journal article·2025-05Open access

Investigate on dynamic mechanical and mesoscopic damage characteristics of high-temperature treated granite based on SPH-FEM coupling algorithm

Liu Zilu, Yu Weijian, Wu Genshui, Zhang Zizheng, Wang Ping

Abstract

High-temperature make rock engineering vulnerable to instability and failure under dynamic disturbance, investigating dynamic mechanical behavior of rocks under high-temperature conditions holds significant engineering importance. In this study, the mineral composition and mesoscopic crack characteristics of granite within the temperature range of 25–600 °C were observed using X-ray diffraction (XRD) and polarized microscopy (PM), the dynamic impact characteristics of granite at different temperatures and impact velocities were tested by separated SHPB system, a SPH-FEM coupling model in LS-DYNA software was established to investigate the dynamic fracture characteristics of granite after heat treatment. The results indicate that: as temperature increasing, the mass loss rate of the granite samples continuously increases, the volumetric expansion rate and density reduction rate first increase and then decrease, the wave velocity decreases linearly. Within the temperature range of 25∼600 °C, the quartz content remains relatively stable, while the proportion of sodium feldspar increases with temperature, and the proportion of potassium feldspar continuously decreases. The loss of various types of moisture within the rock intensifies the damage to its crystalline structure, elevated temperatures can lead to the metamorphism of the mineral components in granite, resulting in alterations to its macro-mechanical properties. The peak strength of granite samples rises with the increase in strain rate, especially at 25 °C and 150 °C. Nevertheless, for the same strain rate, the peak strength of granite decreases as the temperature increases. At same temperature, the fragmentation of granite samples increases with the strain rate, as the temperature rises, the extent of fragmentation after failure also increases for similar strain rates. The LS-DYNA model calculation results closely matched the result of experiment, at temperatures ≤300 °C, the slices showed progressive splitting failure from periphery to interior, while at temperatures ≥450 °C, the slices passing through the center exhibited a 'inverted V′ shaped failure. This study will offer both data support and theoretical insights for the stability control and safety evaluation of rock engineering under dynamic loading in high-temperature conditions.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Rock Mechanics and Modeling · Landslides and related hazards · High-Velocity Impact and Material Behavior

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (58)

Show source-provided references
1. Experimental and modeling investigation on the dynamic response of granite after high-temperature treatment under different pressures10.1016/j.conbuildmat.2017.08.090 ↗
2. Investigation on mechanical properties and dilatancy behavior of deeply buried mudstone: a comprehensive study10.1016/j.conbuildmat.2025.140032 ↗
3. Mechanical behavior and fracture characteristics of high-temperature sandstone under true triaxial loading conditions10.1016/j.jmrt.2023.11.260 ↗
4. Mechanical properties and energy evolution of thermally damaged red sandstone in high-strain-rate impact tensile tests: experimental and theoretical analyses10.1016/j.jmrt.2024.08.202 ↗
5. Failure mechanics mechanisms and permeability stage evolution of limestone considering wave velocity and failure surface characteristics10.1016/j.sandf.2025.101577 ↗
6. Mechanical properties and failure characteristics of sandstone under ramp loading paths10.1007/s40948-023-00574-8 ↗
7. Response mechanism of dynamic tensile mechanics in granite under microwave irradiation: insights from experiments and simulations10.1007/s00603-024-03958-8 ↗
8. Multiscale study of dynamic mode-I fracture characteristics of thermally treated granite: comparison of conventional and microwave heating10.1016/j.engfracmech.2024.110478 ↗
9. Microcracking behavior and damage mechanism of granite subjected to high temperature based on CT-GBM numerical simulation10.1016/j.compgeo.2023.105385 ↗
10. Dynamic response and fracture characteristics of thermally-treated granite under dynamic loading10.1016/j.ijrmms.2023.105482 ↗
11. Mechanical and damage evolution characteristics of granite after heating-cooling cycles10.1007/s11771-023-5513-3 ↗
12. Tensile properties and damage evolution laws of granite after high- and low-temperature cycles10.1007/s11053-022-10025-y ↗
13. Experimental study on uniaxial compression mechanics and failure characteristics of non-through fractured rock10.3390/su15064968 ↗
14. Dynamic shear behaviours of granite under coupled static and high-rate loadings10.1016/j.ijrmms.2024.105730 ↗
15. Dynamic characteristics and anchorage mechanisms of fractured granite: analytical, numerical and experimental analyses
16. Impacts of different cooling methods on the dynamic tensile properties of thermal-treated granite10.1016/j.ijrmms.2023.105438 ↗
17. Research on dynamic cracking properties of cracked rock mass under the effect of thermal treatment10.1016/j.tafmec.2022.103580 ↗
18. Non-monotonic effect of differential stress and temperature on mechanical property and rockburst proneness of granite under high-temperature true triaxial compression
19. Evolution of surface properties of ornamental granitoids exposed to high temperatures10.1016/j.conbuildmat.2015.12.051 ↗
20. Influence of axial stress on failure characteristics of deep arched hard rock roadway10.1016/S1003-6326(24)66656-2 ↗
21. Modeling dynamic fracture in granite under in situ conditions at high temperatures and pressures10.1016/j.ijrmms.2018.11.007 ↗
22. Static compression behavior and strength weakening mechanism of dynamically damaged granite after water soaking10.1016/j.engfailanal.2023.107760 ↗
23. Numerical modelling of thermal weakening of granite under dynamic loading10.1016/j.ijrmms.2023.105523 ↗
24. Experimental study of fracture behaviors of granite at ultra-low temperatures10.1016/j.conbuildmat.2024.135510 ↗
25. Damage deterioration behavior of granite subjected to freeze-thaw cycles: experiments and theories10.1016/j.conbuildmat.2024.138540 ↗
26. Investigation of fracture characteristics of cracked granite suffered from different thermal treatments and water-cooling time10.1016/j.jmrt.2024.01.060 ↗
27. Mechanical properties and thermo-chemical damage constitutive model of granite subjected to thermal and chemical treatments under uniaxial compression10.1016/j.conbuildmat.2023.131755 ↗
28. Determination of dynamic flexural tensile strength of thermally treated laurentian granite using semi-circular specimens10.1007/s00603-016-0920-5 ↗
29. Dynamic behaviors of water-saturated and frozen sandstone subjected to freeze-thaw cycles10.1016/j.jrmge.2022.11.007 ↗
30. Effect of cyclic freeze–thaw treatments on the dynamic fracture characteristics of granite: laboratory testing10.1016/j.engfracmech.2022.108915 ↗
31. Dynamic triaxial compression tests on sandstone at high strain rates and low confining pressures with split Hopkinson pressure bar10.1016/j.ijrmms.2018.12.005 ↗
32. Theoretical and experimental study on single spherical button penetration into granite rock under dynamic impact loading10.1007/s00603-021-02688-5 ↗
33. Fracture mechanics behavior of jointed granite exposed to high temperatures10.1007/s00603-021-02393-3 ↗
34. Study on the influence of indentation depths on the fracture characterization and acoustic emission characteristics of minerals in granite using nanoindentation10.1016/j.conbuildmat.2024.138516 ↗
35. Study on dynamic mechanical properties and constitutive model of granite under constant strain rate loading10.1016/j.conbuildmat.2022.129975 ↗
36. Advances in experimental studies for deep rock dynamics
37. Effects of high temperature and cooling rate on dynamic tensile mechanical properties of granite
38. Energy dissipation characteristics of high-temperature granites after water-cooling under different impact loadings10.1007/s11771-023-5284-x ↗
39. Study on the mode I fracture properties of granites after heating and water-cooling treatments under different impact loadings10.1007/s00603-022-02865-0 ↗
40. Spalling characteristics of high-temperature treated granitic rock at different strain rates10.1016/j.jrmge.2023.05.016 ↗
41. Effect of heat treatment on dynamic tensile strength and damage behavior of medium-fine-grained huashan granite10.1007/s40799-017-0180-7 ↗
42. Effects of thermal treatment on tensile strength of laurentian granite using Brazilian test10.1007/s00603-015-0712-3 ↗
43. Modeling of non-linear rheological behavior of hard rock using triaxial rheological experiment10.1016/j.ijrmms.2017.01.004 ↗
44. Fractal analysis for dynamic failure characteristics of granite induced by mechanical–thermal loading10.1680/jgele.15.00035 ↗
45. Morphological evolution and flow conduction characteristics of fracture channels in fractured sandstone under cyclic loading and unloading10.1016/j.ijmst.2023.11.003 ↗
46. An experimental investigation on fatigue characteristics of granite under repeated dynamic tensions10.1016/j.ijrmms.2022.105185 ↗
47. Mechanical properties and fracture behavior of flawed granite under dynamic loading10.1016/j.soildyn.2020.106569 ↗
48. Dynamic rock tensile strengths of Laurentian granite: experimental observation and micromechanical model10.1016/j.jrmge.2016.08.007 ↗
49. Dynamic properties and failure mechanism of granite with non-persistent joints subjected to impact load10.1016/j.ijrmms.2023.105451 ↗
50. Dynamic mechanical properties and cracking behaviours of persistent fractured granite under impact loading with various loading rates10.1016/j.tafmec.2022.103281 ↗
51. Dynamic failure analysis on granite under uniaxial impact compressive load
52. Shear-related roughness classification and strength model of natural rock joint based on fuzzy comprehensive evaluation10.1016/j.ijrmms.2020.104550 ↗
53. Investigation on water inrush fracture mechanics model based on fracture mechanics and microseismic monitoring10.1016/j.asej.2023.102587 ↗
54. Dynamic damage characteristics and structural model of concentric perforated granite subjected to thermal-hydro-mechanical coupling
55. Meyers · 1994
56. Sensitivity analysis determination and optimization of Rock RHT parameters
57. The RHT concrete model in LS-DYNA
58. Hoek · 1980