journal article·2021-08-25Open access

Deformation and Phase Transformation of Disordered α Phase in the (α + γ) Two-Phase Region of a High-Nb TiAl Alloy

Haitao Zhou, Fantao Kong, Yanbo Wang, Xiangwu Hou, Ning Cui, Jingli Sun

Materials· Volume 14· Issue 17

Abstract

In this paper, the deformation and phase transformation of disordered α phase in the (α + γ) two-phase region in as-forged Ti-44Al-8Nb-(W, B, Y) alloy were investigated by hot-compression and hot-packed rolling. The detailed microstructural evolution demonstrated that the deformed microstructure was significantly affected by the deformation conditions, and the microstructure differences were mainly due to the use of a lower temperature and strain rate. Finer α grains were formed by the continuous dynamic recrystallization of α lamellae and α grains distributed around lamellar colonies. Moreover, the grooved γ grains formed by the phase transformation from α lamellae during hot rolling cooperated with and decomposed α lamellae. A microstructure evolution model was built for the TiAl alloy at 1250 °C during hot rolling.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Intermetallics and Advanced Alloy Properties · MXene and MAX Phase Materials · Titanium Alloys Microstructure and Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Research & Development Center, Shanghai Spaceflight Precision Machinery Institute, Shanghai 201600, China

School of Materials Science and Engineering, Harbin Institute of Technology, Harbin 150001, China

School of Mechanical and Automotive Engineering, Qingdao University of Technology, Qingdao 266520, China

Funding

Shanghai Sailing Program · Shanghai Rising-Star Program

References (24)

Show source-provided references
1. Liu, B.L., Wang, M.S., Du, Y.L., and Li, J.X. (2020). Size-Dependent Structural Properties of a High-Nb TiAl Alloy Powder. Materials, 13.10.3390/ma13010161 ↗
2. A β-solidifying TiAl alloy reinforced with ultra-fine Y-rich precipitates10.1016/j.scriptamat.2020.10.010 ↗
3. Polysynthetic twinned TiAl single crystals for high-temperature applications10.1038/nmat4677 ↗
4. Modeling concepts for intermetallic titanium aluminides10.1016/j.pmatsci.2016.01.001 ↗
5. Appel, F., Paul, J.D.H., and Oehring, M. (2011). Gamma Titanium Aluminide Alloys-Science and Technology, Wiley VCH.10.1002/9783527636204 ↗
6. Sheet gamma TiAl: Status and opportunities10.1007/s11837-004-0251-y ↗
7. Hot rolling of gamma titanium aluminide foil10.1016/j.actamat.2010.04.042 ↗
8. Fabrication and Properties of gamma-TiAl Sheet Materials: A Review10.1007/s11837-017-2551-z ↗
9. High strength in high Nb containing TiAl alloy sheet with fine duplex microstructure produced by hot pack rolling10.1016/j.jallcom.2016.12.005 ↗
10. Effect of hot rolling and primary annealing on the microstructure and texture of a β-stabilised γ-TiAl based alloy10.1016/j.actamat.2016.12.056 ↗
11. Dynamic recrystallization of a β(B2)-Stabilized γ-TiAl based Ti-45Al-8Nb-2Cr-0.2B alloy: The contributions of constituent phases and Zener-Hollomon parameter modulated recrystallization mechanisms10.1016/j.jallcom.2020.154386 ↗
12. Hot pack rolling nearly lamellar Ti-44Al-8Nb-(W, B, Y) alloy with different rolling reductions: Lamellar colonies evolution and tensile properties10.1016/j.matdes.2017.02.053 ↗
13. A novel hot pack rolling of high Nb-TiAl sheet from cast ingot10.1016/j.intermet.2015.07.009 ↗
14. Effect of pack rolling on microstructures and tensile properties of as-forged Ti-44Al-6V-3Nb-0.3Y alloy10.1016/j.intermet.2011.10.003 ↗
15. Investigations on processing powder metallurgical high-Nb TiAl alloy sheets10.1016/j.intermet.2014.07.013 ↗
16. High temperature deformability and microstructural evolution of Ti-47Al-2Cr-0.2Mo alloy10.1016/j.jallcom.2010.06.124 ↗
17. Hot deformation behavior and microstructural evolution of as-forged Ti-44Al-8Nb-(W, B, Y) alloy with nearly lamellar microstructure10.1016/j.intermet.2017.02.026 ↗
18. Microstructural evolution, hot workability, and mechanical properties of Ti-43Al-2Cr-2Mn-0.2Y alloy10.1016/j.matdes.2015.10.076 ↗
19. Deformation behavior of high Nb containing TiAl based alloy in α + γ two phase field region10.1016/j.matdes.2015.10.080 ↗
20. The Al-B-Nb-Ti system III. Thermodynamic re-evaluation of the constituent binary system Al-Ti10.1016/j.jallcom.2007.10.061 ↗
21. Microsegregation in high Nb containing TiAl alloy ingots beyond laboratory scale10.1016/j.intermet.2006.10.003 ↗
22. In-situ control of microstructure and mechanical properties during hot rolling of high-Nb TiAl alloy10.1016/j.mtla.2018.05.007 ↗
23. Recovery, recrystallization and phase transformations during thermomechanical processing and treatment of TiAl-based alloys10.1016/S1359-6454(00)00093-8 ↗
24. Spheroidization of the lamellar microstructure in Ti-6Al-4V alloy during warm deformation and annealing10.1016/j.actamat.2011.03.037 ↗