Gun Liner Bond Strength Studies
Source abstract
Abstract
Experiments have been conducted to see if internal grooves machined in steel cylinders will lead to higher bond strengths produced by the Gun Liner Emplacement with an Elastomeric Material (GLEEM) process. Groove depth and twist angle were varied. Both experimental and analytical studies showed that at the pressures used, there was little movement of the liner material into the machined grooves. However, the liner was seen to conform to very small machining marks in the steel cylinder inner bore, providing an increase in the coefficient of friction. Bond strengths of over 30 MPa were obtained.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Electromagnetic Launch and Propulsion Technology · Metal and Thin Film Mechanics · High-Velocity Impact and Material Behavior
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (6)
Show source-provided references
1. Carter , R.H. ; de Rosset , W.S. ; Gray , D.M. GLEEM—A new composite gun tube processing technology. InProceedings of the 26th Annual Army Science Conference, Orlando, Florida, December 2008.
2. de Rosset , W.S. Gun Liner Emplacement with an Elastomeric Material. ARL Contractor Report ARL CR-645, April 2010.10.21236/ADA610343 ↗
3. Carter , R.H. ; de Rosset , W.S. Compressed Elastomer Method for Autofrettage and Lining Tubes. U.S. Army Research Laboratory Patent Application 12/176,608, July 2008.
4. de Rosset , W.S. ; Snoha , D.J. ; Minnicino , M.A. Strength of an Explosively-Formed Bond. ARL Technical Report ARL TR-3889, September 2006.10.21236/ADA455905 ↗
5. Miller , M.D. ; Audino , M.J. ; Smith , S.B. ; Welty , A.M. ; Snoha , D.J. ; Gray , D.M. ; de Rosset , W.S. Laboratory Investigations of Explosively-Bonded Gun Tube Liners. ARDEC Technical Report RDAR-WSB-TR-09016. September 2009.
6. Gray , D. GLEEM Testing Fixture. ARL Technical Note ARL TN-360, July 2009.10.21236/ADA506447 ↗