journal article·2026-05Open access

Nanoscale competition between structure and chemistry governing corrosion in pseudo high-entropy amorphous alloys

D.D. Coimbrão, G.Y. Koga, G. Pedrino, V. Roche, J.-C. Lepretre, V. Martin, C. Bolfarini, F. Wang, A. Inoue, G. Zepon, W.J. Botta

Abstract

High-entropy (HE) Fe–Cr–B–based amorphous alloys are known to retain remarkable corrosion resistance even after the onset of crystallization, forming multicomponent bcc or bcc + fcc solid solutions without early boride precipitation. In the Mn-containing HE system (Fe 0.25 Co 0.25 Ni 0.25 Cr 0.125 Mn 0.125 ) 100-x B x (x = 9–13 at%), Mn enhances glass-forming ability, enabling high thermal stability and mechanically robust annealed states characterized by nanoscale mixtures of crystalline and residual amorphous phases. Here, we systematically investigate how nanoscale structure and local chemistry govern corrosion behavior across fully amorphous, partially crystallized, and fully crystalline states. Fully amorphous ribbons were produced by melt spinning for all compositions, followed by controlled annealing to induce crystallization. Electrochemical measurements in chloride-rich media (0.6 M NaCl) reveal that all amorphous alloys exhibit remarkable corrosion resistance, as demonstrated by potentiodynamic polarization and electrochemical impedance spectroscopy. X-ray photoelectron spectroscopy shows that this performance originates from a uniform, nanometric passive film composed of mixed Fe-, Co-, Ni-, Cr-, and Mn-derived oxides and hydroxides. In contrast, partial crystallization leads to a pronounced degradation in corrosion resistance, despite the absence of Cr-rich borides. This deterioration is traced to a chemistry-dominated nanoscale effect, in which Mn promotes the accumulation of deleterious Mn–O-rich species within the passive layer, while early-stage crystallization induces Cr partitioning and local depletion at crystal–matrix interfaces. These results demonstrate a transition from structure-dominated corrosion resistance in the amorphous state to chemistry-driven degradation upon crystallization in (Fe 0.25 Co 0.25 Ni 0.25 Cr 0.125 Mn 0.125 ) 100-x B x alloys, providing nanoscale insights that may guide the design of corrosion-resistant high-entropy alloys under similar conditions. • Fully amorphous Fe–Cr–Mn–B HE alloys exhibit excellent corrosion resistance in NaCl • Amorphous disorder stabilizes a uniform nanometric mixed-oxide passive film • Partial crystallization causes sharp corrosion degradation without boride formation • Mn–O enrichment and local Cr depletion destabilize passive films upon crystallization • Corrosion control shifts from structural disorder to nanoscale chemistry effects
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: High Entropy Alloys Studies · Metallic Glasses and Amorphous Alloys · High-Temperature Coating Behaviors

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (48)

Show source-provided references
1. Non-crystalline Structure in Solidified Gold-Silicon Alloys10.1038/187869b0 ↗
2. Thermal and magnetic properties of bulk Fe-based glassy alloys prepared by copper mold casting10.2320/matertrans1989.36.1427 ↗
3. Microstructural development in equiatomic multicomponent alloys10.1016/j.msea.2003.10.257 ↗
4. Nanostructured high-entropy alloys with multiple principal elements: novel alloy design concepts and outcomes10.1002/adem.200300567 ↗
5. A critical review of high entropy alloys and related concepts10.1016/j.actamat.2016.08.081 ↗
6. Recent development and application products of bulk glassy alloys✰10.1016/j.actamat.2010.11.027 ↗
7. Corrosion resistance of Fe-Cr-based amorphous alloys: An overview10.1016/j.jnoncrysol.2016.04.009 ↗
8. G.Y. Koga*, A.M. 3, Claudemiro Bolfarini, Claudio Shyinti Kiminami, W.J.B. 4 Jorge Jr., An overview of thermally sprayed Fe-Cr-Nb-B amorphous coatings – From the 2 alloy development to the coating’s performance against corrosion and wear, (n.d.).
9. Iron-rich High Entropy Alloys
10. Cost-Effective Fe-Rich High-Entropy Alloys: A Brief Review
11. Effect of molybdenum, manganese and tungsten contents on the corrosion behavior and hardness of iron-based metallic glasses10.1002/maco.201206740 ↗
12. Effects of Mn addition on the magnetic property and corrosion resistance of bulk amorphous steels10.1016/j.jallcom.2007.09.139 ↗
13. Effect of Mn content on corrosion and mechanical behaviors of Fe-based medium entropy alloy10.1016/j.jmrt.2024.04.246 ↗
14. Effect of manganese on mechanical properties and deformation mechanism of CoCrFeNi high entropy alloys
15. Corrosion resistance of Fe-Cr-based amorphous alloys: an overview10.1016/j.jnoncrysol.2016.04.009 ↗
16. Corrosion of high entropy alloys10.1038/s41529-017-0009-y ↗
17. Microstructural investigation of Fe-Cr-Nb-B amorphous/nanocrystalline coating produced by HVOF10.1016/j.matdes.2016.09.027 ↗
18. Optimization of mechanical and corrosion properties of plasma sprayed low-chromium containing Fe-based amorphous/nanocrystalline composite coating10.1016/j.surfcoat.2019.05.010 ↗
19. Wear behaviour of rapidly solidified Fe68Cr18Mo2B12 alloys10.1016/0043-1648(94)90281-X ↗
20. Production and corrosion resistance of thermally sprayed Fe-based amorphous coatings from mechanically milled feedstock powders10.1007/s11661-018-4785-y ↗
21. Characterization and corrosion resistance of boron-containing-austenitic stainless steels produced by rapid solidification techniques10.3390/ma11112189 ↗
22. Challenges in optimizing the resistance to corrosion and wear of amorphous Fe-Cr-Nb-B alloy containing crystalline phases10.1016/j.jnoncrysol.2020.120537 ↗
23. Mechanistic insight into the role of amorphicity and porosity on determining the corrosion mitigation behavior of Fe-based amorphous/nanocrystalline coating10.1016/j.jallcom.2020.156624 ↗
24. Crystallization, phase evolution and corrosion of Fe-based metallic glasses: an atomic-scale structural and chemical characterization study10.1016/j.actamat.2014.02.027 ↗
25. Corrosion properties of amorphous, partially, and fully crystallized Fe68Cr8Mo4Nb4B16 alloy10.1016/j.jallcom.2020.154123 ↗
26. High-entropy alloys: a critical review10.1080/21663831.2014.912690 ↗
27. Peculiarities and usefulness of multicomponent bulk metallic alloys10.1016/j.jallcom.2016.11.228 ↗
28. P. Morrell, 65 Metals and Alloys Ranked by Cost per Ounce, 〈Https://Kylarmack.Com/Blogs/News/65-Metals-and-Alloys-Ranked-by-Cost-per-Ounce〉 (2024).
29. Novel phase decomposition, good soft-magnetic and mechanical properties for high-entropy (Fe0.25Co0.25Ni0.25Cr0.125Mn0.125)100–B (x = 9–13) amorphous alloys10.1016/j.jallcom.2020.155917 ↗
30. New insights into the properties of high-manganese steel10.1007/s12613-020-2166-1 ↗
31. Effect of Mn content on crystallization behaviors and magnetic properties of FeCoNiBMn high-entropy amorphous alloys10.1016/j.jmrt.2024.01.052 ↗
32. Recent advancements in manganese steels – A review10.1016/j.matpr.2020.01.296 ↗
33. Why CoCrFeMnNi HEA could not passivate in chloride solution? – A novel strategy to significantly improve corrosion resistance of CoCrFeMnNi HEA by N-alloying10.1016/j.corsci.2022.110396 ↗
34. Near atomic-scale comparison of passive film on a 17 wt% Cr-added 18 wt% Mn steel with those on typical austenitic stainless steels10.1016/j.scriptamat.2021.114112 ↗
35. High entropy effect on structure and properties of (Fe,Co,Ni,Cr)-B amorphous alloys10.1016/j.jallcom.2016.11.223 ↗
36. Formation, thermal stability and mechanical properties of high entropy (Fe,Co,Ni,Cr,Mo)-B amorphous alloys10.1016/j.jallcom.2017.10.227 ↗
37. Formation, stability and ultrahigh strength of novel nanostructured alloys by partial crystallization of high-entropy (Fe 0.25 Co 0.25 Ni 0.25 Cr 0.125 Mo 0.125) 86-89 B 11-14 amorphous phase
38. Formation, structure and properties of pseudo-high entropy clustered bulk metallic glasses10.1016/j.jallcom.2019.153164 ↗
39. Corrosion resistance of pseudo-high entropy Fe-containing amorphous alloys in chloride-rich media10.1016/j.jallcom.2021.161090 ↗
40. Thermally sprayed multi-principal element Cr40Co40Ni20 coatings – Oxidation upon coatings’ build-up and electrochemical corrosion10.1016/j.surfcoat.2022.129154 ↗
41. Corrosion and wear resistant Cr40Co40Ni20 coatings produced by plasma transferred arc10.1016/j.surfcoat.2024.131693 ↗
42. Cr40Co40Ni20 multi-principal element alloy outperforms inconel 625: a passivation and corrosion resistance study in chloride media10.1149/1945-7111/adfe21 ↗
43. Crystallographic account of nano-scaled intergrowth of M2B-type borides in nickel-based superalloys10.1016/j.actamat.2014.01.002 ↗
44. Electrochemical impedance spectroscopy optimization on passive metals10.1149/2.0811608jes ↗
45. Measurement models for electrochemical impedance spectroscopy: i. demonstration of applicability10.1149/1.2069522 ↗
46. Microstructural evolution, electrochemical and corrosion properties of AlxCoCrFeNiTiy high entropy alloys10.1016/j.matdes.2019.107698 ↗
47. A surface study of the native oxide upon a compositionally complex alloy10.5006/2967 ↗
48. Influence of nitrogen and manganese on localized Corrosion behaviour of stainless steels in chloride environments10.1002/maco.19950461104 ↗