journal article·1974-02

A laser scan technique for electronic materials surface evaluation

D. R. Oswald, D. F. Munro

Journal of Electronic Materials· Volume 3· Issue 1
Publisher page

Abstract

No abstract is available for this record. The assistant can identify its topic from the title, but cannot infer the study’s results.

Source: Not provided · Quality: missing

Research context

OpenAlex topics: Surface Roughness and Optical Measurements · Industrial Vision Systems and Defect Detection · Electron and X-Ray Spectroscopy Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (12)

Show source-provided references
1. ASTM Document F154 72T, “Tentative Recommended Practices and Nomenclature for Identification of Structures and Contaminants Seen in Specular Silicon Surfaces.
2. Hughes 3 mw He-Ne laser, Hughes Electron Dynamics Division, Torrance, California.
3. G-320 Optical Scanner, General Scanning Inc., Watertown, Massachusetts.
4. Carl Meyer f/1.5, 135 mm telephoto lens.
5. 01LPX 041 lens from Optical Industries, Santa Ana, California.
6. SGD 100A photodiode from EG&G, Inc., Salem, Massachusetts. Each of the photodiodes is connected to an operational amplifier in a translmpedance configuration.
7. 03FNG 001 Neutral density filter from Optical Industries.
8. Velmex A2512C Unislide, Velmex, Inc., Holcomb, New York.
9. 611 Storage monitor, Tektronix, Inc., Beaverton, Oregon.
10. D. F. Munro, oral presentation at Bell OSA meeting, October 17–20, 1972, San Francisco, California.
11. See, for example,Introduction to Statistical Analyses by W. J. Dixon and F. J. Massey. For a defect count of N, this average uncertainty in the count will be √N. At 100 defects, √N/N × 100% = 10%; i.e., the reading will tend to fluctuate from about 90 to 110, but average out at 100.
12. 4601 Hard Copy Unit from Tektronix.