journal article·2011-01

SiO2 stabilized Pt/C cathode catalyst for proton exchange membrane fuel cells

Tong Zhu, Chunyu Du, Chuntao Liu, Geping Yin, Pengfei Shi

Applied Surface Science· Volume 257· Issue 6
Publisher page

Abstract

Abstract This paper describes the preparation of SiO2 stabilized Pt/C catalyst (SiO2/Pt/C) by the hydrolysis of alkoxysilane, and examines the possibility that the SiO2/Pt/C is used as a durable cathode catalyst for proton exchange membrane fuel cells (PEMFCs). TEM and XRD results revealed that the hydrolysis of alkoxysilane did not significantly change the morphology and crystalline structure of Pt particles. The SiO2/Pt/C catalyst exhibited higher durability than the Pt/C one, due to the facts that the silica layers covered were beneficial for reducing the Pt aggregation and dissolution as well as increasing the corrosion resistance of supports, although the benefit of silica covering was lower than the case of Pt/CNT catalyst. Also, it was observed that the activity of the SiO2/Pt/C catalyst for the oxygen reduction reaction was somewhat reduced compared to the Pt/C one after the silica covering. This reduction was partially due to the low oxygen kinetics as revealed by the rotating-disk-electrode measurement. Silica covering by hydrolysis of only 3-aminopropyl trimethoxysilane is able to achieve a good balance between the durability and activity, leading to SiO2/Pt/C as a promising cathode catalyst for PEMFCs.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Electrocatalysts for Energy Conversion · Fuel Cells and Related Materials · Advancements in Solid Oxide Fuel Cells

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (24)

Show source-provided references
1. A historical perspective of fuel cell technology in the 20th century10.1149/1.1488651 ↗
2. In situ analysis of performance degradation of a PEMFC under nonsaturated humidification10.1149/1.1854781 ↗
3. Lifetime behavior of a PEM fuel cell with low humidification of feed stream10.1039/B412600A ↗
4. Formation, microstructural characteristics and stability of carbon supported platinum catalysts for low temperature fuel cells10.1023/A:1024771618027 ↗
5. Electrochemical durability of carbon nanostructures as catalyst support for PEMFCs10.1149/1.3033517 ↗
6. Catalyst microstructure examination of PEMFC membrane electrode assemblies vs. time10.1149/1.1625944 ↗
7. Microstructural changes of MEAs during PEMFC durability testing at high humidity conditions10.1149/1.1873492 ↗
8. Scientific aspects of polymer electrolyte fuel cell durability and degradation10.1021/cr050182l ↗
9. Characterization of vulcan electrochemically oxidized under simulated PEM fuel cell conditions10.1149/1.1649756 ↗
10. The stability of Pt/C catalyst in PBI/H3PO4 PEMFC during high temperature life test10.1016/j.jpowsour.2006.09.069 ↗
11. Thermal degradation of the support in carbon-supported platinum electrocatalysts for PEM fuel cells10.1016/j.carbon.2004.09.004 ↗
12. Understanding and approaches for the durability issues of Pt-based catalysts for PEM fuel cell10.1016/j.jpowsour.2007.07.004 ↗
13. Instability of Pt/C electrocatalysts in proton exchange membrane fuel cells: a mechanistic investigation10.1149/1.2050347 ↗
14. Platinum dissolution and deposition in the polymer electrolyte membrane of a PEM fuel cell as studied by potential cycling10.1039/B514342J ↗
15. Sub-stoichiometric titanium oxide-supported platinum electrocatalyst for polymer electrolyte fuel cells10.1016/j.elecom.2004.12.007 ↗
16. A novel CNT@SnO2 core–sheath nanocomposite as a stabilizing support for catalysts of proton exchange membrane fuel cells10.1016/j.elecom.2008.12.034 ↗
17. Stabilization of platinum oxygen-reduction electrocatalysts using gold clusters10.1126/science.1134569 ↗
18. Supportless Pt and PtPd nanotubes as electrocatalysts for oxygen reduction reaction10.1002/anie.200700894 ↗
19. High Durability of carbon nanotube-supported Pt electrocatalysts covered with silica layers for the cathode in a PEMFC10.1149/1.2952665 ↗
20. Improvement in the durability of Pt electrocatalysts by coverage with silica layers10.1021/jp076120b ↗
21. Effects of the surface area of carbon support on the characteristics of highly-dispersed Pt–Ru particles as catalysts for methanol oxidation10.1016/S0013-4686(03)00521-8 ↗
22. Characterization of high-surface-area electrocatalysts using a rotating disk electrode configuration10.1149/1.1838642 ↗
23. Platinum dispersed on silica nanoparticles for PEM fuel cells10.1016/j.jelechem.2007.09.037 ↗
24. Proton exchange membrane fuel cells with carbon nanotube based electrodes10.1021/nl034952p ↗