journal article·2007-10-01

Modeling of Elastic Waves in Dynamically Loaded NiAl Bicrystals

Eric Loomis, Pedro Peralta, Damian C. Swift

Publisher page

Abstract

Two methods have been used to simulate 2D elastic wave scattering in nickel aluminide (NiAl) bicrystals to study effects of grain boundaries and material anisotropy on elastic wave propagation. Scattering angles and amplitude ratios of the reflected and refracted waves produced at the grain boundary were calculated via slowness curves for both grains, which were plotted in the plane of incidence containing the grain boundary normal. From these curves, scattering angles were measured graphically and amplitude ratios were calculated based on the continuity of tractions and displacements at the boundary. To support these calculations, finite element simulations were performed with ABAQUS/EXPLICIT to obtain time- and space-dependent stresses. The results of each method correlated well with each other for four bicrystals. It was found that for bicrystals where the transmitted quasi-longitudinal (TQL) wave amplitude decreased across the boundary, diminished stresses were found in the finite element models for the same bicrystal. Conversely, where an increase in amplitude of the TQL wave was found, the finite element simulations showed that stress under the boundary increased. In general, the amplitude of the TQL wave was found to have a strong connection to the ratio of incident and TQL sound speeds. However, other directions in each grain are believed to contribute strongly to the overall scattering process since the pairs of bicrystals in this investigation had somewhat similar sound speeds. These findings correlated well with free surface cracking observed in a previous paper (Loomis, E., Peralta, P., Swift, D., and McClellan, K., 2005, Mater. Sci. Eng., Ser. A., 404(1-2), pp. 291–300), where cracks nucleated and propagated due to the focusing of scattered waves at the boundary. Specifically, in bicrystals oriented for shielding, the grain boundary was protected forcing cracks to grow outside of the shielded region.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Intermetallics and Advanced Alloy Properties · Advanced ceramic materials synthesis · High-Velocity Impact and Material Behavior

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Los Alamos National Laboratory, P.O. Box 1663, MS E526, Los Alamos, NM 87545

Department of Mechanical and Aerospace Engineering, Arizona State University, P.O. Box 876106, Tempe, AZ 85287-6106

Material Science and Technology Division, Lawrence Livermore National Laboratory, 7000 East Avenue, Livermore, CA 94551

References (15)

Show source-provided references
1. Treatment of Compounds and Alloys in Radiation Hydrodynamics Simulations of Ablative Laser Loading10.1103/PhysRevE.69.056401 ↗
2. Calculation of Grain Boundary Shock Interactions10.1063/1.1780219 ↗
3. New Windows Into Shocks at the Mesoscale10.1063/1.1780225 ↗
4. A Model for Elastic Precursor Waves in the Shock Loading of Polycrystalline Metals10.1016/0025-5416(77)90217-8 ↗
5. Auld
6. On the Failure of NiAl Bicrystals Under Laser Induced Shock Loading10.1016/j.msea.2005.05.074 ↗
7. Musgrave
8. The Propagation of Elastic Waves in Crystals and Other Anisotropic Media10.1088/0034-4885/22/1/303 ↗
9. Reflection and Polarization of Elastic Waves in a LiF Crystal: Mode Conversion From Longitudinal to Transverse
11. Swift, D. , 2005, “Quantum Mechanical Equations of State for Nickel Aluminide,” Los Alamos National Laboratory Report No. LA-UR-05-1223; Phys Rev B (submitted).
12. Zel’dovich
13. Swift, D., Tierney, T., McClellan, K., Byler, D., Brooks, J, Clegg, S., Peralta, P., and Loomis, E., 2004, “Dynamic Loading of Thick Nickel-Aluminum Crystals by Laser Ablation,” Los Alamos National Laboratory Report No. LA-UR-04-3895.
14. Development of the Indirect Drive Approach to Inertial Confinement Fusion and the Target Physics Basis for Ignition and Gain10.1063/1.871025 ↗
15. Furnish