journal article·2004-09

The effect of grain size on low-cycle fatigue behavior of Al-2024 polycrystalline alloy

A. Mohamed, Y. El-Madhoun, M. N. Bassim

Publisher page

Abstract

Two different sets of fatigue specimens were heat treated at different times or temperatures to investigate the effect of grain size on the low-cycle fatigue behavior of Al-2024 polycrystalline alloy. Strain-controlled low-cycle fatigue testing with a strain rate of 1×10−4 s−1 was conducted at room temperature. The fatigue response of the alloy was evaluated macroscopically in terms of cyclic stress strain response and microscopically in terms of appearance of cyclic slip bands. The cyclic stress strain response of Al-2024 polycrystalline alloy exhibited a definite plateau region where saturation stress remained constant with plastic strain. It was found that the smaller the grain size, the lower the saturation stress and the longer the plateau, whereas the larger the grain size, the higher the saturation stress and shorter the plateau (i.e., reverse grain size effect). Microscopic observations using scanning electron microscope revealed that persistent slip bands (PSBs) were observed at 45 deg orientations from the grain boundary. The volume fraction of PSBs was higher in small-grained Al-2024 polycrystalline alloy as compared to large-grained Al-2024 polycrystalline alloy.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Microstructure and mechanical properties · Aluminum Alloys Composites Properties · Aluminum Alloy Microstructure Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (10)

Show source-provided references
1. T. Takabashi, A. Koike, and K. Sasaki: J. Mater. Manufacturing (USA), 1998, vol. 107, pp. 454–61.
2. T.L. Johnston and C.E. Feltner: Metall. Trans., 1970, vol. 1, pp. 1161–67.10.1007/BF02900226 ↗
3. D.J. Morrison: Mater. Sci. Eng., 1994, vol. 187A, pp. 11–21.10.1016/0921-5093(94)90326-3 ↗
4. Deformation of Polycrystals: Mechanisms and Microstructures, Proc. 2nd Risø Int. Symp. on Metallurgy and Materials Science, H. Mughrabi, R. Wang, N. Hansen, A. Horsewell, T. Leffers, and H. Lilholt, eds., Risø National Laboratory, Roskilde, 1981, pp. 87–98.
5. L. Llanes; Ph.D. Dissertation, University of Pennsylvania, Philadelphia, PA, 1992.
6. Materials Science Monographs, Basic Mechanisms in Fatigue of Metals, H. Mughrabi, R. Wang, P. Lukas, and J. Polak, eds., Elsevier, Amsterdam, 1988, vol. 46, pp. 1–14.
7. K.V. Rasmussen and O.B. Pedersen: Acta Metall., 1980, vol. 28, pp. 1467–78.10.1016/0001-6160(80)90047-4 ↗
8. L. Llanes and C. Laird: Mater. Sci. Eng. A, 1990, vol. 128, pp. L9-L12.10.1016/0921-5093(90)90239-Y ↗
9. D.J. Morrison, V. Chopra, and J.W. Jones: Scripta Metall., 1991, vol. 25, pp. 1299–304.10.1016/0956-716X(91)90404-O ↗
10. Metals Handbook, Desk ed., ASM, Metals Park, OH, 1985.