Preparation and electrical properties of 0.4Pb(Zn1/3Nb2/3)O3-0.6Pb(Zr0.4Ti0.6)O3 thin films by 2-step annealing method
Source abstract
Abstract
Films of (1−x)Pb(Zn1/3Nb2/3)O3-xPb(Zr0.4Ti0.6) O3 (x = 0.6, 40PZN-60PZT) were deposited on Pt/TiO2/ SiO2/Si substrate through spin coating. Using a combination of homogeneous precursor solution preparation and two-step pyrolysis process, we were able to obtain the 40PZN-60PZT thin films of perovskite phase virtually without pyrochlore phase precipitation after annealing above 650∘C. But since annealing done at the high temperatures for extended time can cause diffusion of Pt, TiO2 and Si, and precipitation of nonstoichiometric PbO, we adopted 2-step annealing method to circumvent these problems. The 2-step annealed films show dense microstructure than the 1-step films annealed at higher temperature. Furthermore, the root-mean-square surface roughness of 220 nm thick films which are annealed at 720∘C for 1 min and then annealed at 650∘C for 5 min was found to be 3.9 nm by atomic force microscopy as compared to the 12 nm surface roughness of the film annealed only at 720∘C for 5 min. The electrical properties of 2-step annealed films are virtually same and those of the 1-step annealed films annealed at high temperature. The film 2-step annealed at 720∘C for brief 1 min and with subsequent annealing at 650∘C for 5 min showed a saturated hysteresis loop at an applied voltage of 5 V with remanent polarization (P r) and coercive voltage (V c) of 25.3 μC/cm2 and 0.66 V respectively. The leakage current density was lower than 10−5A/cm2 at an applied voltage of 5 V.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Ferroelectric and Piezoelectric Materials · Microwave Dielectric Ceramics Synthesis · Multiferroics and related materials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (16)
Show source-provided references
1. G.A. Smolenskii, V.A. Bokov, V.A. Isupov, N.N. Krainik, R.E. Pasynkov, and A.I. Sokolov, Ferroelectrics and Related Materials (Gordon and Breach, New York, 1984) p. 763.
2. S.-E. Park and T.R. Shrout, J. Appl. Phys., 82, 1804 (1997).10.1063/1.365983 ↗
3. J. Kuwata, K. Uchino and S. Nomura, Jpn. J. Appl. Phys., 21, 1298 (1982).10.1143/JJAP.21.1298 ↗
4. J. Kuwata, K. Uchino, and S. Nomura, Ferroelectrics, 31, 579 (1981).10.1080/00150198108223490 ↗
5. Y. Yang, K. Kim, and H. Choi, Thin Sol. Flims, 396, 97 (2001).10.1016/S0040-6090(01)01236-6 ↗
6. Y. Kamisuki, T. Taniguchi, and T. Takenaka, Mic. Elec. Eng., 29, 169 (1995).10.1016/0167-9317(95)00137-9 ↗
7. A. Halliyal, U. Kumar, R.E. Newnham, and L.E. Cross, J. Am. Ceram. Soc., 66, 671 (1987).
8. D.H. Lee and N.-K. Kim, Mater. Lett., 34, 299 (1998).10.1016/S0167-577X(97)00185-7 ↗
9. X. Wang and H. Chen, Mat. Sci. Eng. B., B99, 36 (2003).10.1016/S0921-5107(02)00445-2 ↗
10. Y. Yoshikawa, J. Eur. Ceram. Soc., 19, 1037 (1999).10.1016/S0955-2219(98)00369-0 ↗
11. Z. Kighelman, D. Danjanovic, and N. Setter, J. Appl. Phys., 90, 4682 (2001).10.1063/1.1409573 ↗
12. A. Seifert, A. Vojita, J.S. Speck, and F.F. Lange, J. Mater. Res., 11, 1470 (1996).10.1557/JMR.1996.0183 ↗
13. I. Stolichnov, A. Tagantsev, N. Setter, J.S. Cross, and M. Tsukada, Appl. Phys. Lett., 74, 3552 (1999).10.1063/1.124158 ↗
14. N. Floquet, J. Hector, and P. Gaucher, J. Appl. Phys., 84, 3815 (1998).10.1063/1.368560 ↗
15. L. Zheng, C. Lin, and T.-P. Ma, J. Phys. D: Appl. Phys., 29, 457 (1996).10.1088/0022-3727/29/2/025 ↗
16. L. Zheng, C. Lin, W. Xu, and M. Okuyama, J. Phys. D: Appl. Phys., 29, 2020 (1996).10.1088/0022-3727/29/7/040 ↗