journal article·1989-01-01

Temperature-Dependence of Multiaxial Non-Proportional Cyclic Behavior of Type 316 Stainless Steel

S. Murakami, M. Kawai, K. Aoki, Y. Ohmi

Publisher page

Abstract

Temperature dependence of multiaxial cyclic behavior of type 316 stainless steel was elucidated experimentally. Cyclic tests under constant total-strain amplitudes were performed for uniaxial tension-compression and circular (non-proportional) strain paths at several temperatures; room temperature, 200°C, 400°C, 500°C, 600°C, and 700°C. The strain amplitudes of the cycles were specified to be 0.2, 0.3, and 0.4 percent under constant strain rate of 0.2 percent per min. A quantitative discussion was made with special emphasis on the difference between material behavior under uniaxial tension-compression strain cycles and multiaxial non-proportional circular ones at these temperatures. The most significant cyclic hardening was observed in the temperature range between 400°C and 600°C for both the proportional and the non-proportional strain cycles. At these particular temperatures, much larger inelastic strain was accumulated until a cyclic stabilization was obtained. Though the effect of non-proportionality in the cyclic strain paths on the cyclic hardening was significant particularly at the temperature below 450°C, it rapdily decreased at higher temperatures.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Microstructure and Mechanical Properties of Steels · High-Velocity Impact and Material Behavior · Metallurgy and Material Forming

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Department of Mechanical Engineering, Nagoya University, Chikusa-ku, Nagoya 464-01, Japan

Institute of Engineering Mechanics, University of Tsukuba, Tsukuba 305, Japan

Nippon Steel Corporation, Hirohata-ku, Himeji 671-11, Japan

Toyota Motor Corporation, Toyota-cho, Toyota 471, Japan

References

Reference metadata was not supplied for this record.