journal article·2002-01-12

REVITALIZING A SELECTIVELY HEAT TREATABLE STEEL PLATE WITH ULTRA HARD AND TOUGH LAYERS

Yung Neng Cheng, Shyong Lee, Chin Shuang Lee

Publisher page

Abstract

A three-layered laminated metal composite possessing ultra hard and tough layers suffered cracking problems, such that its further development was halted. The cause of fracture was analyzed and determined to be the result of concentrating residual stresses along edges, especially at the corners of the plate. Using data on geometrical dimensions, material properties, and external boundary conditions, finite element analysis was employed to calculate the stress distribution. For reducing stress concentration on the edges, three possibilities were analyzed by finite element method. Results show that when the sharp corners of the rectangular composite plate are slightly rounded, the original concentrated tensile stress can be reduced by ∼20%, but this technique cannot achieve more than 35%. Another way that is more efficient is to chamfer edges, and the angle of chamfering did matter. Chamfering plus corner round-up did not yield further benefit.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Microstructure and Mechanical Properties of Steels · Metal Forming Simulation Techniques · High Temperature Alloys and Creep

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (5)

Show source-provided references
1. Dastur Y.N. · Metall. Trans. A · 1981 · 12 · 74910.1007/BF02648339 ↗
2. Lee S. · Res. Mech. · 1990 · 31 · 232
3. Lee, S. 1988. “Tensile and Impact Behavior of Laminated Composites Based on Ultra High Carbon Steel”. Stanford, CA: Stanford University.
4. Lee S. · Compos. Sci. Technol. · 1992 · 44 · 7110.1016/0266-3538(92)90026-Y ↗
5. Lee S. · Int. J. Fracture · 1994 · 65 · 17310.1007/BF00032286 ↗