Residual Elastic Strains in Autofrettaged Tubes: Elastic–Ideally Plastic Model Analysis
Source abstract
Abstract
Autofrettage is a treatment process that uses plastic deformation to create a state of permanent residual stress within thick-walled tubes by pressurizing them beyond the elastic limit. The present paper presents explicit analytical formulas for residual elastic strains within the tube wall derived on the basis of the classical elastic–ideally plastic solution. Then the problem is addressed of rational interpretation of the radial and hoop residual elastic strains measured at a fixed number of points. To this end, the mismatch between the experimental measurements and theoretical predictions of the residual elastic strains is represented in the form of quadratic functional, J, the minimum of which is sought in terms of the problem parameters, namely, the material yield stress, σY, and the radial position of the elastic-plastic boundary, c. It is shown that J shows an approximately parabolic variation in terms of either parameter when the other is fixed, and that therefore the global minimum of J can be readily found. This procedure is implemented and applied to a set of experimental data on neutron diffraction measurements (Venter, A.M., de Swardt, R.R., and Kyriacou, S., 2000, J. Strain Anal., 35, pp. 459–469). In conclusion, further applications of this family of interpretation approaches are discussed.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Fatigue and fracture mechanics · Hydrogen embrittlement and corrosion behaviors in metals · High Temperature Alloys and Creep
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Department of Engineering Science, University of Oxford, Parks Road, Oxford OX1 3PJ, UK
References (12)
Show source-provided references
1. Lamé
2. Den Hartog
4. Soutas-Little
5. An Elasto-Plastic Analytical Solution for a Closed-End Thick-Walled Cylinder of a Strain Hardening Material
6. An Exact Elasto-Plastic Solution for an Open-Ended Thick-Walled Cylinder of a Strain-Hardening Material10.1016/0308-0161(92)90064-M ↗
7. Elasto-Plastic Analysis of an Internally Pressurized Thick-Walled Cylinder Using a Strain Gradient Plasticity Theory10.1016/S0020-7683(03)00424-4 ↗
8. Comparative Measurements on Autofrettaged Cylinders With Large Bauschinger Reverse Yielding Zones10.1243/0309324001514224 ↗
9. Der Nachweis Inner Spannungen in Stangen und Rohren
10. Measurement of Residual Hoop Stresses in Cylinders Using the Compliance Method10.1115/1.3225864 ↗
11. On the Modelling of Residual Stresses Due to Surface Peening Using Eigenstrain Distributions10.1243/030932405X30984 ↗
12. Synchrotron Measurement and Eigenstrain Modelling of Residual Stress in Machined Nickel Alloy Plates10.1243/03093247JSA135 ↗