journal article·2023-09Open access

Mechanical and thermal properties of cement mortar composites incorporating micronized miscanthus fibers

Franck Komi Gbekou, Abderrahim Boudenne, Anissa Eddhahak, Karim Benzarti

Abstract

This study examines the impact of incorporating micronized miscanthus fibers into a cement mortar, focusing on the mechanical and thermal effects. Initially, an experimental procedure was devised to create mortar mixtures with varying amounts of miscanthus fibers, with a maximum dosage of 7 wt.%. This involved saturating the fibers with water beforehand to maintain the workability of the fresh mixes. The resulting hardened bio-based mortars were then evaluated after 28 days in terms of their microstructure, mechanical strength (assessed through flexural and compression tests), and thermophysical properties (measured using the Hot-Disk technique to determine thermal conductivity/diffusivity and volumetric heat capacity). The experimental findings revealed significant enhancements (up to 87%) in the thermal resistance of the mortars due to the addition of fibers. However, this improvement was accompanied by a considerable reduction in mechanical strength. As a result, while these bio-based mortars are unsuitable for structural applications, they still possess adequate mechanical properties for handling and are appropriate for insulation purposes in construction.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Innovations in Concrete and Construction Materials · Natural Fiber Reinforced Composites · Hygrothermal properties of building materials

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (55)

Show source-provided references
1. International Energy Agency (IEA), Tracking buildings 2021, Paris, 2021. https://www.iea.org/reports/tracking-buildings-2021.
2. Overview on biobased building material made with plant aggregate10.21809/rilemtechlett.2016.9 ↗
3. Renewable energy technologies for sustainable development of energy efficient building10.1016/j.aej.2017.02.027 ↗
4. 2017
5. The influence of natural reinforcement fibres on insulation values of earth plaster for straw bale buildings10.1016/j.matdes.2010.05.026 ↗
6. Acoustic performance and microstructural analysis of bio-based lightweight concrete containing miscanthus10.1016/j.conbuildmat.2017.09.161 ↗
7. Experimental investigation of new biocomposite with low cost for thermal insulation10.1016/j.enbuild.2013.07.019 ↗
8. Development of lightweight concrete with high resistance to water and chloride-ion penetration10.1016/j.cemconcomp.2010.08.005 ↗
9. The mechanical, transport and thermal properties of mortar and concrete containing waste cork10.1016/j.cemconcomp.2012.06.003 ↗
10. Hygric properties and thermal conductivity of a new insulation material for building based on date palm concrete10.1016/j.conbuildmat.2017.08.025 ↗
11. Hygrothermal characterization of a new bio-based construction material: concrete reinforced with date palm fibers10.1016/j.conbuildmat.2018.10.089 ↗
12. Thermo-physical and mechanical characterization of cement-based mortar incorporating spent tea
13. Thermophysical characteristics of cement-based mortar incorporating spent coffee grounds
14. Thermal and mechanical performance of natural mortar reinforced with date palm fibers for use as insulating materials in building10.1016/j.enbuild.2014.05.032 ↗
15. Plant fibre reinforced cement components for roofing10.1016/S0950-0618(99)00046-X ↗
16. Bio-based ultra-lightweight concrete applying miscanthus fibers: acoustic absorption and thermal insulation10.1016/j.cemconcomp.2020.103829 ↗
17. Development of cork–gypsum composites for building applications10.1016/S0950-0618(99)00021-5 ↗
18. Properties of hemp fibre reinforced concrete composites10.1016/j.compositesa.2005.01.032 ↗
19. Influence of chemical treatments of miscanthus stem fragments on polysaccharide release in the presence of cement and on the mechanical properties of bio-based concrete materials10.1016/j.cemconcomp.2019.103429 ↗
20. Correlation between hydration of cement and durability of natural fiber-reinforced cement composites10.1016/j.corsci.2016.01.020 ↗
21. Assessing the effect of CaSO4 content on the hydration kinetics, microstructure and mechanical properties of cements containing sugars10.1016/j.conbuildmat.2017.03.067 ↗
22. Saccharification of Miscanthus x giganteus, incorporation of lignocellulosic by-product in cementitious matrix10.1016/j.crvi.2011.07.008 ↗
23. Effect of saccharides on the hydration of ordinary Portland cement10.1016/j.conbuildmat.2017.05.149 ↗
24. Long-term performance of bio-based miscanthus mortar10.1016/j.conbuildmat.2022.126703 ↗
25. Optimisation of the mechanical properties of Miscanthus lightweight concrete10.1016/j.conbuildmat.2020.119643 ↗
26. 2- miscanthus
27. Delayed harvest of miscanthus—influences on biomass quantity and quality and environmental impacts of energy production10.1016/S1161-0301(02)00018-7 ↗
28. Suitability of miscanthus genotypes for lightweight concrete
29. Variation in morphology, anatomy and chemistry of stems of Miscanthus genotypes differing in mechanical properties10.1016/S0926-6690(02)00093-6 ↗
30. The use of miscanthus (Giganteus) as a plant fiber in concrete production
31. Dias · 2021
32. Masonry blocks from lightweight concrete on the basis of miscanthus as aggregates
33. Increase of miscanthus cultivation with new roles in materials production—a review10.3390/agronomy10020308 ↗
34. Use of calcium sulfoaluminate cements for setting control of 3D-printing mortars10.1016/j.conbuildmat.2017.09.109 ↗
35. Khalil · 2018
36. 2016
37. Effects of treated miscanthus on performance of bio-based cement mortar10.1080/21650373.2022.2059794 ↗
38. 2010
39. 2015
40. Plant-based natural fibre reinforced cement composites: a review10.1016/j.cemconcomp.2016.02.014 ↗
41. A study, of jute fibre reinforced cement composites10.1016/0262-5075(82)90011-2 ↗
42. Experimental and multi-scale analysis of the thermal properties of Portland cement concretes embedded with microencapsulated Phase Change Materials (PCMs)10.1016/j.applthermaleng.2013.11.050 ↗
43. Microencapsulated bio-based phase change material-micro concrete composite for thermal energy storage
44. Mechanical and thermophysical properties of cement mortars including bio-based microencapsulated phase change materials10.1016/j.conbuildmat.2022.129056 ↗
45. Description of the concrete carbonation process with adjusted depth-resolved thermogravimetric analysis10.1007/s10973-021-10966-1 ↗
46. Measurement methods of carbonation profiles in concrete: thermogravimetry, chemical analysis and gammadensimetry10.1016/j.cemconres.2007.04.015 ↗
47. Lignocellulosic biomass-based pyrolysis: a comprehensive review
48. Properties of concretes enhanced with phase change materials for building applications10.1016/j.enbuild.2019.07.014 ↗
49. Thermal properties of cement mortar with different mix proportions10.3989/mc.2020.09219 ↗
50. Full-scale investigation of the dynamic heat storage of concrete decks with PCM and enhanced heat transfer surface area10.1016/j.enbuild.2012.12.013 ↗
51. Mechanical and microstructural characterization of bio-concrete prepared with optimized alternative green binders10.1016/j.conbuildmat.2021.122533 ↗
52. Mechanical, thermal, hygroscopic and acoustic properties of bio-aggregates – lime and alkali - activated insulating composite materials: a review of current status and prospects for miscanthus as an innovative resource in the South West of England10.1016/j.susmat.2020.e00211 ↗
53. Mechanical and thermal properties of lime and hemp concrete (“hempcrete”) manufactured by a projection process10.1016/j.conbuildmat.2007.07.016 ↗
54. Analysis of plant materials pre-treated by steam explosion technology for their usability as insulating materials
55. Properties study of cotton stalk fiber/gypsum composite10.1016/S0008-8846(02)00915-8 ↗