journal article·2021-04

Asymptotic Analysis for Plane Stress Problems

Dan Givoli

Journal of Elasticity· Volume 144· Issue 1
Publisher page

Abstract

In this classroom note, the old and well-known plane-stress elastic class of problems is revisited, using an analysis technique which is different than that commonly found in the literature, and with a pedagogical benefit. An asymptotic analysis is applied to problems of thin linear elastic plates, made of a homogeneous and rather general anisotropic material, under the plane stress assumption. It is assumed that there are no body forces, that the boundary conditions are uniform over the thickness, and that the material (hence also the solution) is symmetric about the middle plane. The small parameter in this analysis is (epsilon =t/D) where (t) is the (uniform) thickness of the plate and (D) is a measure of its overall size. The goal of this analysis is to show how the three-dimensional (3D) problem of this type is reduced asymptotically to a sequence of essentially two-dimensional (2D) problems for a small (epsilon ). As expected, the leading problem in this sequence is shown to be the classical plane-stress problem. The solutions of the higher-order problems are corrections to the plane-stress solution. The analysis also shows that all six 3D compatibility equations are satisfied as (epsilon ) goes to zero, and that the error incurred by the plane stress assumption is (O(epsilon 2)). For the special case of an isotropic in-the-plane material, the second-order solution is shown to be the exact solution of the 3D problem, up to an (O(epsilon 2)) error in the close vicinity of the edge (which agrees with a well-known result for an isotropic material).
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Mechanical Behavior of Composites · Metal Forming Simulation Techniques · Structural Analysis and Optimization

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (16)

Show source-provided references
1. Timoshenko, S.P., Goodier, J.N.: Theory of Elasticity, 3rd edn. pp. 241–244. McGraw-Hill, New York (1970)
2. Love, A.E.H.: A Treatise on the Mathematical Theory of Elasticity, 4th edn. pp. 137–138. Cambridge (1927)
3. Sokolnikoff, I.S.: Mathematical Theory of Elasticity, 2nd edn. pp. 253–257. McGraw-Hill, New York (1956)
4. Filon, L.N.G.: On an approximate solution for the bending of a beam of rectangular cross-section under any system of load, with special reference to point of concentrated or discontinuous loading. Philos. Trans. R. Soc. Lond. Ser. A, Math. Phys. Sci. 201, 63–155 (1903)
5. Lekhnitskii, S.G.: Theory of Elasticity of an Anisotropic Body, English ed., pp. 139–143. Mir Publishers, Moscow (1981)
6. Wang, M.Z., Xu, B.X., Zhao, B.S.: On the generalized plane stress problem, the Gregory decomposition and the Filon mean method. J. Elast. 108, 1–28 (2012)10.1007/s10659-011-9352-3 ↗
7. Wang, M.Z., Xu, B.X., Gao, Y.: On the assumptions of the generalized plane stress problem and the Filon average. Acta Mech. 225, 1419–1427 (2014)10.1007/s00707-013-1036-6 ↗
8. Li, X.F., Hu, Z.L.: Generalization of plane stress and plane strain states to elastic plates of finite thickness. J. Elast. 140, 243–256 (2020)10.1007/s10659-020-09768-7 ↗
9. Bender, C.M., Orszag, S.A.: Advanced Mathematical Methods for Scientists and Engineers. Springer, New York (1999)10.1007/978-1-4757-3069-2 ↗
10. Bare, D.Z., Orlik, J., Panasenko, G.: Asymptotic dimension reduction of a Robin-type elasticity boundary value problem in thin beams. Appl. Anal. 93, 1217–1238 (2014)10.1080/00036811.2013.823481 ↗
11. Bare, D.Z., Orlik, J., Panasenko, G.: Non homogeneous Dirichlet conditions for an elastic beam: an asymptotic analysis. Appl. Anal. 95, 2625–2636 (2016)10.1080/00036811.2015.1105960 ↗
12. Nazarov, S.A., Slutskij, A.S.: Asymptotics of natural oscillations of a spatial junction of thin elastic rods. C. R., Méc. 344, 684–688 (2016)10.1016/j.crme.2016.04.001 ↗
13. Nazarov, S.A., Slutskij, A.S., Taskinen, J.: Asymptotic analysis of an elastic rod with rounded ends. Math. Methods Appl. Sci. 43, 6396–6415 (2020)10.1002/mma.6380 ↗
14. Baldelli, A.L., Bourdin, B.: On the asymptotic derivation of Winkler-type energies from 3D elasticity. J. Elast. 121, 275–301 (2015)10.1007/s10659-015-9528-3 ↗
15. Reddy, J.N., Miravete, A.: Practical Analysis of Composite Laminates. CRC Press, Boca Raton (1995)
16. Ansys® Academic Research Mechanical, Release 20.2, Help System, Basic Analysis Guide, ANSYS, Inc. (2020)