Cyclic Deformation Behavior and Dislocation Substructures of Hexagonal Zircaloy-4 Under Out-of-Phase Loading
Source abstract
Abstract
Macroscopic response and microscopic dislocation structures of Zr-4 subjected to biaxial fatigue under different phase angles of 30°, 60°, 90° and different equivalent strain ranges of 0.8%, 0.6%, 0.4% were studied. The testing results show that the delay angle between the stress deviators and strain increment tensors is strongly dependent on phase angle and the equivalent strain range. When phase angle equals 60°, the delay angle has the minimum variation range for all specimens. The mean value of the delay angle decreases with increasing phase angle or the equivalent strain range. The variation range and average value of the Mises equivalent stress have the maximum in S3 with the phase angle of 90°. They decrease as the equivalent strain range decreases. Zr-4 displays a pronounced initial hardening followed by a continuous softening for all specimens during out-of-phase cycling. The stabilized saturation stresses of Zr-4 under out-of-phase cycling are much higher than that under uniaxial cycling. It indicates that Zr-4 displays an obvious additional hardening. As the phase angle increases, the typical dislocation structure changes from dislocation cells to tangles. The dislocation-dislocation interactions increase resulting in an additional hardening. In essence, the degree of additional hardening depends, among other factors, on the maximum shear stress ratio of resolved shear stresses and critical resolved shear stresses (RSS/CRSS). [S0094-4289(00)00601-0]
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Nuclear Materials and Properties · Microstructure and mechanical properties · Magnesium Alloys: Properties and Applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
State Key Laboratory for Mechanical Behavior of Materials, Xi’an Jiaotong University, Xi’an 710049, P.R. China
References (20)
Show source-provided references
1. Benallal, A., and Marquis, D., 1987, “Constitutive Equations for Nonproportional Cyclic Elasto-Viscoplasticity,” ASME J. Eng. Mater. Technol., 109, No. 4, pp. 326–336.10.1115/1.3225985 ↗
2. Bettge, D., Ostele, W., and Ziebs, J., 1995, “Temperature Dependence of Additional Cyclic Hardening of a Nickel-Base Superalloy during Out-of-Phase Multiaxial Deformation,” Scr. Metall. Mater., 32, No. 10, pp. 1601–1606.10.1016/0956-716X(95)00243-O ↗
3. Doong, S. H., Socie, D. F., and Robertson, I. M., 1990, “Dislocation Substructures and Nonproportional Hardening,” ASME J. Eng. Mater. Technol., 112, No. 4, pp. 456–464.10.1115/1.2903357 ↗
4. Doong, S. H., and Socie, D. F., 1991, “Constitutive Modeling of Metals under Nonproportional Cyclic Loading,” ASME J. Eng. Mater. Technol., 113, No. 1, pp. 23–30.10.1115/1.2903379 ↗
5. Doquet, V., and Pineau, A., 1990, “Extra Hardening Due to Cyclic Nonproportional Loading of an Austenitic Stainless Steel,” Scr. Metall. Mater., 24, No. 3, pp. 433–438.10.1016/0956-716X(90)90178-J ↗
6. Doquet, V. , 1993, “Twinning and Multiaxial Cyclic Plasticity of a Low Stacking-Fault-Energy F.C.C. Alloy,” Acta Metall. Mater., 41, No. 3, pp. 2451–2459.10.1016/0956-7151(93)90325-M ↗
7. Feaugas, X., and Clavel, M., 1997, “Cyclic Deformation Behavior of an α/β Titanium Alloy (Parts I and II),” Acta Mater., 45, No. 7, pp. 2685–2701 and pp. 2703–2714.10.1016/S1359-6454(96)00407-7 ↗
8. Kida, S., Itoh, T., Sakane, M., Ohnami, M., and Socie, D. F., 1997, “Dislocation Structure and Non-proportional Hardening of Type 304 Stainless Steel,” Fatigue Fract. Eng. Mater. Struct., 20, No. 10, pp. 1375–1386.10.1111/j.1460-2695.1997.tb01496.x ↗
9. Krempl, E., and Lu, H., 1984, “The Hardening and Rate-Dependent Behavior of Fully Annealed AISI Type 304 Stainless Steel Under Biaxial In-Phase and Out-of-Phase Strain Cycling at Room Temperature,” ASME J. Eng. Mater. Technol., 106, No. 4, pp. 376–381.10.1115/1.3225733 ↗
10. Krempl, E., and Lu, H., 1989, “The Path and Amplitude Dependence of Cyclic Hardening of Type 304 Stainless Steel at Room Temperature,” Biaxial and Multiaxial Fatigue, EGF3, M. W. Browa and K. J. Miller, eds., Mechanical Engineering Publications, London, pp. 89–106.
11. McDowell, D. L., Stahl, D. R., Stock, S. R., and Antolovich, S. D., 1988, “Biaxial Path Dependence of Deformation Substructure of Type 304 Stainless Steel,” Metall. Trans. A, 19, No. 5, pp. 1277–1292.10.1007/BF02662589 ↗
12. Nishino, S., Hamada, N., Sakane, M., Ohnami, M., Matsumura, N., and Tokizane, M., 1986, “Microstructural Study of Cyclic Strain Hardening Behavior in Biaxial Stress States at Elevated Temperature,” Fatigue Fract. Eng. Mater. Struct., 9, No. 1, pp. 65–77.10.1111/j.1460-2695.1986.tb01212.x ↗
13. Itoh, T., Sakane, M., Ohnami, M., and Ameyama, K., 1992, “Additional Hardening Due to Nonproportional Cyclic Loading—A Contribution of Stacking Fault Energy,” Mecamat’92 Inter. Seminar on Multiaxial Plasticity, LMT-Cachan, France, pp. 43–50.
14. Xiao, L., and Kuang, Z. B., 1996, “Biaxial Path Dependence of Macroscopic Response and Microscopic Dislocation Substructure in Type 302 Stainless Steel,” Acta Mater., 44, No. 8, pp. 3059–3067.10.1016/1359-6454(95)00441-6 ↗
15. Xiao, L., and Gu, H. C., 1998, “Plastic Energy Dissipation Model for Lifetime Prediction of Zirconium and Zircaloy-4 Fatigued at RT and 400°C,” ASME J. Eng. Mater. Technol., 120, No. 2, pp. 114–118.10.1115/1.2806998 ↗
16. Xiao, L., and Gu, H. C., 1999, “Low Cycle Fatigue Properties and Microscopic Deformation Structures of Zircaloy-4 in Recrystallized and Stress-relieved Conditions,” J. Nucl. Mater., 265, pp. 213–217.10.1016/S0022-3115(98)00506-6 ↗
17. Xiao, L., and Gu, H. C., 1997, “Dislocation Structures in Zirconium and Zircaloy-4 Fatigued at Different Temperatures,” Metall. Mater. Trans., 28, No. 4, pp. 1021–1033.10.1007/s11661-997-0232-1 ↗
18. Doner, M., Chang, H., and Conrad, H., 1974, “Plastic Flow and Dislocation Structure at Small Strains in OFHC Copper Deformed in Tension, Torsion and Combined Tension-Torsion,” J. Mech. Phys. Solids, 22, pp. 555–573.10.1016/0022-5096(74)90034-9 ↗
19. Pochettino, A. A., Gannio, N., Edwards, C. V., and Penelle, R., 1992, “Texture and Pyramidal Slip in Ti, Zr and Their Alloys,” Scr. Metall. Mater., 27, No. 12, pp. 1859–1863.10.1016/0956-716X(92)90033-B ↗
20. Tenckhoff, E. , 1978, “The Development of the Deformation Texture in Zirconium During Rolling in Sequential Passes,” Metall. Trans. A, 9, No. 10, pp. 1401–1412.10.1007/BF02661811 ↗