journal article·2017-02-14Open access

Grain-refining ability of ultra-rapid annealing for low-carbon steel: severe plastic deformation

Mohammad Ali Mostafaei, Mohsen Kazeminezhad

Materiali in tehnologije· Volume 51· Issue 1

Abstract

To study the grain-refinement ability of ultra-rapid annealing (URA), heating rates from 0.3 C/s up to 1200 C/s with conventional annealing and URA in the intercritical temperature range were performed on severely deformed low-carbon steel. The results show that recrystallization in conventional annealing is completed below the critical temperature of Ac1 without grain refinement. URA up to 730 C at a heating rate of 200 C/s causes grain refinement due to full interaction between the recrystallization and phase transformation. URAs up to 730 C with heating rates of 600 C/s and 1000 C/s lead to partial grain refinement and no grain refinement, respectively. During annealing with a heating rate of 1200 C/s, the temperature should reach 760 C for the occurrence of recrystallization leading to grain refinement. The sample URAed at 600 C/s up to 730 C shows the maximum hardness due to fine grains being partially formed. Keywords:
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Microstructure and Mechanical Properties of Steels · Metal Alloys Wear and Properties · Metallurgy and Material Forming

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References

Reference metadata was not supplied for this record.