journal article·2005-04-01

Using Embossing to Create a Fiber Reinforced Honeycomb Composite

William Jordan

Publisher page

Abstract

This research project used hot embossing to create a strong and tough polymeric based composite structure. A honeycomb type structure was created by pressing small grooves into thin polycarbonate sheets. A trapezoidal die was used to create hexagonal shaped channels in the polymeric sheet. A number of these sheets were then bonded together to form a composite material. Carbon fibers were embedded into the channels in some of the laminates. The embossing process was carried out at an elevated temperature in an environmental chamber attached to an MTS servo hydraulic testing machine. The grooved structure had a 31% to 45% decrease in the apparent density compared to the ungrooved specimens. Bend tests, tensile tests, and Charpy impact tests were performed on laminates made from this material. The specific values of tensile strength, flexural modulus, and Charpy impact toughness were increased. A small percentage of fibers significantly increased both the stiffness and strength of the laminate.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Nanofabrication and Lithography Techniques · Additive Manufacturing and 3D Printing Technologies · Advanced Surface Polishing Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Mechanical Engineering, Louisiana Tech University, Ruston, LA 71272 Phone: (318) 257-4304 Fax: (318) 257-2306

References (6)

Show source-provided references
1. Jordan, W., and Mindiola, A., 2000, “Using Micro-Embossing to Improve the Mechanical Properties of Polymeric Based Structures,” in Proceedings of International Conference on Composites Engineering Vol. 7, edited by David Hui, July 2000, pp. 399–400.
2. Hall, D., and Jordan, W., 1996, “Development of Strong Lightweight Polymeric Plates using Micromachining,” in Proceedings of Third International Conference on Composites Engineering, edited by David Hui, July 1996, pp. 419–420.
3. Schaller, T., Bhohn, L., Mayer, J., and Schubert, K., 1999, “Microstructural Grooves with a Wideth of Less Than 50μm Cut with Ground Hard Metal Micro End Mills,” Precis. Eng. 23, p. 229229.10.1016/S0141-6359(99)00011-2 ↗
4. Juang, Y., Lee, L., and Koeling, K., 2002, “Hot Embossing in Microfabrication,” Polym. Eng. Sci. 42, p. 539539.10.1002/pen.10970 ↗
5. Becker, H., and Heim, U., 2000, “Hot Embossing as a Method of Fabrication of Polymer High Aspect Ratio Structures,” Sens. Actuators, A, 83, p. 130130.10.1016/S0924-4247(00)00296-X ↗
6. Willet, R., “Mechanical Properties of Hot Embossed Polycarbonate,” Master’s thesis, November 1998, Louisiana Tech University, Louisiana.