journal article·2025-01-03Open access

The Effect of the MgO/Al2O3 Ratio on the Thermal and Refractory Behaviors of Cordierite Ceramics

Jae-Seung Lee, Jin-Woo Kim, Joo-Seok Park, Min-Ho Lee, Heesoo Lee

Materials· Volume 18· Issue 1

Abstract

In this study, cordierite-based ceramics (2MgO·2Al2O3·5SiO2) were synthesized using high-purity MgO, Al2O3, and SiO2 as starting materials. The influence of the MgO/Al2O3 ratio on various properties, including the thermal behavior, pyrometric cone refractory behavior, phase formation, physical properties, and microstructure of the synthesized ceramics, was systematically analyzed. Increasing the MgO/Al2O3 ratio progressively weakened the cordierite network, leading to lower temperatures for liquid formation and melting. This resulted in reduced viscosity and increased fluidity. Subsequently, the thermal and refractory behaviors were observed at lower temperatures with higher deformation rates under higher MgO/Al2O3 ratios. The lower viscosity of the liquid formed at reduced temperatures contributed to an increase in the density of sintered bodies, reduced porosity, and enhanced shrinkage. X-ray diffraction analysis confirmed that cordierite was the predominant phase in samples sintered at 1300, 1350, and 1400 °C, with higher cordierite formation at higher temperatures. Conversely, the formation of secondary phases, such as spinel, cristobalite, and enstatite, decreased with increasing sintering temperature. Pyrometric cones were then constructed for a range of temperature settings, and their deformation characteristics at specific temperatures were used to evaluate the refractoriness under diverse conditions.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Advanced ceramic materials synthesis · Microwave Dielectric Ceramics Synthesis · Ferroelectric and Piezoelectric Materials

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Business Cooperation Center, Industry Support Division, Korea Institute of Ceramic Engineering & Technology, Jinju-si 52851, Republic of Korea

School of Materials Science & Engineering, Pusan National University, Busan 46241, Republic of Korea

Funding

Korea Planning and Evaluation Institute of Industrial Technology (KEIT) Program

References (44)

Show source-provided references
1. Phase formation and crystallization kinetics in cordierite ceramics prepared from kaolinite and magnesia10.1016/j.ceramint.2017.11.119 ↗
2. Cordierite-based ceramics with coffee husk ash addition: I–microstructure and physical properties10.1016/j.jmrt.2021.09.032 ↗
3. Wetting and penetration of cordierite and mullite materials by non-stoichiometric cordierite liquids10.1016/j.ceramint.2007.06.013 ↗
4. Processing of microcellular cordierite ceramics from a preceramic polymer10.1016/j.scriptamat.2005.12.039 ↗
5. Idbenjadi, F.E., Benhammou, A., Abourriche, A., and Abouliatim, Y. (2024). Effect of sintering temperature on the thermal and mechanical properties of cordierite-based refractory. Mater. Today Proc., in press.10.1016/j.matpr.2024.02.035 ↗
6. Sintering, physicomechanical, thermal expansion and microstructure properties of cordierite ceramics based on utilizing silica fume waste10.1016/j.matchemphys.2021.124829 ↗
7. Low temperature synthesis of highly pure cordierite materials by spark plasma sintering nano-oxide powders10.1016/j.ceramint.2020.06.167 ↗
8. Pressureless sintering of cordierite ceramics with optimized strength and thermal expansion10.1088/1757-899X/770/1/012069 ↗
9. Sintering behavior of alumina rich cordierite porous ceramics10.1016/S0254-0584(00)00432-6 ↗
10. Durability of cordierite honeycomb structure for automotive emissions control10.1016/0040-6031(93)80245-6 ↗
11. Synthesis and characterization of cordierite ceramic from Moroccan stevensite and andalusite10.1016/j.clay.2010.06.004 ↗
12. Preparation of refractory cordierite using amorphous rice husk silica for thermal insulation purposes10.1016/j.ceramint.2016.02.062 ↗
13. Processing of porous cordierite ceramics with controlled porosity10.2109/jcersj.115.52 ↗
14. Densification and crystallization of nonstoichiometric cordierite glass with excess MgO synthesized from kaolin and talc10.1111/j.1551-2916.2010.04144.x ↗
15. Effect of excess MgO mole ratio in a stoichiometric cordierite (2MgO2Al2O3·5SiO2) composition on the phase transformation and crystallization behavior of magnesium aluminum silicate phases10.1111/j.1744-7402.2010.02486.x ↗
16. Microstructure, thermal expansion, hardness and thermodynamic parameters of cordierite materials synthesized from Algerian natural clay minerals and magnesia10.1016/j.bsecv.2020.03.008 ↗
17. Crystallization and densification of nano-size amorphous cordierite powder prepared by a PVA solution-polymerization route10.1111/j.1151-2916.1998.tb02667.x ↗
18. Crystallization behavior and properties of cordierite synthesized by sol-gel technique and hydrothermal treatment
19. Synthesis and analysis of optical properties of cordierite nanopowder prepared by the Pechini method10.1016/j.mspro.2015.11.107 ↗
20. Synthesis and characterization of nanosized pure α-cordierite glass-ceramic powders10.1007/s41779-017-0147-2 ↗
21. Effect of MgO/SiO2 ratio and Al2O3 content on crystallization behavior and properties of cordierite-based glass–ceramics
22. Crystallization behaviour in the system MgO∙Al2O3∙SiO210.1016/0022-3093(95)00451-3 ↗
23. Kaya, Y., Kobya, V., Mardani, A., Mardani, N., and Beytekin, H.E. (2024). Effect of Grinding Conditions on Clinker Grinding Efficiency: Ball Size, Mill Rotation Speed, and Feed Rate. Buildings, 14.10.3390/buildings14082356 ↗
24. Khater, G.A., Romero, M., López-Delgado, A., Padilla, I., El-Kheshen, A.A., Farag, M.M., Elmaghraby, M.S., Shendy, H., and Nasralla, N.H.S. (2024). Utilizing Ceramic Factory Waste to Produce Low-Cost Refractory Ceramics. Recycling, 9.10.3390/recycling9050098 ↗
25. Yu, Y., Wang, J., Yu, Y., Yan, Z., Du, Y., Chu, P., Jing, Q., and Liu, P. (2022). Synthesis and Characterization of Single-Phase α-Cordierite Glass-Ceramics for LTCC Substrates from Tuff. Materials, 15.10.3390/ma15248758 ↗
26. Yoo, D., Kim, M., Oh, S.K., Hwang, S., Kim, S., Kim, W., Kwon, Y., Jo, Y., and Jeon, J.-K. (2024). Synthesis of Hydroxylammonium Nitrate and Its Decomposition over Metal Oxide/Honeycomb Catalysts. Catalysts, 14.10.3390/catal14020116 ↗
27. (1988). Pyrometric Reference Cones for Laboratory Use—Specification (Standard No. KS L ISO 1146).
28. (2020). Fine Ceramics (Advanced Ceramics, Advanced Technical Ceramics)—Determination of Density and Apparent Porosity (Standard No. KS L ISO 18754).
29. (2016). Testing Method for Refractoriness of Refractory Materials and Products (Standard No. KS L ISO 3113).
30. Influence of silica phase transformation on synthesis of cordierite ceramic10.1007/s41779-017-0060-8 ↗
31. Solid state synthesis and its characterization of high density cordierite ceramics using fine oxide powders10.2109/jcersj2.118.246 ↗
32. Mechanism of cordierite formation obtained by high temperature sintering technique10.1016/j.ceramint.2023.03.184 ↗
33. Application of hot-stage microscopy to evaluating sample morphology changes on heating10.1007/s10973-015-5023-0 ↗
34. Calculation of viscosity–temperature curves for glass obtained from four wastewater treatment plants in Egypt10.1007/s10973-012-2232-7 ↗
35. Melting behaviour of feldspar porcelain glazes
36. Viscosity and thermal evolution of density and wetting angle of a commercial glaze by means of hot stage microscopy10.1016/j.mspro.2015.05.031 ↗
37. Chapter 2.2.—The Structure and Properties of Silicate Slags10.1016/B978-0-08-096986-2.00008-4 ↗
38. Comparative roles of Al3+ and Fe3+ ions for network construction in sodium silicate melts10.2355/isijinternational.41.410 ↗
39. Revealing the structural role of MgO in aluminosilicate glasses10.1016/j.actamat.2021.117417 ↗
40. Effect of network formers and modifiers on the crystallization resistance of oxide glasses10.1016/j.jnoncrysol.2020.120359 ↗
41. Fabrication of dense cordierite ceramic through reducing Al2O3 mole ratio10.1016/j.matlet.2013.11.011 ↗
42. Preparation and characterization of cordierite ceramic from coal series kaolin for electronic application10.1007/s41779-019-00306-w ↗
43. Effects of temperature non-uniformity and effective viscosity on pyrometric cone deformation10.1002/ces2.10026 ↗
44. Carter, C.B., and Norton, M.G. (2013). Ceramic Materials: Science and Engineering, Springer. [2nd ed.]. 9.12 MEASURING, TEMPERATURE.