journal article·2025-11Open access

Pseudo-binary diffusion couple approach as a tool for evaluation of microstructural changes as a function of composition (x) in AlCoCrxFeNi, AlxCoCrFeNi and AlCoCrFeNix multicomponent alloys

Yuval Hodaya Malinker, Guy Hillel, Jonathan Priel, Susanna Syniakina, Louisa Meshi

Abstract

This study employs a pseudo-binary diffusion couple approach to systematically investigate the microstructural evolution in AlCoCr x FeNi, Al x CoCrFeNi and AlCoCrFeNi x multicomponent alloys. In the Al x CoCrFeNi system, the study identified a single-phase face-centered cubic (FCC) structure at low Al concentrations, a dual-phase B2 (ordered body-centered cubic (BCC)) and BCC at intermediate Al levels, and a B2 matrix with fine BCC particles at higher Al concentrations. The solubility limit of Al in the FCC phase was determined to be approximately 8 at.% Al. Contrary to previous assertions that Al stabilizes the BCC phase, this study concludes that Al acts as a B2 stabilizer. For the AlCoCr x FeNi system, the study concluded a single-phase B2 structure at low Cr concentrations, fine BCC particles within the B2 matrix at intermediate Cr levels, and a phase inversion at higher Cr concentrations where the BCC phase became the matrix with B2 particles embedded within it. The threshold Cr content for this phase inversion was identified as approximately 33 at.% Cr. It was concluded that Cr acts as a stabilizer for the BCC phase, while the B2 phase exhibited limited Cr solubility. AlCoCrFeNi x system demonstrated unique behavior. A high diffusion coefficient of Ni was observed in the AlCoCrFe B2/BCC basket-weave microstructure. This area could accommodate up to 25 at.% Ni without significant microstructural changes. At higher Ni contents, the microstructure transformed dramatically into a combination of L1₂ (ordered FCC) and B2 phases. As Ni content increased, the structure evolved to a eutectic microstructure, accompanied by a significant reduction in the rate of Ni diffusion. The similarity of these results to those reported for conventionally processed and heat-treated alloys suggests that the pseudo-binary diffusion couple method is an effective tool for evaluating microstructural changes in multicomponent alloys. Notably, the eutectic microstructure observed in the AlCoCrFeNi₂.₁ diffusion couple aligns with findings in cast alloys. Given the current research focus on eutectic high-entropy alloys (HEAs), this method offers a rapid and efficient means of identifying compositions exhibiting such microstructures. Overall, this research enhances the understanding of multicomponent alloy systems and provides a foundation for future studies aimed at optimizing alloy composition and processing to achieve desired microstructures and mechanical properties. • Al/CoCrFeNi, Cr/AlCoFeNi, Ni/AlCoCrFe diffusion couples were studied. • Changes of the microstructure as function of Cr, Al, Ni content were reported. • Solubility limits of Cr and Al in B2 and FCC, respectively, were determined. • Conclusions were in line with those reported for cast and heat treated alloys. • Pseudo-binary diffusion couple method is an effective tool for studying HEAs.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: High Temperature Alloys and Creep · Metallurgical and Alloy Processes · Intermetallics and Advanced Alloy Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (50)

Show source-provided references
1. Nanostructured high-entropy alloys with multiple principal elements: novel alloy design concepts and outcomes10.1002/adem.200300567 ↗
2. High-entropy alloy: challenges and prospects10.1016/j.mattod.2015.11.026 ↗
3. Multicomponent high-entropy Cantor alloys10.1016/j.pmatsci.2020.100754 ↗
4. Understanding the role of the constituting elements of the AlCoCrFeNi high entropy alloy through the investigation of quaternary alloys10.3390/met10101275 ↗
5. Systematic study of the effect of Cr on the microstructure, phase content and hardness of the AlCrxFeCoNi alloys10.1016/j.jallcom.2023.168897 ↗
6. Ion irradiation effect on B2 single phase AlFeCoNi alloy10.1016/j.matchar.2022.112299 ↗
7. Microstructural evolution, phase formation and mechanical properties of multi-component AlCoCrFeNi x alloys10.1007/s00339-019-2959-0 ↗
8. Comprehensive study of phase transitions in equiatomic AlCoCrFeNi high-entropy alloy10.1016/j.jallcom.2020.158220 ↗
9. Retardation of the σ phase formation in the AlCoCrFeNi multi-component alloy10.1016/j.matchar.2018.12.010 ↗
10. Evolution of phases, hardness and magnetic properties of AlCoCrFeNi high entropy alloy processed by mechanical alloying10.1016/j.jallcom.2020.154826 ↗
11. Review of recent research on AlCoCrFeNi high-entropy alloy10.3390/met11081302 ↗
12. Microstructures and properties of high-entropy alloys10.1016/j.pmatsci.2013.10.001 ↗
13. Microstructure, wear and oxidation behavior of AlCrFeNiX (X= Cu, Si, Co) high entropy alloys produced by powder metallurgy10.1016/j.vacuum.2021.110143 ↗
14. Study on the mechanical properties and corrosion resistance of AlxCoFeNiCr1− x high-entropy alloys10.1088/2053-1591/ab3d86 ↗
15. Microstructure and compressive properties of AlCrFeCoNi high entropy alloy10.1016/j.msea.2008.01.064 ↗
16. Phase separation in equiatomic AlCoCrFeNi high-entropy alloy10.1016/j.ultramic.2012.12.015 ↗
17. Phase selection of BCC/B2 phases for the improvement of tensile behaviors in FeNiCrAl medium entropy alloy10.1016/j.jallcom.2022.165382 ↗
18. Heat treatment impacts the micro-structure and mechanical properties of AlCoCrFeNi high entropy alloy10.1016/j.jallcom.2016.05.034 ↗
19. Additive manufacturing of a functionally graded high entropy alloy using a hybrid powder-bed wire-based direct energy deposition approach
20. Phases, microstructure and mechanical properties of AlxCoCrFeNi high-entropy alloys at elevated temperatures10.1016/j.jallcom.2013.11.084 ↗
21. Effects of Al addition on the microstructure and mechanical property of AlxCoCrFeNi high-entropy alloys10.1016/j.intermet.2012.03.005 ↗
22. Microstructure evolution and compressive property variation of AlxCoCrFeNi high entropy alloys produced by directional solidification10.1016/j.intermet.2022.107749 ↗
23. Effect of Al content on microstructure and mechanical properties of the fcc and bcc phases of AlxCoCrFeNi high entropy alloys
24. Effects of AL addition on microstructure and mechanical properties of AlxCoCrFeNi high-entropy alloy10.1016/j.msea.2015.09.034 ↗
25. The BCC/B2 morphologies in Al x NiCoFeCr high-entropy alloys10.3390/met7020057 ↗
26. Investigation of the phase stabilities in AlNiCoCrFe high entropy alloys10.1016/j.jallcom.2016.08.121 ↗
27. Microstructure and mechanical property of as-cast,-homogenized, and-deformed AlxCoCrFeNi (0≤ x≤ 2) high-entropy alloys10.1016/j.jallcom.2009.08.090 ↗
28. Microstructure, thermophysical and electrical properties in AlxCoCrFeNi (0≤ x≤ 2) high-entropy alloys10.1016/j.mseb.2009.05.024 ↗
29. Thermal–mechanical processing and strengthen in Al x CoCrFeNi high-entropy alloys10.3389/fmats.2020.585602 ↗
30. Cooling rate effect on microstructure and mechanical properties of AlxCoCrFeNi high entropy alloys10.1016/j.matdes.2017.07.008 ↗
31. Comparative study of the microstructures and mechanical properties of direct laser fabricated and arc-melted AlxCoCrFeNi high entropy alloys10.1016/j.msea.2015.02.072 ↗
32. Phase transformations of Al-bearing high-entropy alloys AlxCoCrFeNi (x= 0, 0.1, 0.3, 0.75, 1.5) at high pressure10.1063/1.5079868 ↗
33. AlxCoCrFeNi high entropy alloys from metal scrap: microstructure and mechanical properties10.1016/j.jallcom.2023.173002 ↗
34. Compositionally graded AlxCoCrFeNi high-entropy alloy manufactured by laser powder bed fusion10.1016/j.mtla.2021.101308 ↗
35. Influence of Al content on thermal stability of nanocrystalline AlxCoCrFeNi high entropy alloys at low and intermediate temperatures10.1016/j.apt.2020.02.032 ↗
36. Inhibiting cracking and improving strength for additive manufactured AlxCoCrFeNi high entropy alloy via changing crystal structure from BCC-to-FCC
37. Alloying behaviour, thermal stability and phase evolution in quinary AlCoCrFeNi high entropy alloy10.1016/j.apt.2018.06.006 ↗
38. Multi-phase nature of sintered vs. arc-melted CrxAlFeCoNi high entropy alloys-experimental and theoretical study10.1016/j.jallcom.2019.06.121 ↗
39. Understanding phase stability of Al-Co-Cr-Fe-Ni high entropy alloys10.1016/j.matdes.2016.07.073 ↗
40. Effects of Cr content on microstructure and mechanical properties of AlCoCrxFeNi high-entropy alloy
41. A promising new class of high-temperature alloys: eutectic high temperature alloys10.1038/srep06200 ↗
42. Microstructural evolution, phase formation and mechanical properties of multi-component AlCoCrFeNiₓ alloys10.1007/s00339-019-2959-0 ↗
43. Effects of chromium on the microstructures and mechanical properties of AlCoCr x FeNi 2.1 eutectic high entropy alloys10.1007/s40195-021-01303-4 ↗
44. A pseudobinary approach to study interdiffusion and the Kirkendall effect in multicomponent systems10.1080/14786435.2013.769692 ↗
45. Solving the issues of multicomponent diffusion in an equiatomic NiCoFeCr medium entropy alloy10.1016/j.actamat.2020.03.041 ↗
46. Pseudo-binary and pseudo-ternary diffusion couple methods for estimation of the diffusion coefficients in multicomponent systems and high entropy alloys10.1080/14786435.2019.1619027 ↗
47. Sadhu
48. Binder jetting of the AlCoCrFeNi alloy
49. NIH image to ImageJ: 25 years of image analysis10.1038/nmeth.2089 ↗
50. Towards controllable formation of antiphase boundaries (APBs) in the B2 matrices of the Al-Fe based complex multicomponent alloys10.1016/j.jallcom.2024.175295 ↗