journal article·2017-01-01Open access

Mechanical Properties of Gelcast Cerium Dioxide From 23 to 1500 °C

Stephen J. Sedler, Thomas R. Chase, Jane H. Davidson

Abstract

This work reports the elastic modulus and four-point flexural strength of a gelcast ceramic, cerium dioxide (ceria), with a microporosity of nominally 20% and a grain size of 11 μm from 23 to 1500 °C. The data augment the sparse data published for ceria and extend previous results by 150 °C. The ceria tested is representative of that constituting the ligaments of a reticulated porous ceramic. The elastic modulus decreases from 90 GPa at 23 °C to 16 GPa at 1500 °C. The flexural strength is 78 MPa below 900 °C and then decreases rapidly to 5 MPa at 1500 °C. These trends are consistent with data reported for other ceramics. Comparing the measured elastic modulus to prior data obtained for lower porosity shows the minimum solid area (MSA) model can be used to extend the modulus data to other porosities. Similarly, the flexural strength data agree with prior data when the effects of specimen size, porosity, and grain size are taken into account.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Chemical Looping and Thermochemical Processes · Nuclear materials and radiation effects · Catalytic Processes in Materials Science

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Department of Mechanical Engineering, University of Minnesota—Twin Cities, 111 Church Street SE, Minneapolis, MN 55455 e-mail:

Funding

National Science Foundation

References (77)

Show source-provided references
1. Automotive Exhaust Catalysis10.1016/S0021-9517(02)00067-2 ↗
2. 3D Flowerlike Ceria Micro/Nanocomposite Structure and Its Application for Water Treatment and CO Removal10.1021/cm062471b ↗
3. Enhanced Ceria—A Low-Temperature SOFC Electrolyte10.1016/0167-2738(92)90103-V ↗
4. Converting Ceria Polyhedral Nanoparticles into Single-Crystal Nanospheres10.1126/science.1125767 ↗
5. Rotary-Type Solar Reactor for Solar Hydrogen Production With Two-Step Water Splitting Process10.1021/ef060581z ↗
6. Final Report—Reimagining Liquid Transportation Fuels: Sunshine to Petrol
7. Design of a Solar Reactor to Split CO2 Via Isothermal Redox Cycling of Ceria10.1115/1.4028917 ↗
8. The Binary Lanthanide Oxides: Synthesis and Identification
9. A Thermochemical Study of Ceria: Exploiting an Old Material for New Modes of Energy Conversion and CO2 Mitigation10.1098/rsta.2010.0114 ↗
10. High-Flux Solar-Driven Thermochemical Dissociation of CO2 and H2O Using Nonstoichiometric Ceria10.1126/science.1197834 ↗
11. Syngas Production by Simultaneous Splitting of H2O and CO2 Via Ceria Redox Reactions in a High-Temperature Solar Reactor10.1039/C1EE02620H ↗
12. Thermochemical CO2 Splitting Via Redox Cycling of Ceria Reticulated Foam Structures With Dual-Scale Porosities10.1039/C4CP01172D ↗
13. Efficient Splitting of CO2 in an Isothermal Redox Cycle Based on Ceria10.1021/ef402492e ↗
14. A Thermodynamic Study of Nonstoichiometric Cerium Dioxide10.1016/0022-3697(75)90192-4 ↗
15. Solar Thermochemical CO2 Splitting Utilizing a Reticulated Porous Ceria Redox System10.1021/ef3013757 ↗
16. The Effects of Morphology on the Oxidation of Ceria by Water and Carbon Dioxide10.1115/1.4005119 ↗
17. Control of Heterogeneity in Nanostructured Ce1−xZrxO2 Binary Oxides for Enhanced Thermal Stability and Water Splitting Activity10.1021/jp2071315 ↗
18. Enhanced Oxidation Kinetics in Thermochemical Cycling of CeO2 Through Templated Porosity10.1021/jp309247c ↗
19. Ceria-Based Electrospun Fibers for Renewable Fuel Production Via Two-Step Thermal Redox Cycles for Carbon Dioxide Splitting10.1039/c4cp01974a ↗
20. Effect of Flow Rates on Operation of a Solar Thermochemical Reactor for Splitting CO2 Via the Isothermal Ceria Redox Cycle10.1115/1.4032019 ↗
21. Demonstration of a Solar Reactor for Carbon Dioxide Splitting Via the Isothermal Ceria Redox Cycle and Practical Implications10.1021/acs.energyfuels.6b01265 ↗
22. Ceramic Diesel Particulate Filters10.1111/j.1744-7402.2005.02044.x ↗
23. Heat Recirculation and Heat Transfer in Porous Burners10.1016/j.combustflame.2004.02.007 ↗
24. 45S5 Bioglass®-Derived Glass–Ceramic Scaffolds for Bone Tissue Engineering10.1016/j.biomaterials.2005.11.025 ↗
25. Transient Three-Dimensional Heat Transfer Model of a Solar Thermochemical Reactor for H2O and CO2 Splitting Via Nonstoichiometric Ceria Redox Cycling10.1115/1.4026465 ↗
26. The Elastic Modulus of Pure and Doped Ceria10.1016/j.scriptamat.2010.09.021 ↗
27. Elastic and Flow Properties of Dense, Pure Oxide Refractories10.1111/j.1151-2916.1951.tb13017.x ↗
28. Effect of Y2O3 Addition on the Conductivity and Elastic Modulus of (CeO2)1−x(YO1.5)x10.1016/j.ssi.2009.06.003 ↗
29. Effect of Rare-Earth Oxides on Fracture Properties of Ceria Ceramics10.1023/B:JMSC.0000040087.37727.cd ↗
30. Mechanical Properties of Pure and Doped Cerium Oxide10.1016/j.jeurceramsoc.2014.11.036 ↗
31. The Effect of Oxygen Vacancy Concentration on the Elastic Modulus of Fluorite-Structured Oxides10.1016/j.ssi.2006.11.003 ↗
32. Compilation of Mechanical Properties for the Structural Analysis of Solid Oxide Fuel Cell Stacks. Constitutive Materials of Anode-Supported Cells10.1016/j.ceramint.2012.01.043 ↗
33. Some Properties of Sintered Ceria Ceramics10.1007/BF01290299 ↗
34. The Origin of Elastic Anomalies in Thin Films of Oxygen Deficient Ceria, CeO2−x10.1016/j.ssi.2010.09.001 ↗
35. Effects of Reduction Treatment on Fracture Properties of Cerium Oxide10.1111/j.1551-2916.2007.01994.x ↗
36. Evaluation of Thin Film Ceria Membranes for Syngas Membrane Reactors—Preparation, Characterization and Testing10.1016/j.memsci.2010.12.012 ↗
37. Defect Equilibria and Chemical Expansion in Non-Stoichiometric Undoped and Gadolinium-Doped Cerium Oxide10.1016/j.electacta.2008.09.026 ↗
38. Defect Chemistry and Thermomechanical Properties of Ce0.8PrxTb0.2−xO2−δ10.1149/1.3270475 ↗
39. Oxygen Nonstoichiometry and Defect Chemistry Modeling of Ce0.8Pr0.2O2−δ10.1149/1.3288241 ↗
40. Standard Test Method for Flexural Strength of Advanced Ceramics at Elevated Temperatures
41. Gelcasting—A New Ceramic Forming Process
42. Method for Molding Ceramic Powders Using a Water-Based Gel Casting
43. SediGraph Technique10.1017/CBO9780511626142.013 ↗
44. 2008
45. 2011
46. 1977
47. Creep Behaviour of Membrane and Substrate Materials for Oxygen Separation Units10.1016/j.jeurceramsoc.2013.02.007 ↗
48. 1999
49. Evaluated Material Properties for a Sintered α-Alumina10.1111/j.1151-2916.1997.tb03074.x ↗
50. Method of Making Porous Ceramic Articles
51. Processing of Porous Ceramics
52. Improvement in the Strut Thickness of Reticulated Porous Ceramics10.1111/j.1151-2916.2001.tb00895.x ↗
53. Open-Cell, Low-Density Ceramics Fabricated From Reticulated Polymer Substrates10.1111/j.1551-2916.1987.tb00156.x ↗
54. 1873
55. 1997
56. The Mechanics of Three-Dimensional Cellular Materials10.1098/rspa.1982.0088 ↗
57. The Deformation of Foamed Elastic Materials10.1002/app.1959.070010117 ↗
58. The Prediction of the Tensile Properties of Flexible Foams10.1002/app.1971.070150314 ↗
59. Fracture Mechanics of Cellular Glass
60. Compressive Response of Open-Cell Foams. Part I: Morphology and Elastic Properties10.1016/j.ijsolstr.2004.07.023 ↗
61. Elastic Behavior of Open-Cell Alumina10.1111/j.1151-2916.1987.tb05632.x ↗
62. Mechanical Properties of Silicon Oxycarbide Ceramic Foams10.1111/j.1151-2916.2001.tb00996.x ↗
63. Influence of Slurry Characteristics on Porosity and Mechanical Properties of Alumina Foams10.1111/j.1744-7402.2006.02098.x ↗
64. Direct Least-squares Fitting of Algebraic Surfaces10.1145/37402.37420 ↗
65. Standard Test Methods for Determining Average Grain Size
66. The Porosity Dependence of Physical Properties of Materials: A Summary Review10.4028/www.scientific.net/KEM.115.1 ↗
67. Evaluation and Extension of Physical Property-Porosity Models Based on Minimum Solid Area10.1007/BF00355133 ↗
68. Comparison of Physical Property-Porosity Behaviour With Minimum Solid Area Models10.1007/BF00357860 ↗
69. Comparison of Different Experimental Techniques for Determination of Elastic Properties of Solids10.1016/j.msea.2003.09.080 ↗
70. A Statistical Distribution Function of Wide Applicability
71. Standard Practice for Reporting Uniaxial Strength Data and Estimating Weibull Distribution Parameters for Advanced Ceramics
72. Strength Degradation and Failure Limits of Dense and Porous Ceramic Membrane Materials10.1016/j.jeurceramsoc.2013.04.018 ↗
73. Weibull Strength Scaling for Standardized Rectangular Flexure Specimens10.1111/j.1151-2916.2003.tb03329.x ↗
74. The Deformation and Ageing of Mild Steel: III Discussion of Results10.1088/0370-1301/64/9/303 ↗
75. The Cleavage Strength of Polycrystals
76. Mechanical Properties in the Ceria-Zirconia System10.1016/0955-2219(92)90054-H ↗
77. Ceria–Lanthanum Strontium Manganite Composites for Use in Oxygen Generation Systems10.1016/S0167-2738(03)00006-7 ↗