journal article·2023-05Open access

Experimental investigation on mechanical properties and deformation mechanism of soft-hard interbedded rock-like material based on digital image correlation

Pingkuang Luo, Diyuan Li, Jinyin Ma, Aohui Zhou, Chengxi Zhang

Abstract

The soft-hard interbedded rocks are often encountered in rock engineering such as mining engineering, tunnel engineering, and natural gas engineering. In this study, the horizontal soft-hard interbedded composite rock-like material (HSHC) specimens were prepared with different thickness ratios of rock-like layers, and a series of uniaxial compression tests were performed by using a self-designed loading mold. A parameter R was defined for the HSHC specimens, which is related to the thickness ratio of the soft and hard rock-like layers, the length-width ratio, and the mechanical parameters of the soft and hard rock-like materials. R was regarded to characterize the strength properties of the HSHC specimens. The test results showed that the axial strength of the HSHC specimens decreases first and then tends to be constant with increasing of R. Digital image correlation (DIC) technique was used to investigate the strain evolution and crack propagation process of the HSHC specimens. The displacement variation trend of the specimen can be roughly divided into three stages: stable deformation stage, rapid crack growth stage and instability failure stage. The failure mode of the HSHC specimens was mainly splitting tensile failure along the bedding plane. Meanwhile, a simplified mechanical model of laminated rock mass under uniaxial compression is established. The strength variation trend predicted by this model is consistent with the experimental results. The present study can reveal the failure mechanism of soft-hard interbedded rock mass at the bottom of the tunnel under the action of large horizontal stress after excavation.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Rock Mechanics and Modeling · Tunneling and Rock Mechanics · Landslides and related hazards

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (67)

Show source-provided references
1. Numerical analysis of tunneling in slates with anisotropic time-dependent behavior10.1016/j.tust.2018.11.025 ↗
2. Numerical observations of the failure of a laminated and jointed roof and the effective of different support schemes: a case study10.1007/s12665-020-08935-2 ↗
3. Physical model test and numerical simulation on the failure mechanism of the roadway in layered soft rocks10.1016/j.ijmst.2021.01.003 ↗
4. Physical experiment and numerical modelling of tunnel excavation in slanted upper-soft and lower-hard strata10.1016/j.tust.2018.08.049 ↗
5. Searching for multistage sliding surfaces based on the discontinuous dynamic strength reduction method10.1016/j.enggeo.2021.106086 ↗
6. Temperature effect of rock burst for hard rock in deep-buried tunnel10.1007/s11069-014-1042-6 ↗
7. Evaluation of strength anisotropy and failure modes of laminated sandstones10.1007/s12517-014-1411-1 ↗
8. Using anisotropic effective medium theories to quantify elastic properties of sandstone-shale laminated rocks10.1190/geo2015-0323.1 ↗
9. The evolution law of the damage of bedded composite rock and its fractal characteristics
10. Study of layered rock mass composite model based on characteristics of structural plane and its application
11. Progress and challenges of soft rock engineering in depth
12. A new classification of failure mechanisms at tunnels in stratified rock masses through physical and numerical modeling10.1016/j.tust.2019.103017 ↗
13. Large-scale model experiment and numerical simulation on convergence deformation of tunnel excavating in composite strata10.1016/j.tust.2019.103133 ↗
14. Physical modeling of floor heave for the deep-buried roadway excavated in ten degree inclined strata using infrared thermal imaging technology10.1016/j.tust.2016.12.018 ↗
15. The mechanism of roadway deformation in conditions of laminated rocks10.1016/j.jsm.2018.03.004 ↗
16. Comprehensive assessment on dynamic roof instability under fractured rock mass conditions in the excavation disturbed zone10.1016/S1674-4799(09)60003-0 ↗
17. Analysis of deformation damage in deep well roadway and supporting countermeasures10.1007/s10706-020-01416-0 ↗
18. Mechanism for controlling floor heave of mining roadways using reinforcing roof and sidewalls in underground coal mine10.3390/su10051413 ↗
19. Imperfection and burial-depth sensitivity of the initiation and development of kink folds in laminated rocks10.1016/j.jmps.2009.04.006 ↗
20. Effective method for adjusting the uplifting of shield machine tunneling in upper-soft lower-hard strata10.1016/j.tust.2021.104040 ↗
21. Microseismic characteristics of rockburst development in deep TBM tunnels with alternating soft–hard strata and application to rockburst warning: a case study of the Neelum–Jhelum hydropower project10.1016/j.tust.2022.104398 ↗
22. Failure mechanisms and modes of tunnels in monoclinic and soft-hard interbedded rocks: a case study10.1007/s12205-020-1324-3 ↗
23. Deformation evolution and failure mechanism of monoclinic and soft-hard interbedded strata: study of Muzhailing tunnel10.1061/(ASCE)CF.1943-5509.0001605 ↗
24. The effect of selected factors on floor upheaval in roadways—in situ testing10.3390/en13215686 ↗
25. Study on floor heave mechanism of horizontal layered soft rock roadway in deep well under different stress states
26. Numerical investigation of the direct tensile behaviour of laminated and transversely isotropic rocks containing incipient bedding planes with different strengths10.1016/j.compgeo.2017.11.007 ↗
27. Discrete element modeling of delamination in laboratory scale laminated rock10.1007/s42461-020-00302-w ↗
28. Trilinear tensile stress–strain constitutive model for high ductility cementitious composite with totally recycle fine aggregate10.1016/j.conbuildmat.2021.126149 ↗
29. Dynamic damage and failure of layered sandstone with pre-cracked hole under combined cyclic impact and static loads
30. Effect of interfacial angle on the mechanical behaviour and acoustic emission characteristics of coal–rock composite specimens10.1016/j.jmrt.2022.09.104 ↗
31. Analysis of deformation of linear viscoelastic two layered laminated rocks
32. Investigation of strength and deformation of composite rock in uniaxial and triaxial compression test
33. Experimental study of stress wave propagation and energy characteristics across rock specimens containing cemented mortar joint with various thicknesses
34. Stress wave propagation and dynamic behavior of red sandstone with single bonded planar joint at various angles
35. Dynamic compression characteristics of layered rock mass of significant strength changes in adjacent layers10.1016/j.jrmge.2019.09.003 ↗
36. Effect of confining pressure on mechanical properties of horizontal layered composite rock
37. Research on a model material preparation method for alternate layered rock mass and preliminary experiment
38. On the fracture mechanism of rock-like materials with interbedded hard-soft layers under Brazilian tests10.1016/j.tafmec.2021.103102 ↗
39. Uniaxial experimental study of the acoustic emission and deformation behavior of composite rock based on 3D digital image correlation (DIC)10.1007/s10409-017-0706-3 ↗
40. An experimental investigation of the failure mechanism of simulated transversely isotropic rocks10.1016/j.ijrmms.2006.03.011 ↗
41. Preparation and mechanical properties of artificial transversely isotropic rock10.1016/S1365-1609(00)00024-1 ↗
42. Study on damage constitutive relation of three-dimensional stratified composite rock
43. Study on micropores evolution and loading experiment on stratified composite rock
44. Influence of mechanical characteristic of bedding surface on stratified composite rock mass
45. A review of 3D printed concrete: performance requirements, testing measurements and mix design10.1016/j.conbuildmat.2020.121745 ↗
46. Finite element analysis on the anisotropic behavior of 3D printed concrete under compression and flexure
47. 3D recycled mortar printing: system development, process design, material properties and on-site printing
48. Influence of new-to-old concrete interface on the damping behavior of recycled aggregate concrete10.1002/suco.202100106 ↗
49. Theoretical and experimental analysis on the mechanism of the Kaiser effect of acoustic emission in brittle rocks
50. The mode I fatigue fracture of fine-grained quartz-diorite under coupled static loading and dynamic disturbance10.1016/j.tafmec.2021.103140 ↗
51. Effect of filling on failure characteristics of diorite with double rectangular holes under coupled static–dynamic loads10.1007/s00603-021-02409-y ↗
52. Mechanical properties and crack evolution of double-layer composite rock-like specimens with two parallel fissures under uniaxial compression10.1016/j.tafmec.2020.102610 ↗
53. Crack coalescence in rock-like specimens with two dissimilar layers and pre-existing double parallel joints under uniaxial compression10.1016/j.ijrmms.2021.104621 ↗
54. Deformation and failure mechanism of horizontal soft and hard interlayered rock under uniaxial compression based on digital image correlation method10.1016/j.engfailanal.2022.106823 ↗
55. Critical tension crack depth in rockslides that conform to the three-section mechanism10.1007/s10346-020-01471-x ↗
56. Modeling of failure characteristics of rectangular hard rock influenced by sample height-to-width ratios: a finite/discrete element approach
57. Failure characteristics of granite influenced by sample height-to-width ratios and intermediate principal stress under true-triaxial unloading conditions10.1007/s00603-018-1414-4 ↗
58. Hou · 2021 · 1
59. Investigation of the rate dependence of fracture propagation in rocks using digital image correlation (DIC) method10.1016/j.engfracmech.2015.02.021 ↗
60. Schreier · 2009
61. Two-dimensional digital image correlation for in-plane displacement and strain measurement: a review10.1088/0957-0233/20/6/062001 ↗
62. Mechanical properties and fracture evolution of sandstone specimens containing different inclusions under uniaxial compression10.1016/j.ijrmms.2019.01.010 ↗
63. Effect of water content on the failure pattern and acoustic emission characteristics of red sandstone10.1016/j.ijrmms.2021.104709 ↗
64. Effect of thermal treatment on the fracture toughness and subcritical crack growth of granite in double-torsion test
65. Evaluation of Bi-modular behavior of rocks subjected to uniaxial compression and Brazilian tensile testing10.1007/s00603-021-02469-0 ↗
66. Crack development in transversely isotropic sandstone discs subjected to Brazilian tests observed using digital image correlation10.1016/j.ijrmms.2019.04.004 ↗
67. Subcritical crack growth and fracture behavior of rocks and long-term strength estimation10.1016/j.tafmec.2022.103664 ↗