2006 · 48 · 22610.1016/j.corsci.2004.11.025 ↗
25. Svenningsen · Corros. Sci. · 2006 · 48 · 152810.1016/j.corsci.2005.05.045 ↗
26. Larsen · J. Electrochem. Soc. · 2008 · 155 · C55010.1149/1.2976774 ↗
27. Liu · Acta Mater. · 2007 · 55 · 35310.1016/j.actamat.2006.08.025 ↗
28. Zheng · Metals · 2017 · 7 · 38710.3390/met7100387 ↗
29. Bhattamishra · Mater. Des. · 1997 · 18 · 2510.1016/S0261-3069(97)00027-7 ↗
30. Zhang · Corros. Sci. · 2019 · 150 · 10010.1016/j.corsci.2019.01.030 ↗
31. Intergranular Corrosion of Extruded AA 6000-Series Model Alloys
32. Svenningsen · Corros. Sci. · 2006 · 48 · 25810.1016/j.corsci.2004.12.003 ↗
33. Shi · Corrosion · 2005 · 61 · 53410.5006/1.3278189 ↗
34. Kairy · Electrochim. Acta · 2016 · 190 · 9210.1016/j.electacta.2015.12.098 ↗
35. Liang · Corros. Sci. · 2013 · 76 · 11910.1016/j.corsci.2013.06.035 ↗
36. Zhan · Mater. Corros. · 2008 · 59 · 67010.1002/maco.200804110 ↗
37. Minoda · Metall. Mater. Trans. A · 2002 · 33 · 289110.1007/s11661-002-0274-3 ↗
38. Bloeck · Aluminium · 1994 · 70 · 87
39. Burleigh · Corrosion · 1995 · 51 · 5010.5006/1.3293577 ↗
40. Svenningsen · Corros. Sci. · 2006 · 48 · 396910.1016/j.corsci.2006.03.018 ↗
41. Larsen · Mater. Sci. Forum · 2006 · 519-521 · 66710.4028/www.scientific.net/MSF.519-521.667 ↗
42. Liang · Corros. Sci. · 2013 · 76 · 11910.1016/j.corsci.2013.06.035 ↗
43. Bloeck · Aluminium-Dusseldorf · 1994 · 70 · 87
44. Burleigh · Corrosion · 1995 · 51 · 5010.5006/1.3293577 ↗
45. Li · Corros. Sci. · 2016 · 107 · 11310.1016/j.corsci.2016.02.025 ↗
46. Characterization of 6111-like Aluminum Alloys Using Electrochemical Techniques and Electron Microscopy
47. Campbell · 200810.31399/asm.tb.emea.9781627082518 ↗
48. Adapala · Corrosion · 2022 · 78 · 59910.5006/4079 ↗
49. Jones · 1996
50. Braun · Materwiss. Werksttech. · 2007 · 38 · 67410.1002/mawe.200700204 ↗
51. Stress Corrosion Cracking of High Strength Aluminium Alloys
52. Braun · Mater. Corros. · 1994 · 45 · 25510.1002/maco.19940450502 ↗
53. Osaki · Mater. Trans. · 2006 · 47 · 112710.2320/matertrans.47.1127 ↗
54. Braun · 1998 · 153
55. Fundamental Aspects of Stress Corrosion Cracking
56. Braun · Int. J. Mater. Res. · 2010 · 101 · 65710.3139/146.110314 ↗
57. Standardization of Rising Load/Rising Displacement SCC Testing10.1520/STP10227S ↗
58. Dietzel · Mater. Sci. · 2001 · 37 · 26410.1023/A:1013214910345 ↗
59. Erlings · Corros. Sci. · 1987 · 27 · 115310.1016/0010-938X(87)90105-3 ↗
60. McMahon · Mater. Sci. Eng. A · 2019 · 767 · 13839910.1016/j.msea.2019.138399 ↗
61. The Effect of Applied Polarization on Stress Corrosion Cracking in Sensitized 5083
62. Czechowski · Adv. Mater. Sci. · 2007 · 7 · 8
63. Cooper · Mater. Sci. Forum · 2000 · 331-337 · 162510.4028/www.scientific.net/MSF.331-337.1625 ↗
64. Nguyen · Corrosion · 1982 · 38 · 31910.5006/1.3621692 ↗
65. The Correlation between Crack Chemistry and Crack Growth Behavior of 7xxx Series Aluminum Alloys: A Comparison of Field and Laboratory Tests10.5006/C1999-99153 ↗
66. Holroyd · 2013 · 1230
67. Crane · Corrosion · 2016 · 72 · 22110.5006/1766 ↗
68. Crane · Corrosion · 2016 · 72 · 24210.5006/1766 ↗
69. Stress Corrosion Cracking of Low Temperature Sensitized Aa5083
70. Standard Test Methods for Tension Testing of Metallic Materials
71. Novelis Advanz™ 6hs – S615
72. Standard Test Methods for Determining Average Grain Size
73. Bland · npj Mater. Degrad. · 2017 · 1 · 110.1038/s41529-017-0015-0 ↗
74. Standard Test Method for Measurement of Fatigue Crack Growth Rates
75. Direct Curret Potential Difference Fatigue Crack Growth Measurement Techniques
76. Standard Test Method for Determining Threshold Stress Intensity Factor for Environment-Assisted Cracking of Metallic Materials
77. Standard Practice for Slow Strain Rate Testing to Evaluate the Susceptibility of Metallic Materials to Environmentally Assisted Cracking
78. Standard Practice for Preparing, Cleaning, and Evaluating Corrosion Test Specimens
79. Standard Test Method for Kr Curve Determination
80. Standard Practice for Fracture Toughness Testing of Aluminum Alloys
81. Standard Test Method for Linear-Elastic Plane-Strain Fracture Toughness Kic of Metallic Materials
82. McCabe · 1972 · 449
83. Wei · J. Test. Eval. · 1987 · 15 · 3810.1520/JTE11550J ↗
84. Evaluation of the KISCC Testing Procedure by Round Robin Tests on Steels10.1520/STP23279S ↗
85. Warner · Int. J. Fatigue · 2012 · 42 · 3510.1016/j.ijfatigue.2011.04.013 ↗
86. Burleigh · Corrosion · 1991 · 47 · 8910.5006/1.3585235 ↗
87. Cooper · Corros. Sci. · 2007 · 49 · 263610.1016/j.corsci.2006.12.001 ↗
88. Urushino · Corros. Sci. · 1979 · 19 · 22510.1016/0010-938X(79)90008-8 ↗
89. Young · 1999
90. Use of Microelectrodes for Study of Stress Corrosion of Aluminum Alloys
91. Electrochemical Behavior within the SCC Cracks Aluminum Alloy LC-4
92. Edwards · 1983
93. Holroyd · 1983 · 112