journal article·2023-03Open access

Sulfate resistance of class C/class F fly ash geopolymers

Zhenzhen Jiao, Xueying Li, Qinglin Yu, Qinqin Yao, Ping Hu

Abstract

Sulfate attack is one of the significant durability problems for the geopolymer applied for various severe conditions. In this study, the effects of the water-to-fly ash ratio (W/FA), class C fly ash (CF) content, and alkaline content on the setting times and compressive strength of geopolymer pastes were investigated. According to the results, geopolymer samples of three different strength grades (low, medium, and high) were exposed to a 10% magnesium sulfate (MgSO₄) solution at 80 °C. The weight changes, ultrasonic flight-times, and compressive strengths of the specimens were measured to evaluate their sulfate resistances. Control samples were exposed to water at the same temperature. Finally, microstructural analyses using Fourier-transform infrared spectroscopy, X-ray diffraction, and mercury intrusion porosimetry were performed to investigate the corrosion mechanism. The results indicated that higher CF contents led to shorter initial and final setting times and a higher compressive strength regardless of the W/FA and alkaline content. In addition, there was a small weight change for all the geopolymer with different strength grades after they were exposed to an MgSO4 solution. The low strength geopolymer exhibited a better sulfate resistance because of the sustainable increase in the compressive strength and reduction in the ultrasonic flight-time. Moreover, there was a close relationship between the corrosion resistance and the inner structure of the geopolymer mortars. This research provides a theoretical foundation for the application of geopolymers—particularly in coastal and saline areas, which are often subject to sulfate attack.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Concrete and Cement Materials Research · Magnesium Oxide Properties and Applications · Innovative concrete reinforcement materials

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (65)

Show source-provided references
1. Introduction: sustainable development and concrete technology
2. Climate change and cement industry
3. Properties of a new insulation material glass bubble in geopolymer concrete10.3390/ma14040809 ↗
4. Geopolymers and their uses: Review
5. Chemical research and climate change as drivers in the commercial adoption of alkali activated materials10.1007/s12649-010-9015-9 ↗
6. Behavior of low-calcium fly and bottom ash-based geopolymer concrete cured at ambient temperature10.1016/j.ceramint.2015.01.031 ↗
7. Effects of sodium hydroxide and sodium silicate solutions on compressive and shear bond strengths of FA-GBFS geopolymer10.1016/j.conbuildmat.2015.05.001 ↗
8. An investigation of the microstructure and durability of a fluidized bed fly ash-metakaolin geopolymer after heat and acid exposure10.1016/j.matdes.2015.03.009 ↗
9. Effects of mix design parameters on heat of geopolymerization, set time, and compressive strength of high calcium fly ash geopolymer10.1016/j.conbuildmat.2019.116763 ↗
10. Freeze-thaw and fire resistance of geopolymer mortar based on natural and waste pozzolans
11. Effect of curing conditions on freeze-thaw resistance of geopolymer mortars containing various calcium resources10.1016/j.conbuildmat.2021.125507 ↗
12. Durability performance evaluation of green geopolymer concrete
13. Very high strength (120 MPa) class F fly ash geopolymer mortar activated at different NaOH amount, heat curing temperature and heat curing duration10.1016/j.conbuildmat.2015.08.089 ↗
14. Properties of geopolymer from circulating fluidized bed combustion coal bottom ash10.1016/j.msea.2010.10.062 ↗
15. Effect of transient creep on compressive strength of geopolymer concrete for elevated temperature exposure10.1016/j.cemconres.2013.11.014 ↗
16. Effect of activator type and content on properties of alkali-activated slag mortars10.1016/j.compositesb.2013.10.001 ↗
17. Setting of alkali-activated slag cement. Influence of activator nature10.1680/adcr.2001.13.3.115 ↗
18. Alkali-activated slag mortars: mechanical strength behaviour10.1016/S0008-8846(99)00154-4 ↗
19. Alkali activation of Australian slag cements10.1016/S0008-8846(98)00170-7 ↗
20. Utilization of radioactive high-calcium Mongolian flyash for the preparation of alkali-activated geopolymers for safe use as construction materials10.1016/j.ceramint.2014.07.157 ↗
21. Factors affecting the setting time of fly ash-based geopolymer10.4028/www.scientific.net/MSF.841.90 ↗
22. Influence of curing on the strength development of calcium-containing geopolymer mortar10.3390/ma6115069 ↗
23. Effects of combined usage of GGBS and fly ash on workability and mechanical properties of alkali activated geopolymer concrete with recycled aggregate10.1016/j.compositesb.2018.11.067 ↗
24. Investigation of using waste marble powder, brick powder, ceramic powder, glass powder, and rice husk ash as eco-friendly aggregate in sustainable red mud-metakaolin based geopolymer composites10.1016/j.conbuildmat.2022.129718 ↗
25. Mechanism of sulfate attack: a fresh look: Part 2. Proposed mechanisms10.1016/S0008-8846(02)00958-4 ↗
26. Magnesium sulfate resistance of geopolymer mortar10.1016/j.conbuildmat.2018.06.212 ↗
27. Insights to the sulfate resistance and microstructures of alkali-activated metakaolin/slag pastes10.1016/j.clay.2020.105968 ↗
28. Sulfate resistance of recycled aggregate concrete with GGBS and fly ash-based geopolymer10.3390/ma12081247 ↗
29. Durability of geopolymer materials in sodium and magnesium sulfate solutions10.1016/j.cemconres.2004.09.002 ↗
30. Sulfate resistance of hybrid fiber reinforced metakaolin geopolymer composites10.1016/j.compositesb.2019.107689 ↗
31. Sulfate and acid resistance of lithomarge-based geopolymer mortars10.1016/j.conbuildmat.2018.01.129 ↗
32. Influence of partial replacement of fly ash by metakaolin on mechanical properties and microstructure of fly ash geopolymer paste exposed to sulfate attack10.1016/j.ceramint.2015.10.154 ↗
33. Durability performances of wollastonite, tremolite and basalt fiber-reinforced metakaolin geopolymer composites under sulfate and chloride attack10.1016/j.conbuildmat.2016.12.103 ↗
34. Chloride resistance of class C/class F fly ash-based geopolymer mortars with different strength grades
35. Sustainable utilization of pre-treated and nano fly ash powder for the development of durable geopolymer mortars10.1016/j.apt.2022.103696 ↗
36. 2011
37. 2021
38. Setting and mechanical properties of alkali-activated fly ash/slag concrete manufactured at room temperature10.1016/j.conbuildmat.2013.05.107 ↗
39. Effects of NaOH concentrations on physical and electrical properties of high calcium fly ash geopolymer paste10.1016/j.cemconcomp.2013.09.012 ↗
40. Effect of external and internal calcium in fly ash on geopolymer formation
41. Influence of curing conditions on properties of high calcium fly ash geopolymer containing Portland cement as additive10.1016/j.matdes.2013.07.018 ↗
42. Use of OPC to improve setting and early strength properties of low calcium fly ash geopolymer concrete cured at room temperature10.1016/j.cemconcomp.2014.08.008 ↗
43. Influence of NaOH solution on the synthesis of fly ash geopolymer10.1016/j.mineng.2009.03.022 ↗
44. Effect of SiO2 and Al2O3 on the setting and hardening of high calcium fly ash-based geopolymer systems10.1007/s10853-012-6353-y ↗
45. Calorimetric study of alkaline activation of calcium hydroxide–metakaolin solid mixtures10.1016/S0008-8846(00)00435-X ↗
46. Effect of the activator dose on the compressive strength and accelerated carbonation resistance of alkali silicate-activated slag/metakaolin blended materials10.1016/j.conbuildmat.2015.08.013 ↗
47. Characterization of the high-calcium fly ash geopolymer mortar with hot-weather curing systems for sustainable application10.1016/j.apt.2017.06.013 ↗
48. Investigation into the effect of calcium on the existence form of geopolymerized gel product of fly ash based geopolymers10.1016/j.cemconcomp.2018.11.019 ↗
49. Application and validation of fly ash based geopolymer mortar as grouting material in porous asphalt concrete10.1016/j.conbuildmat.2022.127154 ↗
50. Taftan pozzolan-based geopolymer cement
51. Effects of blast-furnace slag on natural pozzolan-based geopolymer cement
52. Effect of type, form, and dosage of activators on strength of alkali-activated natural pozzolans10.1016/j.cemconcomp.2010.10.021 ↗
53. Potential utilization of class C fly ash-based geopolymer in oil well cementing operations10.1016/j.cemconcomp.2014.06.014 ↗
54. Effect of synthesis parameters on the compressive strength of low-calcium ferronickel slag inorganic polymers10.1016/j.jhazmat.2008.04.055 ↗
55. A comparative study on the durability of geopolymers produced with ground glass fiber, fly ash, and glass-powder in sodium sulfate solution10.1016/j.conbuildmat.2017.07.139 ↗
56. Sulfate resistance of ferrochrome slag based geopolymer concrete10.1016/j.ceramint.2015.09.058 ↗
57. Alkali activated cement made from blast furnace slag generated by charcoal: resistance to attack by sodium and magnesium sulfates10.1016/j.conbuildmat.2019.117710 ↗
58. Sulfate attack on alkali-activated slag concrete10.1016/S0008-8846(01)00659-7 ↗
59. Early mechanical properties and microstructural evolution of slag/metakaolin-based geopolymers exposed to karst water10.1016/j.cemconcomp.2019.03.009 ↗
60. Studies on the microstructure and durability characteristics of ambient cured FA-GGBS based geopolymer mortar10.1016/j.conbuildmat.2022.128538 ↗
61. Chemical acceleration of a neutral granulated blast-furnace slag activated by sodium carbonate10.1016/j.cemconres.2015.02.014 ↗
62. Use of glass waste as an activator in the preparation of alkali-activated slag. Mechanical strength and paste characterisation10.1016/j.cemconres.2013.12.005 ↗
63. Hybrid slag geopolymer composites with durable characteristics activated by cement kiln dust10.1016/j.conbuildmat.2019.116708 ↗
64. Reactivity and reaction products of alkali-activated, fly ash/slag paste10.1016/j.conbuildmat.2015.02.022 ↗
65. Microstructural changes in alkali activated fly ash/slag geopolymers with sulfate exposure10.1617/s11527-012-9906-2 ↗