journal article·1997-07-01

Effect of Cure State on Stress Relaxation in 3501-6 Epoxy Resin

S. R. White, A. B. Hartman

Publisher page

Abstract

Little experimental work has been done to characterize how the viscoelastic properties of composite material matrix resins develop during cure. In this paper, the results of a series of creep tests carried out on 3501–6 epoxy resin, a common epoxy matrix material for graphite/epoxy composites, at several different cure states is reported. Beam specimens were isothermally cured at increasing cure temperatures to obtain a range of degrees of cure from 0.66 to 0.99. These specimens were then tested in three-point bending to obtain creep compliance over a wide temperature range. The master curves and shift functions for each degree of cure case were obtained by time-temperature superposition. A numerical technique and direct inversion were used to calculate the stress relaxation modulus master curves from the creep compliance master curves. Direct inversion was shown to be adequate for fully cured specimens, however it underpredicts the relaxation modulus and the transition for partially cured specimens. Correlations with experimental stress relaxation data from Kim and White (1996) showed that reasonably accurate results can be obtained by creep testing followed by numerical conversion using the Hopkins-Hamming method.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Mechanical Behavior of Composites · Epoxy Resin Curing Processes · Structural Behavior of Reinforced Concrete

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Department of Aeronautical and Astronautical Engineering, University of Illinois at Urbana-Champaign, Urbana, IL 61801

Department of Mechanical and Industrial Engineering, University of Illinois at Urbana-Champaign, Urbana, IL 61801

References (8)

Show source-provided references
1. Ferry, J. D., 1970, Viscoelastic Properties of Polymers, Wiley, New York.
2. Hopkins I. L. , and HammingR. W., 1957, “On Creep and Relaxation,” Journal of Applied Physics, Vol. 28, p. 906906.10.1063/1.1722885 ↗
3. Kim Y. K. , and WhiteS. R., 1996, “Stress Relaxation Behavior of 3501–6 Epoxy Resin During Cure,” Polymer Engineering and Science, Vol. 36, p. 28522852.10.1002/pen.10686 ↗
4. Nielsen, L. E., and R. F. Landel, 1994, Mechanical Properties and Polymers and Composites, Marcel Dekker, New York.
5. Perkin Elmer, 1994, DMA Users Manual, 7 Series/UNIX DMA7.
6. Suzuki K. , and MiyanoY., 1977, “Change in Viscoelastic Properties of Epoxy Resin in the Curing Process,” Journal of Applied Polymer Science, Vol. 21, p. 33673367.10.1002/app.1977.070211215 ↗
7. White S. R. , and HahnH. T., 1992, “Process Modeling of Composite Materials: Residual Stress Development During Cure Part II. Experimental Validation,” Journal of Composite Materials, Vol. 26, p. 24232423.10.1177/002199839202601605 ↗
8. Williams, J. G., 1973, Stress Analysis of Polymers, Wiley, New York.