journal article·2011-07-01

Coupling of Nanocavitation With Cyclic Deformation Behavior of High-Density Polyethylene Below the Yield Point

Kamel Hizoum, Yves Rémond, Stanislav Patlazhan

Publisher page

Abstract

The peculiarities of viscoelastic behavior of high-density polyethylene (HDPE) subjected to the uniaxial cyclic tensions and retractions below the yield point are studied. This required using three different deformation programs including (i) the successive increase in strain maximum of each cycle, (ii) the controlled upper and lower stress boundaries, and (iii) the fixed strain at the backtracking points. The experimental data are analyzed in a framework of the modified structure-sensitive model (Oshmyan et al., 2006, “Principles of Structural–Mechanical Modeling of Polymers and Composites,” Polym. Sci. Ser. A, 48, pp. 1004–1013) of semicrystalline polymers. It is supposed that increase in the interlamellar nanovoid volume fraction results in speeding-up the plastic flow rate while decreasing cavitation rate. Consequently, a proper fitting of the stress–strain cyclic diagrams is obtained for the applied deformation programs within the common set of model parameters. This makes it possible to reveal evolution of nanovoid volume fraction in HDPE during cyclic deformations.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Rheology and Fluid Dynamics Studies · Polymer crystallization and properties · Tribology and Wear Analysis

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Institute of Mechanics of Fluids and Solids UMR 7507 UdS/CNRS, 2 rue Boussingault, F-67000 Strasbourg, France; LTI, Public Research Centre Henri Tudor, 66, rue de Luxembourg, L-4221 Esch-Sur-Alzette, Luxembourg

Institute of Mechanics of Fluids and Solids UMR 7507 UdS/CNRS, 2 rue Boussingault, F-67000 Strasbourg, France

Semenov Institute of Chemical Physics of Russian Academy of Sciences, 4, Kosygin Street, 119991 Moscow, Russia

References (23)

Show source-provided references
1. Intrinsic Deformation Behavior of Semicrystalline Polymers10.1021/ma035279t ↗
2. A Constitutive Model for Predicting the Large Deformation Thermomechanical Behavior of Fluoropolymers10.1016/j.mechmat.2004.09.002 ↗
3. Model to Predict the Viscoelastic Response of a Semi-Crystalline Polymer Under Complex Cyclic Mechanical Loading and Unloading Conditions10.1007/s11043-007-9031-8 ↗
4. Cyclic Viscoplasticity of High-Density Polyethylene: Experiments and Modeling10.1016/j.commatsci.2006.07.014 ↗
5. An Assessment of Nonlinearly Viscoelastic Constitutive Models for Cyclic Loading: The Effect of a General Loading/Unloading Rule10.1007/s11043-006-9004-3 ↗
6. High-Temperature Mechanical Behavior of Semi-Crystalline Polymers and Relationship to a Rubber-Like “Relaxed” State10.1016/j.mechmat.2008.10.001 ↗
7. Network Stretching, Slip Processes, and Fragmentation of Crystallites During Uniaxial Drawing of Polyethylene and Related Copolymers. A Comparative Study10.1021/ma981776b ↗
8. A Molar Mass Induced Transition in the Yielding Properties of Linear Polyethylene10.1016/S0032-3861(03)00036-3 ↗
9. Network Stretching During Tensile Drawing of Polyethylene: A Study Using X-Ray Scattering and Microscopy10.1021/ma051726o ↗
10. Viscous-Force-Dominated Tensile Deformation Behavior of Oriented Polyethylene10.1021/ma052496g ↗
11. Structural−Mechanical Phase Diagram of Isotactic Polypropylene10.1021/ja063464r ↗
12. Effect of Chain Entanglements on Plastic Deformation Behavior of Linear Polyethylene10.1021/ma050815y ↗
13. Experimental Characterization of Deformation Damage in Solid Polymers Under Tension, and Its Interrelation With Necking10.1016/S0020-7683(02)00184-1 ↗
14. Characterization of Volume Strain at Large Deformation Under Uniaxial Tension in High-Density Polyethylene10.1016/j.polymer.2006.03.093 ↗
15. Plastic Deformation of Crystalline Polymers: The Role of Cavitation and Crystal Plasticity10.1021/ma050842o ↗
16. Cavitation During Tensile Deformation of High-Density Polyethylene10.1016/j.polymer.2006.12.054 ↗
17. Cavitation During Tensile Deformation of Polypropylene10.1021/ma0715122 ↗
18. Principles of Structural–Mechanical Modeling of Polymers and Composites10.1134/S0965545X06090173 ↗
19. Stress–Strain Behavior of High-Density Polyethylene Below the Yield Point: Effect of Unloading Rate10.1134/S0965545X08050040 ↗
20. A Pseudo-Elastic Model for the Mullins Effect in Filled Rubber10.1098/rspa.1999.0431 ↗
21. Simulation of Small-Strain Deformations of Semi-Crystalline Polymer: Coupling of Structural Transformations With Stress-Strain Response10.1023/B:JMSC.0000030709.19754.28 ↗
22. Rheology of Polypropylene in the Solid State10.1007/BF00356330 ↗
23. The Effect of Cyclic True Strain on the Morphology, Structure, and Relaxation Behavior of Ultra High Molecular Weight Polyethylene10.1016/S0032-3861(00)00626-1 ↗