A New Model for Springback Prediction for Aluminum Sheet Forming
Source abstract
Abstract
A new model for springback, based on isotropic and kinematic hardening models, the Mroz multiple surfaces model, and observations from experimental data, is proposed in this paper. In this model, a material parameter (CM), which is significant after reverse yielding, is suggested to handle the Bauschinger effect. A simple, low-cost, multiple-bending experiment has been developed to determine CM for aluminum alloys AA6022-T4 and AA6111-T4. The new model fits available experimental results better than the isotropic and kinematic hardening models and the Mroz multiple surfaces model.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Metal Forming Simulation Techniques · Laser and Thermal Forming Techniques · Metallurgy and Material Forming
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Department of Mechanical Engineering, Northern Illinois University, DeKalb, IL 60115
Fellow ASME
Department of Mechanical Engineering, The Ohio State University,Columbus, OH 43210
References (16)
Show source-provided references
1. An Experimental Investigation of the Influence of the Bauschinger Effect on Springback Predictions10.1016/S0924-0136(00)00834-7 ↗
2. The Bauschinger Effect and Discontinuous Yielding10.1080/14786437208227444 ↗
3. A Review of Certain Aspects of the Bauschinger effect in Metals10.1016/0025-5416(79)90043-0 ↗
4. Analysis of The Bauschinger Effect10.1016/0001-6160(86)90220-8 ↗
5. Springback Analysis in Orthotrpic Sheet Metal Forming With An Elasto Plastic Formulation Using A Kinematic Hardening Model
6. Springback in Plane Strain Stretch/Draw Sheet Forming10.1016/0020-7403(95)93523-9 ↗
7. Springback Analysis of Sheet Metal subjected to Bending-Unbending under Tension (parts I and II)
8. Elasto Plastic Formulation Using A Kinematic Hardening Model For Springback Analysis In Sheet Metal Forming10.1016/0924-0136(95)01876-X ↗
9. Stress and Residual Stress Distributions in Plane Strain Bending10.1016/S0020-7403(97)00075-1 ↗
10. A New Model for Springback Prediction in Which the Bauschinger Effect Is Considered10.1016/S0020-7403(01)00012-1 ↗
11. On The Description Of Anisotropic Work Hardening10.1016/0022-5096(67)90030-0 ↗
12. An Attempt To Describe The Behavior Of Metal Under Cyclic Loads Using A More General Work Harding Model10.1007/BF01176668 ↗
13. A Three-dimensional Model of Anisotropic Hardening in Metals and Its Application to the Analysis of Sheet Metal Formability10.1016/0022-5096(84)90008-5 ↗
15. Discussion of the Prager Hardening Law10.1115/1.4011571 ↗
16. Carden, W. D. , 1997, “Springback After Drawing and Bending of Metal Sheets,” M.S. thesis, The Ohio State University.