journal article·2019-12-21Open access

The Properties of Composites with Recycled Cement Mortar Used as a Supplementary Cementitious Material

Katarzyna Kalinowska-Wichrowska, Marta Kosior-Kazberuk, Edyta Pawluczuk

Materials· Volume 13· Issue 1

Abstract

The process of recycling concrete rubble is accompanied by the formation of a large amount of fine fraction, which cannot be reused as aggregate. The results of research on the possibility of using recycled cement mortar (RCM), obtained during concrete recycling, as a cementitious supplementary material, are presented. The experimental research was carried out on the basis of two variables determining the recycling process: X1—temperature (range of variation 288–712 °C) and X2—time (range of variation 30–90 min) of thermal treatment of concrete rubble. The experiment included 10 series of new composites made with RCMs subjected to different variants of thermal treatment, and two additional control series. The best treatment parameters were determined based on the assessment of selected physical and mechanical properties of the new cement composites, as well as the analysis of characteristics and microstructure of RCM. The test results showed that proper thermal treatment of concrete rubble makes it possible to obtain a high-quality fine fraction, which has the properties of an active addition and can be used as a partial replacement for cement in mortars and concretes.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Recycled Aggregate Concrete Performance · Concrete and Cement Materials Research · Innovative concrete reinforcement materials

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Faculty of Civil and Environmental Engineering, Bialystok University of Technology, 15-351 Bialystok, Poland

References (39)

Show source-provided references
1. Emerging Energy-Efficiency and CO2 Emission-Reduction Technologies for Cement and Concrete Production: A Technical Review10.1016/j.rser.2012.07.019 ↗
2. de Brito, J., and Agrela, F. (2019). Life Cycle Assessment Applied to Recycled Aggregate Concrete. New Trends in Eco-Efficient and Recycled Concrete, Woodhead Publishing. [1st ed.].
3. A Proposal for the Maximum Use of Recycled Concrete Sand in Masonry Mortar Design
4. A Review of Recycled Aggregate in Concrete Applications (2000–2017)10.1016/j.conbuildmat.2018.03.240 ↗
5. de Brito, J., and Agrela, F. (2019). Microstructural Studies on Recycled Aggregate Concrete. New Trends in Eco-Efficient and Recycled Concrete, Woodhead Publishing. [1st ed.].10.1016/B978-0-08-102480-5.00011-7 ↗
6. Physical, Chemical and Mineralogical Properties of Fine Recycled Aggregates Made from Concrete Waste10.1016/j.conbuildmat.2015.03.112 ↗
7. A Two-Step Multiscale Model to Predict Early Age Strength Development of Cementitious Composites Considering Competing Fracture Mechanisms10.1016/j.conbuildmat.2019.02.134 ↗
8. Pawluczuk, E., Kalinowska-Wichrowska, K., Bołtryk, M., Jiménez, J.R., and Fernández, J.M. (2019). The Influence of Heat and Mechanical Treatment of Concrete Rubble on the Properties of Recycled Aggregate Concrete. Materials, 12.10.3390/ma12030367 ↗
9. Engineering Properties of Treated Recycled Concrete Aggregate for Structural Applications10.1016/j.conbuildmat.2013.03.014 ↗
10. Quality Improvement Techniques for Recycled Concrete Aggregate: A Review10.3151/jact.17.151 ↗
11. Development of a Sustainable Concrete Waste Recycling System-Application of Recycled Aggregate Concrete Produced by Aggregate Replacing Method10.3151/jact.5.27 ↗
12. Removal of Cement Mortar Remains from Recycled Aggregate Using Pre-Soaking Approaches10.1016/j.resconrec.2006.05.012 ↗
13. Alkali-Activated Building Materials Made with Recycled Construction and Demolition Wastes10.1016/j.conbuildmat.2017.05.122 ↗
14. Utilization of Waste Concrete Powder as a Substitution Material for Cement10.1016/j.conbuildmat.2011.11.042 ↗
15. Fines Extracted from Recycled Concrete as Alternative Raw Material for Portland Cement Clinker Production10.1016/j.cemconcomp.2015.01.003 ↗
16. Influence of Fine Recycled Concrete Aggregates on the Properties of Mortars10.1016/j.conbuildmat.2015.02.037 ↗
17. An Investigation on the Recycling of Hydrated Cement from Concrete Demolition Waste10.1016/j.cemconcomp.2015.04.010 ↗
18. Cement Substitution by a Recycled Cement Paste Fine: Role of the Residual Anhydrous Clinker10.1016/j.conbuildmat.2016.11.080 ↗
19. Rehydration Reactivity of Recycled Mortar from Concrete Waste Experienced to Thermal Treatment10.1016/j.conbuildmat.2007.05.012 ↗
20. Rehydration Activity of Hydrated Cement Paste Exposed to High Temperature10.1002/fam.1067 ↗
21. Production of Geopolymeric Binder from Blended Waste Concrete Powder and Fly Ash10.1016/j.conbuildmat.2012.04.044 ↗
22. Chai, L., Monismith, C.L., and Harvey, J. (2009). Re-Cementation of Crushed Material in Pavement Bases, Pavement Research Center, University of California. UCPRC-TM-2009-04.
23. Paige-Green, P. (2010, January 16–19). A Preliminary Evaluation of the Reuse of Cementitious Materials. Proceedings of the 29th Annual Southern African Transport Conference, Pretoria, South Africa.
24. Evaluation of Recementation Reactivity of Recycled Concrete Aggregate Fines10.3141/2401-05 ↗
25. Diseño y prestaciones de morteros de albañilería elaborados con áridos reciclados procedentes de escombro de hormigón10.3989/mc.2009.44207 ↗
26. Incorporation of Fine Concrete Aggregates in Mortars10.1016/j.conbuildmat.2012.06.031 ↗
27. Bołtryk, M., Kalinowska-Wichrowska, K., and Pawluczuk, E. (2018, December 01). Method for Separation of Set Cement Mortar from Coarse Aggregate and for Crushing that Mortar, and the Device for the Application of This Method, PAT.229887. Available online: http://regserv.uprp.pl/register/application?number=P.417362.
28. (2011). EN 197-1:2011 Cement. Composition, Specifications and Conformity Criteria for Common Cements, European Committee for Standardization.
29. (2012). EN 933-1:2012 Test for Geometrical Properties of Aggregates. Determination of Particle Size Distribution. Sieving Method, European Committee for Standardization.
30. (2012). EN 206:2013+A1:2016 Concrete. Specification, Performance Production and Conformity, European Committee for Standardization.
31. (2016). EN 196-1:2016 Methods of Testing Cement. Determination of Strength, European Committee for Standardization.
32. (1999). EN 1015-3:1999 Methods of Test for Mortar for Masonry. Determination of Consistence of Fresh Mortar (by Flow Table), European Committee for Standardization.
33. (2012). EN 450-1:2012 Fly Ash for Concrete. Definition, Specifications and Conformity Criteria, European Committee for Standardization.
34. (2010). EN 196-9:2010 Methods of Testing Cement. Heat of Hydration. SEMI-Adiabatic Method, European Committee for Standardization.
35. Ramachandran, V.S., Paroli, R.M., Beaudoin, J.J., and Delgado, A.H. (2003). Handbook of Thermal Analysis of Construction Materials, Noyes Publications/William Andrew Publishing.10.1016/B978-081551487-9.50017-7 ↗
36. Physicochemical, Mineralogical, and Morphological Characteristics of Concrete Exposed to Elevated Temperatures10.1016/S0008-8846(01)00736-0 ↗
37. (2002). EN ISO 3252:2002 Powder Metallurgy. Vocabulary, European Committee for Standardization.
38. Brandt, S. (1999). Data Analysis. Statistical and Computational Methods for Scientists and Engineers, Springer. [3rd ed.].10.1007/978-1-4612-1446-5 ↗
39. Kurdowski, W. (2014). Cement and Concrete Chemistry, Springer.10.1007/978-94-007-7945-7 ↗