journal article·2003-07-01Open access

The Computation and Measurement of Residual Stresses in Laser Deposited Layers

S. Finnie, W. Cheng, I. Finnie, J. M. Drezet, M. Gremaud

Abstract

Laser metal forming is an attractive process for rapid prototyping or the rebuilding of worn parts. However, large tensile stress may arise in layers deposited by laser melting of powder. A potential solution is to preheat the substrate before and during deposition of layers to introduce sufficient contraction during cooling in the substrate to modify the residual stress distribution in the deposited layers. To demonstrate the value of this approach, specimens were prepared by depositing stellite F on a stainless steel substrate with and without preheating. Residual stresses were computed by numerical simulation and measured using the crack compliance method. For non-preheated specimens simulation and experiment agreed well and showed that extremely high residual tensile stresses were present in the laser melted material. By contrast, pre-heated specimens show high compressive stresses in the clad material. However, in this case the numerical simulation and experimental measurement showed very different stress distribution. This is attributed to out of plane deformation due to the high compressive stresses which are not permitted in the numerical simulation. A “strength of materials” analysis of the effect of out of plane deformation was used to correct the simulation, Agreement with experimental results was then satisfactory.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Laser and Thermal Forming Techniques · Additive Manufacturing Materials and Processes · Tribology and Lubrication Engineering

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

145 W. 67th Street, Apt. 26D, New York, NY 10023

BEAR, Inc., 2216 5th Street, Berkeley, CA 94710

University of California, Berkeley, Dept. of Mech. Eng., Berkeley, CA 94720

CALCOM SA, PSE-EPFL. 1015 Lausanne, Switzerland

References (6)

Show source-provided references
1. Lu., J., ed., 1996, Handbook of Measurement of Residual Stress, Soc. for Exp. Mech. Inc., Fairmont Press, Lilburn, CA.
2. Cheng, W., and Finnie, I., 1985, “A Method for Measurement of Axisymmetric Residual Stresses in Circumferentially Welded Thin-Walled Cylinders,” ASME J. Eng. Mater. Technol., 106, pp. 131–185.10.1115/1.3225799 ↗
3. Cheng, W., and Finnie, I., 1994, “An Overview of the Crack Compliance Method for Residual Stress Measurement,” Proc. 4th Int. Conf. on Residual Stress, Soc. for Exp. Mech. Inc., Bethel CT, pp. 449–458.
4. Mason, J. C., 1984, Basic Matrix Methods, Butterworths & Co. (Publishers Ltd.).
5. Finnie, I., and Cheng, W., 1995, “Residual Stresses and Fracture Mechanics,” ASME J. Eng. Mater. Technol., 117, pp. 373–378.10.1115/1.2804728 ↗
6. Cheng, W., and Finnie, I., 1993, “A Comparison of the Strains Due to Edge Cracks and Cuts of Finite Width With Applications to Residual Stress Measurement,” ASME J. Eng. Mater. Technol., 115, pp. 220–226.10.1115/1.2904210 ↗