journal article·1975-01

Tensile Strength, Ductility and Impact Strength of Plated ABS and Polypropylene

P. Tipping, J. K. Dennis

Transactions of the IMF· Volume 53· Issue 1
Publisher page

Abstract

SummaryTensile strength, ductility and impact strength of four grades of ABS and three grades of polypropylene were evaluated when plated with various copper+nickel+chromium coatings. Tests were also carried out at the following intermediate stages in the processing sequences:- (i) as moulded, (ii) after etching, (iii) after electroless nickel deposition, (iv) after copper plating, (v) after nickel plating. The application of electrodeposited coatings resulted in a fall in ductility and impact strength but the UTS depended on the particular coating deposited. Mechanisms responsible for the failure of plated plastics are discussed; the dominant phenomenon is considered to be the notch sensitivity of the plastics. A theoretical model was developed to illustrate how a load on a tensile specimen would be distributed between the substrate and copper coatings of varying thickness. A figure was also constructed to show changes in the distribution of the load between substrate and coating with variation in the ratio of Young's moduli of plastics and copper at a particular coating thickness.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Corrosion Behavior and Inhibition · Polymer crystallization and properties · Tribology and Wear Analysis

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (13)

Show source-provided references
1. Goldie W. · 1969
2. Plastics Design Process · 1966 · 6 · 10
3. Roobol N. R. · Plating · 1970 · 57 · 1122
4. Matsunaga M. · Met Fin · 1971 · 69 · 36
5. Morton G. H. · Soc Plas Eng Tech Papers · 1967 · 13 · 888
6. 10.1080/00202967.1974.1187029710.1080/00202967.1974.11870297 ↗
7. 10.1080/00202967.1974.1187031910.1080/00202967.1974.11870319 ↗
8. Dennis J. K. · Electroplating and Met Fin · 1974 · 27 · 9
9. Standard method of test for tensile properties of plastics, ASTM, D638-72, (Type I).
10. 1965
11. Moroney M. J. · 1969 · 216
12. Dennis J. K. · Electroplating and Met Fin · 1965 · 18 · 376
13. Oulsnam S. R. · 1965