Corrosion Aging of Reinforced Concrete T-Girders Strengthened with Near-Surface-Mounted Composites
Source abstract
Abstract
This paper discusses the effect of corrosion aging on the flexural response of reinforced concrete (RC) T-girders strengthened with near-surface-mounted (NSM) composite reinforcement. The study comprised analytical modeling and experimental testing of 15 RC T-girders. Twelve girders were strengthened in flexure with either two or four NSM carbon-fiber-reinforced polymer composite strips, and three girders were not strengthened to act as benchmarks. In some girders, the NSM composite reinforcement was supplemented by intermittent U-shaped composite wraps along the beam span. Five girders were not corroded and 10 were subjected to accelerated corrosion aging for 30 and 100 days that corresponded to average measured tensile steel mass losses of 5 and 15%, respectively. Corrosion damage and cracking reduced the load capacity of the girders strengthened by NSM composites without U-wraps. The inclusion of U-wraps in the strengthening regime prevented premature peeling failure of the concrete cover. No reduction in the load capacity was recorded for the corroded girders strengthened with NSM composites combined with U-wraps. The residual load capacities of all strengthenedcorroded girders were substantially higher than that of the control girder. An analytical model was introduced that can predict the load capacity and failure mode of corroded T-girders strengthened with NSM composites. A comparison between the analytical and experimental results demonstrated the accuracy and validity of the model.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Structural Behavior of Reinforced Concrete · Concrete Corrosion and Durability · Structural Load-Bearing Analysis
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Associate Professor, United Arab Emirates Univ., P.O. Box 15551, Al Ain, United Arab Emirates; presently, on leave, Housing and Building National Research Center, Egypt (corresponding author).
M.Sc. Graduate, United Arab Emirates Univ., P.O. Box 15551, Al Ain, United Arab Emirates.
Professor, United Arab Emirates Univ., P.O. Box 15551, Al Ain, United Arab Emirates.
Professor, Ain Shams Univ., P.O. Box 11517, Cairo, Egypt.
References (22)
Show source-provided references
1. American Concrete Institute (ACI). (2008). “Building code requirements for structural concrete.” 318-08 Farmington Hills MI.
2. ASTM. (2011). “Standard practice for preparing cleaning and evaluating corrosion test specimens.” G1-03 West Conshohocken PA.
3. 10.1016/j.cemconcomp.2004.07.00410.1016/j.cemconcomp.2004.07.004 ↗
4. 10.1061/(ASCE)1090-0268(2008)12:2(149)10.1061/(ASCE)1090-0268(2008)12:2(149) ↗
5. Dalfré G. and Barros J. (2011). “Assessing the effectiveness of a NSM-CFRP flexural strengthening technique for continuous RC slabs by experimental research.” Proc. 1st Middle East Conf. on Smart Monitoring Assessment and Rehabilitation of Civil Structures EMPA Dubendorf Zurich.
6. 10.1016/j.compositesb.2006.08.00310.1016/j.compositesb.2006.08.003 ↗
7. Eligehausen R. · 1998 · 45
8. Near-surface-mounted fiber-reinforced polymer reinforcements for flexural strengthening of concrete structures
9. El-Maaddawy T. Bouchair A. Biddah A. and El-Dieb A. S. (2012). “Flexural behavior of concrete T-girders strengthened with NSM composite system.” Proc. 7th Asian Symp. on Polymers in Concrete Istanbul Technical Univ. Istanbul Turkey.
10. Long-term performance of corrosion-damaged reinforced concrete beams
11. 10.1061/(ASCE)1090-0268(2005)9:3(227)10.1061/(ASCE)1090-0268(2005)9:3(227) ↗
12. Fédération Internationale du Béton (fib). (2000). “Bond of reinforcement in concrete.” State-of-Art Rep. fib Lausanne Switzerland 427.
13. 10.1061/(ASCE)1090-0268(2003)7:3(248)10.1061/(ASCE)1090-0268(2003)7:3(248) ↗
14. 10.1061/(ASCE)CC.1943-5614.000013310.1061/(ASCE)CC.1943-5614.0000133 ↗
15. Concrete stress distribution in ultimate strength design
16. Strengthening of RC members using near-surface mounted FRP composites: Design overview
17. 10.1061/(ASCE)CC.1943-5614.000041110.1061/(ASCE)CC.1943-5614.0000411 ↗
18. 10.1016/S0141-0296(01)00105-510.1016/S0141-0296(01)00105-5 ↗
19. 10.1016/S0141-0296(01)00106-710.1016/S0141-0296(01)00106-7 ↗
20. Effect of reinforcing steel area loss on flexural behavior of reinforced concrete beams
21. 10.1061/(ASCE)CC.1943-5614.000045110.1061/(ASCE)CC.1943-5614.0000451 ↗
22. Flexural behavior of concrete beams strengthened with near-surface-mounted CFRP strips